Aero Mist 52469 User Manual

LIMITED WARRANTY

Aeromist, Inc. shall warrant the components of the 15-Nozzle Fogging Kit (Model

52469) to be free of defects in workmanship for five years. Maintenance items
are not warrantable including nozzles and filters. No warranty of merchantabil
ity or other warranty, expressed or implied, is made.

Liability for, and the exclusive remedy for, defective materials or workmanship,
is limited to the replacement or repair of defective products. This warranty ap
plies only to the original purchaser of the system and is not transferable. Any
parts found to be defective will be replaced at no charge. All parts must be
returned to Aeromist, Inc., freight pre-paid by customer, and will be returned to
customer by Aeromist, Inc., freight collect.

-

-

This warranty specifically excludes the following: Failure of parts due to dam
age by accident, fire, freezing, chemicals, improper installation, or unusual
characteristics of water supply, such as mineral and calcium buildup.

This warranty covers parts only. Any costs incurred due to replacement or repair
is the responsibility of the buyer and not covered under warranty.

-

INSTALLATION INSTRUCTIONS

23610 N 20th Dr, Ste 6, Phoenix, AZ 85085

[phone]

www.aeromist.com

TOOLS REQUIRED

Tape Measure
PVC Tubing Cutter
5/8" Open-End Wrench
9/16" Open-End Wrench

LIST OF ALL ENCLOSED PARTS

QTY PART NO DESCRIPTION

1 56401 Flexible Nylon Tubing 50 ft Roll
5 52468 3-Nozzle Fog Riser (pre-assembled)
15 52411 .012 Misting Nozzle - Fine
1 52513 Brass End Plug

HI GH-PRESSURE PUMP

For optimum performance of your new Aeromist 15-Nozzle Fog
Kit (52469) we recommend the use of an optional 1000 PSI high-

pressure pump to create fog. This system is expandable with up
to 30 (.012 size) nozzles using our 1000 PSI Misting Pump
(60100K). Larger pumps are also available. Please see the en­closed accessories brochure or visit www.aeromist.com for other
available pumps, upgrades and accessories.

IN STALLATION INSTRUCTIONS

1. Connect Flexible Nylon Tubing (56401) to outlet of high-pressure pump.

2. Bury tubing approximately 6" underground. Cut Flexible Nylon Tubing (56401) with a PVC Tubing Cutter. Insert tubing into brass tee
of the 3-Nozzle Fog Riser (52468) until it bottoms out in the fitting. Complete seal with one wrench turn of fitting. Continue by con
necting tubing from one riser to next. Space risers 2-10 feet apart as desired. Closer spacing will result in denser fog. After the last riser,
attach a short piece of tubing and terminate with the Brass End Plug (52513).

3. Flush system for several minutes before inserting nozzles. Install nozzles in 3 risers nearest the pump (hand tighten only) and flush again
for one minute. Install nozzles in each additional riser, one-at-a-time and flush again until nozzles in all risers are installed.

MAINTENAN CE

• Nozzles require cleaning or replacement periodically. Clean nozzles by soaking in vinegar or calcium removal product overnight or
replace as needed.

• Winterize your misting system by draining water out of lines. Be sure all water is drained from Fog lines. This will prevent water from freez
ing and damaging the fog line. This can be accomplished by forcing compressed air through the lines.

Warning! Fogging system is intended for outdoor use only.

• Use normal tap water or soft water only.

• Do not exceed 1000 PSI,

• Do not unscrew nozzles while under pressure

• Do not touch nozzles when system is pressurized

Brass End Plug (52513)

3-Nozzle Fog Riser (52468)

OP TIONAL ACCESSORIES

PART NO DESCRIPTION

60100K 1000 PSI Misting Pump

-

56401 Flexible Nylon Tubing 50 ft Roll
52468 3-Nozzle Fog Riser (pre-assembled)
52473 1-Nozzle Fog Riser (pre-assembled)
52411 .012 Misting Nozzle - Fine
52513 Brass End Plug
52510 Brass Union

-

52512 Brass Tee

FR EQUE NTLY A SKED QUESTIONS

Q How many nozzles can I use with 1000 PSI Misting Pump

(60100K)?

A 30 nozzles and still maintain 800-1000 PSI range

Q How much fog will this create?
A Fog varies depending on temperature, humidity and spacing

Q Does this create cooling?
A Yes, this creates cooling when the fog evaporates.

Q Can nylon be buried under concrete?
Y Yes, recommend using sleeving.

Connect to High-Pressure Pump

Soil Line