AFX BBF162400L30D1SA User Manual

BBF / CEF / FUF Series Surface Mounted LED Fixture

FUF Model Shown

Safety Precautions

Read all safety precautions and installation instructions carefully
before installing or servicing this fixture. Failure to comply with
these instructions could result in potentially fatal electric shock
and/or property damage.

It is recommended that all wiring be performed by a qualified
electrician. This fixture must be wired in accordance with all national
and local electrical codes.

Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp surface or
in water.

Assembly Instructions

1. Preparing for installation

A. Disconnect electrical power before installing or servicing any

part of this fixture

B. Remove fixture from carton; remove ceiling pan (2) and diffuser

assembly (3)

2. Wiring

All wiring must take place inside junction box. Caution:

Make sure power is off at fuse or circuit breaker box. Check power
wires for damage or scrapes. If power supply wires are within three
inches of LED driver, use wire suitable for at least 90C (194F). Note:
Most dwellings built before 1985 have supply wire rated to 60C.
Consult a qualified electrician before installing

Make sure that the power source conforms to the requirements of the
fixture (see labels on fixture housing).

To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green) or bare metal
contact (metal conduit) between this fixture and the ground
connection of your main power supply panel.

This fixture is intended to be used for general indoor lighting in dry
or damp locations only.

A. This unit will not operate properly unless connected to a

“grounded” electrical circuit. Electrical shock, over heating, low or
no light output, and shortened lamp life can result if proper
grounding is not done. Securely attach green (or green and yellow)
wire to ground supply wire

B. Using wire connectors (provided), connect white (common)

supply wire to white fixture lead. Connect black (hot) supply wire
to black fixture lead. Do not mix wires. Pull on each wire lead to
make sure connections are secure. Make certain no bare wires are
exposed outside of wire connectors. Note: fixtures with universal voltage power supplies are pre-wired with a disconnect. Refer
to the included guide for using the disconnect

3. Mounting

A. Attach ceiling pan to junction box (not provided) using keyholes (6) with two #8 –32 x 1” screws (provided)

4. Mounting diffuser

A. Attach safety tether (4) to ceiling pan by inserting the clip into the appropriate holes (5)
B. Orient the cam latches (1) in the open position as shown, and raise the diffuser assembly so it is in contact and centered with the

ceiling pan

C. Rotate each cam latch until the nub on the ceiling pan engages the indentation in the latch

5. Power to the fixture can now be restored

Limited Factory Warranty
AFX Inc. hereby warranty that this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions
for a period of 5 years from date of shipment from factory. This warranty covers all component parts and extends only to replacement of defective fixture
or components; it does not cover failure due to improper installation, misuse, mishandling or damage incurred in transit.

Page 1 of 1 8060804 R0