Aeromotive 11117 INSTALLATION INSTRUCTIONS

AEROMOTIVE Part # 11117

INSTALLATION INSTRUCTIONS

Not For Street Use!

CAUTION:

Installation of this product requires detailed knowledge of automotive systems and repair procedures. We

recommend that this installation be carried out by a qualified automotive technician.

Installation of this product requires handling of gasoline. Ensure you are working in a well ventilated area
with an approved fire extinguisher nearby. Extinguish all open flames, prohibit smoking and eliminate all sources
of ignition in the area of the vehicle before proceeding with the installation.

When installing this product, wear eye goggles and other safety apparel as needed to protect yourself
from debris and sprayed gasoline.

WARNING!

The fuel system is under pressure. Do not open the fuel system until the pressure has been relieved.
Refer to the appropriate vehicle service manual for the procedure and precautions for relieving the fuel system
pressure.

The enclosed Aeromotive fuel pump utilizes an o-ring sealed AN-12 style outlet ports; this port is NOT PIPE THREAD
and utilizes NO THREAD SEALANT.

To use this pump in your vehicle’s fuel system, we strongly recommend the following

Gravity feed the pump by mounting it lower than the fuel cell.
Utilize high pressure fuel lines, fittings and o-rings for all connections from the
fuel cell to the engine.

Failure to follow the above recommendations may result in fuel leakage, bursting of the fuel lines, poor vehicle
performance and/or decreased fuel pump life! Improper installation will void all warranties for this product!

Aeromotive system components are not legal for sale or use on emission controlled motor vehicles.

Performance Specifications: Model 11117

Fuel Compatibility Gasoline & Methyl Alcohol
Port Sizes 1 ¼” Inlet & AN-12 Outlet

Recommended Fuel Pressure regulator:
EFI System Aeromotive p/n 13110
Carbureted System Aeromotive p/n 13202

:

The following steps are typical of most installations:

1. Once the engine has been allowed to cool, relieve the fuel system pressure and disconnect the negative battery

cable.

2. Raise the vehicle and support it with jack stands.

3. Using a suitable timing cover, mount the Aeromotive fuel pump adapter clamp to the timing cover using the supplied

screws. Loosen the clamping screw on the adapter, slide the front of the fuel pump into the adapter clamp and tighten
down the clamp bolt. Make sure the mounting location is clear of the exhaust, is clear of any moving suspension or
drivetrain components and will keep the pump clear of track obstructions or debris.

Note: Be sure to route all fuel lines clear of any moving suspension or drivetrain components, and any exhaust
components! Protect fuel lines from abrasion and track obstructions or debris.

4. Determine which direction the fuel pump shaft will rotate. The direction the shaft is rotated will determine which port is

the inlet and which is the outlet. Using Figure 1a & 1b as a reference identify the fuel pump inlet and outlet ports. If the
fuel pump shaft is rotated in a clockwise direction as viewed from the front of the pump the inlet and outlet ports will
be as shown in Figure 1a. If the fuel pump shaft is rotated in a counter-clockwise direction the inlet as shown in figure
1a now becomes the outlet and the outlet in figure 1a is now the inlet, this is shown in figure 1b.

Figure 1a