Aethra SV22P1 DATASHEET

SV22P1

f

PRI VoIP IAD
E1 for up to 30 simultaneous voice calls
4-wire ShDSL broadband access

Next Generation Networks introduction

Ideal solution for combining broadband access and Voice
over IP, connecting legacy PBX system to IP networks

Flexible

E1 PRI interface provides up to 30 independent channels
while the 4-port Ethernet switch allows data connectivity
with enhanced layer3/layer2 capabilities

The SV22P1 is an Integrated Access
Device that enables Network
Operators and ISPs to effectively
deploy Next Generation Networks
based on Voice over IP technology
offering to Small and Medium
Businesses integrated broadband
data and carrier-class voice services
over ShDSL.
One-box solution providing Data
and Voice services through ISDN
PRI, Ethernet and ShDSL interfaces.

Fast integration and “Five-9s” Service Availability

The SV22P1 IAD guarantees seamless installation and the
highest degree of compatibility with every type and brand o
legacy PBX. An optional fully managed back-up battery unit is
also available for service continuity in case of mains faults.

Full IP Services and Security Features

SV22P1 provides enhanced routing and bridging capabilities,
also offering firewall functionality and VPN data protection
(including IPSec hardware encryption) on transmission between
two sites. Moreover, Virtual Router Redundancy Protocol
configuration increases reliability performing a physical backup.

Traffic Management Capabilities

SV22P1 supports Traffic Shaping and layer2/layer3 QoS
providing interworking mechanisms between the two layers.

Powerful Configuration & Management

SV22P1 offers a web-based interface for easy configuration and
monitoring. It includes remote management via an internal web
server or telnet server using the Command Line Interface.
Syslog protocol can also be used to send event notification
messages across the IP network.

SV22P1

Technical Specifications

LED Indicators

• Power

• RDY (Fail)

• EMERG.

• E1

- ACT

- AIS

- LFA

- LOS

• LAN (1-4)

• Internet

• Line

Physical Interfaces

• 4 switched 10/100bT Ethernet ports with
RJ-45 connectors

• Sync IN/OUT ports with 2 Stereo Jack 3,5 mm
connectors

• Balanced and unbalanced E1 G.703/G.704 with

RJ-45 or coax connectors

• 1 console port with MiniDIN 8P connector

ShDSL Network Interfaces

• ShDSL 2/4-wire with two RJ-11 connectors

• ETSI TS 101 524,

• ITU G.991.2 Annex B

• Line rate up from 200 kbps to 4608 kbps

Voice Interfaces

• ISDN-PRI

- Fully compliant to L1 standards (ITU-T I.413,
ETSI ETS 300 011)

Voice Processing

• Voice Codes

- ITU-T G.711 (A-law, µ-law)

- ITU-T G.729a (factory setup option)

- Transparent pass-through

• ITU-T G.165/G.168 echo cancelation

• Voice Activity Detection and Comfort Noise Generation

• RTP/RTCP (RFC 1889)

• 15/30 Voice Channels (factory setup option)

Signalling

• Euro ISDN EDSS-1

• ETS 300 125 (ITU-T Q.921)

• ETS 300 102-1 (ITU-T Q.931)

• Q-SIG (PSS-1)

• SIP 2.0 according to RFC 3261 (TCP or UDP transport)

• En-block and Overlap sending

• ISDN speech, audio and data (Fax Gr 4, UDI 64, RDI 64)

• DTMF detection and carrying (RFC2833), DTMF info

• Local Generation of:

- Dial tone

- Ring back tone (180 Ringing reply)

- Call Waiting tone

- Busy tone

- Fast Busy tone

Fax and Modem Support

• T.38 fax relay

• Automatic G.711 Fax and Modem Pass-Through

Supplementary Services

• Locally managed2 or Softswitch-based

- Call hold

- Consultation call

- Call waiting

- Call Forwarding

- Caller Identity Presentation (CLIP)

