Aeromotive 18667 User Manual

18660, 18661, 18662 & 18663 Stealth Fuel Cell

INSTALLATION INSTRUCTIONS

WARNING!

The fuel system is under pressure. Do not open the fuel system until the pressure has
been relieved. Refer to the appropriate vehicle service manual for the procedure and precautions
for relieving the fuel system pressure.

To use this stealth fuel cell in your vehicle’s fuel system, you must do the following

• A by-pass style fuel pressure regulator must be used in the system.

• Utilize high pressure fuel lines, fittings and o-rings for all connections from the

fuel tank to the fuel pressure regulator.

• For long term driving applications where continuous run times exceed 30 minutes

and fuel capacity is less then 10 gallons, Aeromotive recommends the installation

of a pump voltage control module, Aeromotive p/n 16306.

Failure to follow the above may result in fuel leakage, bursting of the fuel lines, poor
vehicle performance and/or decreased fuel pump life! Improper installation will void all
warranties for this product!

Aeromotive system components are not legal for sale or use on emission controlled motor vehicles

CAUTION:

:

Installation of this product requires detailed knowledge of automotive systems and repair
procedures. We recommend that this installation be carried out by a qualified automotive
technician.

Installation of this product requires handling of gasoline. Gasoline vapors are highly
flammable. Ensure you are working in a well ventilated area with an approved fire extinguisher
nearby. Extinguish all open flames, prohibit smoking and eliminate all sources of ignition in the
area of the vehicle before proceeding with the installation.

The enclosed Aeromotive fuel pump utilizes a AN-10 ORB (O-ring Boss Ports) style outlet port; these
ports are NOT PIPE THREAD and utilize NO THREAD SEALANT.

Compatible Fuels:

Pump Gas

Race Gas

E85

Diesel

The following steps are typical of most installations:

1. Find a good mounting location on your vehicle for the Aeromotive Stealth Fuel Cell. Remove any

sharp edges from the area around the fuel cell prior to mounting. Mount the cell in accordance to the
requirements set forth by your racing sanctioning body. Fuel cells should always have good solid floor
support under the cell for the weight of the fuel. The top, bottom and sides of the cell must have the
proper support. To make securing the Aeromotive Stealth Cell easier strap kits are available from
most major fuel cell manufactures.

2x AN-08 Rollover Valve / Vent

AN-10 Pump Outlet

AN-08 Return Line Port
From Fuel Pressure Regulator

2. Connect AN-08 lines to the tank vent fittings. Tank vent lines must be ran outside the vehicle.

3. Connect the fuel pump outlet to a fuel filter (Aeromotive p/n 12301 (10 micron) or 12335 (40 micron)).

Make sure you use high pressure (150 psi minimum) fuel line for this connection!
For AN-10 Line, Aeromotive p/n 15608, (AN-10 ORB to AN-10 Flare Union)
For AN-08 Line, Aeromotive p/n 15610, (AN-10 ORB to AN-08 Flare Union)
For AN-06 Line, Aeromotive p/n 15609, (AN-10 ORB to AN-06 Flare Union)