AeroComm PKLR2400 Users Manual

Copyright Information/FCC User’s Notice

Copyright Copyright © 1999 AEROCOMM, Inc. All rights reserved.
Information The information contained in this manual and the accompanying

software programs are copyrighted and all rights are reserved by
AEROCOMM, Inc. AEROCOMM, Inc. reserves the right to make
periodic modifications of this product without obligation to notify
any person or entity of such revision. Copying, duplicating, selling,
or otherwise distributing any part of this product without the prior
consent of an authorized representative of AEROCOMM, Inc. is
prohibited.

All brands and product names in this publication are registered
trademarks or trademarks of their respective holders.

FCC NOTICE

WARNING: This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference and (2) this device
must accept any interference received, including interference that may cause undesired
operation.

ANTENNA WARNING

WARNING: This device has been tested with an MMCX connector with the antennas listed below.

For the purpose of FCC RF Exposure Compliance, the Original Equipment Manufacturer
(OEM) must ensure professional installation of Antennas 2, 3, 4, 6 and 7 by signing the
PROFESSIONAL ANTENNA INSTALLATION AGREEEMENT. Any antenna not in the
following table must be tested to comply with FCC Section 15.203 for unique antenna
connectors and Section 15.247 for emissions.

Mfr Model Freq Gain Type Connector Dimensions Installation
1 Centurion WXE2400 2.4-2.5 2dBi Omni MMCX <2.25" Integrated
2 Maxrad MFB24008 2.4-2.5 8dBi Omni N-F 17" Professional
3 Maxrad BMMG24000MMCX6' 2.4-2.5 unity Omni-mobile MMCX 1.75" Professional
4 Maxrad BMMG24000RPSMA12' 2.4-2.5 5dBi Omni-mobile R-SMA-M 9" Professional
5 AeroComm NZH2400 2.4-2.5 1dBi Omni Integrated 1"x0.3" Integrated
6 Maxrad MP24013FC 2.4-2.5 13dBi Panel TNC-F 8.7x7.9x1.1 Professional
7 Maxrad MUF24005 2.4-2.5 5dBi Omni-Mobile R-SMA-M 8.75" Professional
8 Centurion WXR2400SMRP 2.4-2.5 2dBi Omni R-SMA-M <2.25" User

20cm min
20cm min
20cm min

20cm min
20cm min

LABELING REQUIREMENTS

WARNING: The Original Equipment Manufacturer (OEM) must ensure that FCC labeling

requirements are met. This includes a clearly visible label on the outside of the OEM
enclosure specifying the AeroComm FCC identifier for this product as well as the FCC
Notice above.

RF EXPOSURE

WARNING: For the purpose of FCC RF Exposure Compliance, the Original Equipment

Manufacturer (OEM) must ensure that Antennas 2, 3, 4, 6 and 7 in the previous table
are professionally installed and that a minimum of 20cm spacing between the user and
antenna is required. The OEM is required to sign the by signing the PROFESSIONAL
ANTENNA INSTALLATION AGREEEMENT.