Afcon 514 User Manual

P.O. Box 3365 South El Monte, CA 91733 626.444.0541 Fax [phone] www. Afcon.org

514

CPVC - COPPER

STEEL•

OFFSET HANGER

- 3/4" thru 3"

SIZE SYSTEM PIPE:
MATERIAL
FINISH
LISTING/APPROVAL -

PATENT No. 6,648,278.
FUNCTION

Support horizontal piping: 3/4" - 2" Steel.

•

Size 3/4" - 2" p es listed /l and p

Stabilize vertical piping.

INSTALLATION

including NFPA 13, 13R, 13D and CPVC manufacturers instructions.
Install on horizontal or vertical mounting surface.
Snap over pipe then squeeze strap back allowing pipe to slide freely.
When #905 threads are exposed in wood, install #906 backing nut.

FASTENERS

WOOD - #905

STEEL -

CONCRETE each =

FEATURES

* 1 1/2 Offset
* 3/4 and 1 pipe size a e common center-line.
* Patented design for superior strength.
* Offset edge eliminates abrasion.

AFCON

* screw included - 5/16" hex head.

ORDERING

- Carbon Steel.

- Mil. Galvanized..

203 - EX 4231, EX 2551

­upport horizontal piping: 3/4" -3" CPVC or Copper.

-S

rovid vertical ateral restraint revents upward movement

of pipe that supplies a pendent sprinkler below ceiling.

Per these instructions

-

a

- UL Listed per NFPA 13
3/4" - 3"

18 GA. - 3/4" - 3" CPVC pipe - 1/4" or #14 Tek Screw.

min.

CPVC pipe - screw- no pre-drill.
3/4" - 2" screw- no pre-drill.
3/4" - 2" " 1/2" no pre-drill.

Copper pipe ­Steel pipe - 1/4 x1 lag screw -

Thru " " 2" .

5/8 gypsum board - 1/4 x lag screw

#905

3/4" - 2" Copper pipe - 1/4" or #14 Tek Screw.
3/4" - 2" Steel pipe - 1/4" or #14 Tek Screw.

: Required minimum load fastener

5(wt)+250lbs.

" - loose fit allows pipe to slide.

" " m d with

#905

- Part # and pipe size.

AFCON

# backing nut sold separately.

906

Listed Restraint

3/4 thru 2""

#905

1.5000

#906

3.00

2

Listed Restraint

3/4 thru 2""

Specific products are exclusively designed to be compatible with other products including parts and fasteners, resulting in a listed sway brace, restrainer or hanger assembly.

AFCON AFCON

the following warranty restriction will apply. - will warrant against the failure of its products when used in combination with other products, parts or systems

Be advised DISCLAIMER NOT

not manufactured or sold by . shall be liable under any circumstances whatsoever for any direct or indirect, incidental or consequential damages of any kind, including but not
limited to loss of business or profit, when non- products have been, or are used.

AFCON AFCON

AFCON

NOT

ONLY

AFCON

9/08

CAD

CAD