AFX BWSW70050LBK User Manual

Outdoor Wall Fixture LED Wall Pack

1 of 1

Limited Factory Warranty
AFX Inc. warrants this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions for a period of 3 years
from date of purchase. This warranty covers all component parts and extends only to replacement of defective fixture or components; it does not cover failure due to
improper installation, misuse, mishandling or damage incurred in transit

Models: 326950 (BWSW0810) & 326952 (BWSW0611) 120VAC / 60Hz

Safety Precautions

Read all safety precautions and installation instructions carefully before
installing or servicing this fixture. Failure to comply with these
instructions could result in potentially fatal electric shock and/or
property damage.

It is recommended that a qualified electrician perform all wiring. This
fixture must be wired in accordance with all national and local
electrical codes.

Do not handle any energized fixture or attempt to energize any fixture
with wet hands or while standing on a wet or damp surface or in water.

ASSEMBLY INSTRUCTIONS

1. Preparing for installation

A. Disconnect electrical power at fuse or circuit breaker box before installing or servicing any part of this fixture
B. Carefully remove the fixture from the carton, and check that all parts are included as shown in figure below. Be careful not

to misplace any of the screws or parts which are needed for installing the fixture

2. Wiring (all wiring must take place inside junction box)
Caution: Make sure power is off at fuse or circuit breaker box. Check power wires for damage or scrapes. If power supply wires

are within three inches of the ballast power
supply, use wire suitable for at least 90C (194F)
Note: Most dwellings built before 1985 have
supply wire rated to 60C. Consult a qualified
electrician before installing.
A. Secure gem bar (1) on the junction box (not

supplied) with two screws (2) (supplied)

B. Using wire nuts (supplied), connect white

(neutral) supply wire to white fixture wire;
connect black (hot) supply wire to black
fixture wire. Pull on each wire lead to verify
all connections are secure. Make certain no
bare wires are exposed outside of the wire
nuts

C. Connect the green wire from the power

source to the green screw on the gem bar

D. Tuck all connections neatly into junction box

3. Mounting

A. Thread nut (6) on stem (3). Adjust the length

of the stem in the gem bar so that approx.
3/8” is exposed. Secure the necessary length
with nut (4)

B. Install backpan (5) over stem (3) and secure

with the thumbnut (6)

C. Apply a bead of silicone sealant (not supplied) around the perimeter of the wall plate following the manufacturer’s

instructions

4. Installing diffuser

A. Align hole(s) in the diffuser (7) with hole(s) on the backpan. Secure shade with screw(s) (8)

5. Restore power at fuse or circuit breaker box

This fixture is designed for use in a 110-120VAC, 60Hz fused circuit.
Do not use on a dimming circuit.

To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green) contact
between this fixture and the ground connection of your main power
supply panel.

This fixture is intended to be used for general outdoor lighting in damp
or wet locations.

8060372 R0