Aero Mist 60100K User Manual

LIMITED WARRANTY

Aeromist, Inc. shall warrant the components of the Pump (Model 60100K) to
be free of defects in workmanship for one year. This warranty does not apply
to malfunctions caused by the fault or negligence of the buyer or third party,
including failure to perform periodic maintenance. No warranty of merchant
ability or other warranty, expressed or implied, is made.

In order to take advantage of this warranty, you must first contact Aeromist,
Inc. for a Return Goods Authorization Number. Any defective product must be
returned freight prepaid to Aeromist for examination and disposition. Aeromist
agrees to be responsible for return shipment costs on any approved warranty
repair. The serial number of the product will determine warranty date unless
original purchase invoice can be provided.

The buyer agrees that the sole and exclusive remedy in law or in equity for
breach of any and all warranties and the sole and exclusive remedy for the
manufacturer’s liability of any kind (including without limitation, liability for neg
ligence) with respect to the product and all other performance by the manu
facturer will be limited to the repair of, or at the MANUFACTURER’S OPTION,
THE REPLACEMENT OF THE PRODUCT. Buyer further agrees that the manu
facturer will, in no event have any responsibility or bear any liability for (a)
the cost of labor for the removal of any defective product or the installation of
any replacement product, or (b) the cost of transportation to the manufacturer
of the defective products returned for evaluation. Finally, buyer agrees that
the manufacturer shall not be liable for any other loss or damage (including,
without limitation, lost profits), even if the manufacturer has been advised of the
possibility of such potential loss or damage.

-

-

-

-

INSTALLATION INSTRUCTIONS

23610 N 20th Dr, Ste 6, Phoenix, AZ 85085

[phone]

www.aeromist.com

LI ST OF ALL ENCLOSED PA RTS

QTY PART NO DESCRIPTION

1 60100K Direct-Drive Pump
1 56402 Flexible Nylon Tubing 25' Roll
1 52000 Automatic Drain Valve

57020 MAINTE NA NCE KIT

QTY PART NO DESCRIPTION

1 57011 Filter Element
1 57025 Pump Oil

IN STALLATION INSTRUCTIONS

• WARNING: Before plugging in the unit for the fi rst time, read the following section carefully. To reduce the risk of
electric shock. Plug in supplied grounded cord into a properly grounded receptacle. When servicing this unit, unplug
power cord before attempting any service or repairs.

• Install pump above grade level on a pre-formed concrete pad, 16"×16" minimum size.

• Plug power cord of unit into a properly grounded receptacle.

• Connect water line to water inlet connector.

• Unit is pre-fi lled with oil and ready to run. Oil should be half full on the sight glass when unit is off. Do not overfi ll

• On new misting systems, fl ush lines before installing nozzles. The pump will not build pressure until all nozzles are installed.

• Do not exceed 1000 PSI and do not run pump without water.

• Winter shutdown: Unplug pump power cord, shut off water supply, remove fi lter bowl and drain water. Also drain water out of all lines, to
prevent damage to pump or lines.

• 25 feet or more of nylon tubing is recommended in order to reduce vibration noise.

.

DIRECT DRIVE PUMP SPECIFICATIONS

MODEL FLOW VOLTS MOTOR PUMP LOAD DIMENSIONS

GPM 60 Hz HP RPM Amps L x W x H
60100K 1.0 120 0.75 1725 10.4 24x15x13

Maximum pressure is 1000 PSI, normal operating pressure is 800-1000 PSI.

RECOMMENDED MIN-MAX NOZZLE RANGE

NOZZLES NOZZLES NOZZLES

Nozzle Size .014 .012 .008

Nozzle Range 12–25 15–30 22–45

Choose .012/.014 nozzles for dry climates and .008 for more humid climates.

Regulator

(Normal operating pressure 800-1000 PSI.

Pressure not to exceed 1000 PSI)

Liquid-Filled

Pressure Gauge

Outlet

To Misting Feed Line

Automatic

Drain Valve

ANNUAL MAINTENANC E INSTR UCTION S

• Change oil every 500 hours of runtime or once a year. Use approved Pump Oil (52025). Oil should be half full on the sight glass when

unit is off. Do not overfi ll

• Change Filter Element Annually

.

On/Off Switch

Power Cord

Water Inlet

Oil Filler/Breather Cap

Oil Sight Glass

Filter Bowl

With Replaceable 5-Micron Filter Element

Oil Drain