- Identity restriction

- Call transfer

• DDI Bundle

- GNR Management

IP Functions

• IP Routing

- RIP v1/v1c/ v2, BGP, OSPF

- Enhanced Network Address and Port Translation

- DHCP Server/Client/Relay, DHCP Learning

- Multicast IGMP v1/v2/v3, PIM-SM

• Routing Filtering Redistribution

• Firewalling

- Extended Access Lists

- Stateful Packet Inspection including Denial of

• IP Services

- DNS proxy

- VPN (GRE, IP, PPTP server/client)

- IPSec with DES, 3DES and AES

- ICMP, IGMP snooping, Telnet, TFTP

- Layer 3 QoS according to DiffServ model

- Priority based queuing (Absolute Priority, WFQ, RED)

- Extensive monitoring, tracing and troubleshooting

Ethernet Services

• Self Learning Bridge with up to 1k MAC addresses

and automatic ageing

• Full-Duplex IEEE 802.3x

• Half-Duplex back pressure flow control

• Automatic MDI/MDI-X crossover

• Broadcast/Multicast storm protection

• VLANs (802.1Q and 802.1p) port based management

• Tag/Re-Tag/Untag

- Trunking (VLAN multiplexing)

- Priority based queuing

ATM

• Services

- Up to 8 VCCs

- Class of Services (CBR, VRB-rt, VBR-nrt, UBR+, UBR)

- Voice and Data packets over different VCCs

- Selective CLP marking

- F4/F5 OAM cells, AIS and RDI

- ATM: ITU T-I.361, ITU T-I363.5, ITU T-I432, ITU TI610,

• Access protocols

- IP over AAL-5, Ethernet over AAL-5 (RFC2684)

- PPP over AAL-5 (RFC2364)

- PPP over Ethernet (RFC2516)

- LLC/SNAP and VC encapsulation

(NAPT) engine, with multiple ALGs (including SIP,
TFTP and H.323)

Service attacks

(RFC2474, RFC2475)

facilities

(VC bundling)

ITU T-I731

1

Authentication

• PAP/CHAP/MS-CHAPv1 and v2 authentication

• Basic and Digest schemes (RFC2617)

Service Resiliency

• VRRP (RFC2338)

Management & Configuration

• Password Protected Access

- 2 login levels

- AAA and local authentication

• Local Management

- Console port

- Extensive CLI

- Windows
and firmware download

• Remote Management

- CLI (internal Telnet Server)

- HTTP (embedded WEB Server)

- SNMP Agent (v1, v2c)

- SSH

- Syslog

- Network Performance Monitor

- Ping MIB

- TR-069

• Firmware upgrades: Local and Remote
(TFTP client embedded)

Environment

• Operating Temperature: -5° ÷ 45°C (23° ÷ 113°F)

• Non-Operating Temperature: -40° ÷ 70°C (-40° ÷ 158°F)

• Operating Humidity: 10 ÷ 93% (non-condensing)

Compliance & Approvals

• Storage: ETSI EN 300 019-2-1 T 1.3

• Transportation: ETS 300 019-2-2, T 2.3

• Operating Conditions: ETS 300 019-2-3, T 3.2

• EMC: EN 55022, EN 55024, EN 61000-3-2,

EN 61000-3-3

• Protection: ITU-T K.21

• Safety: EN 60950-1

Power

• External power supply

• AC input voltage: 100 to 230 Vac

• AC input frequency: 50 to 60 Hz

• AC input current: 0.6 A

• Power Backup Unit (PBU)

®

based wizard for configuration

Models

• SV22P1-15 up to 15 voice channels

• SV22P1-30 up to 30 voice channels

Notes

1

Supplementary Services management is not yet fully
standardised by international bodies and their
implementation could be subject to revisions

2

Depending on the specific service, a common
implementation between the IAD and the Softswitch
needs to be agreed

Code 071073044GB Rev. 0 (10/07)

A TLC Srl
Legal Office

via Giovanni Battista Martini, 2
00100 Roma (Italy)

All information provided by A TLC in this datasheet is believed to be accurate. A TLC Srl reserves the right to discontinue and change specifications and prices at any time without prior notice.
Copyright © 2010 A TLC Srl - all rights reserved.

Operating Office

via Matteo Ricci, 10
60126 Ancona (Italy)
Telephone [phone]

Email:[e-mail]

www.aethra.com

Code 071073053GB Rev.6 (06/10)