AeroBed Family Quick Pool with Built-In Seats User Manual

7966 Rev 6/08

107 Pump / Pool

Instruction Manual

Thank you for joining the AeroBed® family by purchasing one of our premium products. You can expect top-notch quality, innovation, and imagination from every AeroBed
product. You are about to enjoy the comfort of an AeroBed pool. It is your responsibility to read and always follow the safety, care, and maintenance instructions for your
new AeroBed product. Always instruct and supervise others on your pool’s proper use, maintenance, and safety.

IMPORTANT: Preparation of your AeroBed product requires no tools. Use of tools may damage your pool.

IMPORTANT SAFETY INFORMATION AND WARNINGS

WARNING: THE USE OF THIS PRODUCT REQUIRES COMPETENT ADULT SUPERVISION AT ALL TIMES. THIS PRODUCT IS NOT RECOMMENDED FOR

CHILDREN UNDER SIX (6) YEARS OF AGE.
Pool
POOL FENCING LAWS IN YOUR AREA MAY AFFECT THIS PRODUCT. IT IS YOUR RESPONSIBILITY TO KNOW AND FOLLOW YOUR LOCAL LAWS.
WARNING: NOT A LIFESAVING DEVICE. USE ONLY WITH ADULT SUPERVISION. Never leave children unattended in or near water.

- Do NOT dive or jump into or on pool or allow children to do so. Warn children that improper use can be fatal.

- To be used only for recreational swimming. Do not use for diving, as a baby playpen, trampoline, boat or for any other recreational activity.

- Place the pool in a safe area before use, making sure that there are no sharp edges, steps, drops or breakable items nearby.

- This pool is made of plastic and may melt or burn if it comes in contact with any flame or heat source. Keep all flame, heat sources or other hot objects

away from this product.

- Guard against slips and falls by avoiding all rough play in or around pool.

- NEVER place pool in another body of water.
Rechargeable Pump - For outdoor use.

WARNING: The Air Release Valve is made of several small parts which could pose a choking hazard. Keep all parts away from children under 6 years of age.
WARNING: Pump is not a toy-children must be supervised at all times.
WARNING: Risk of electric shock. Do not expose to rain. Store Indoors.

- Pump charger is an electrical device. Do not use in or around water.

- Charger to be used indoors only.

- Do NOT place pump or charger where they could fall or be pulled into the water.

- Not recommended for children under 6 (six) years of age.

- The pump contains nickel-cadmium batteries.

- The pump should not be incinerated.

- The pump should not be overcharged or reverse charged.

- The pump batteries are not replaceable. Do not attempt to replace them.

- Do NOT charge the Ni-Cd battery pump with any other charger than the one provided with the pump.

- Do NOT attempt to dissemble, repair, or service the pump. No user serviceable parts are contained inside. Contact Aero Products International, Inc. at

1834 Walden Office Square, Third Floor, Schaumburg, IL 60173 for repair or servicing information.

RECHARGEABLE Ni-Cd PUMP - For Outdoor Use.

WARNING: Risk of electric shock. Do not expose to rain. Store Indoors.
IMPORTANT: PUMP MUST BE CHARGED FOR 24 HOURS PRIOR TO THE FIRST INFLATION. Use the AC adapter to charge your new Aero

pump for 24 hours. For maximum performance, be sure to fully discharge pump before recharging. After initial charge and use, charge pump for
12 HOURS at a time. Charging your pump for periods shorter or longer than 12 hours will substantially decrease the life of your Ni-Cd pump. In
an emergency, a 3 hour charge will provide one inflation, however, continued charging for 3 hour periods will substantially decrease the life of
your Ni-Cd pump.

IMPORTANT: ALWAYS store pump and charger in a cool, dry place. DO NOT allow pump or charger to get wet. Allowing pump and/or charger

to get wet will void your warranty.

IMPORTANT: Charger to be used indoors only.
TO CHARGE / RECHARGE:

a) First, remove pump and charger from box.
b) Second, remove tiny rubber plug from hole on the back of the pump.
c) Insert the charger’s mini-plug in the hole.

d) Third, plug the charger unit into any standard 110V (or 220V depending on your local service) electrical outlet and let it charge for 12 hours

(24 hours on initial charge).
NOTE: For best pump performance, you must completely drain the charge from your pump prior to recharging. For directions, see discharge
section below.

Prior To Inflation:
a) Unplug the pump after it has been charged for 12 hours (24 hours on initial charge).
b) Remove charger unit from the electrical outlet and the mini-plug from the pump.
c) Re-insert the tiny rubber plug into the hole on the back of the pump.

NOTE: Pump will not run while charger is plugged into an electrical outlet.
To Discharge:

a) Place pump on valve as if to inflate product.
b) Allow pump to run until the pump motor dies down.

NOTE: When properly used, your pump will hold a full charge for approximately 90 days. When storing pump for longer than 90 days, fully
discharge and recharge pump every 120 days. This will help maximize pump life.

WARNING: PUMP SHOULD ONLY BE USED WITH AERO ADAPTER PROVIDED. DO NOT USE WITH ANY OTHER ADAPTER.
IMPORTANT: PUMP CONTAINS NICKEL-CADMIUM BATTERIES. BATTERIES MUST BE RECYCLED OR DISPOSED OF PROPERLY.

INFLATION

IMPORTANT: Prior to inflation, find a level spot to inflate your pool.

1. Remove your new AeroBed pool from the packaging and unfold until it lies flat on the ground.

2. Make certain the Quick Air Release Valve located at the head of the pool is closed. If the Air Release Valve is open, close it by using 2
thumbs to push cover and snap into valve. Be careful to avoid pushing valve cover to the right or left as it snaps into the valve opening.

This is the closed position. Open Air Release Valve Close Valve Using 2 Thumbs

3. Remove black cover(s) from the Inflation/Release Valve(s) and pump. Attach pump to valve(s) located on the side of the pool.

4. Turn pump clockwise until the pump turns on.

5. When product is inflated, turn pump counterclockwise and remove. A high pitch whine from your pump will signal that your pool
is fully inflated. Pool will not over-inflate.

6. Detach pump by turning it counter-clockwise.

7. Place covers back on Inflation/Release Valve(s) and pump.

DEFLATION AND STORAGE

1. To empty pool, open water release valve (s) on the bottom of the pool.

2. Once the pool is completely drained, open black Air Release Valve (s) to deflate. With your thumb or forefinger, squeeze the tab toward
the center of the Air Release Valve cover until it opens.

3. Each seat has a separate flapper valve. In order to deflate the built-in seats, you must twist off the valve cover and push open flapper to release
all the air.

3. Tightly fold pool towards the Air Release Valve end until all air is expelled. Unfold and let dry completely before storing.

4. Push the Air Release Valve closed until it locks.

CARE AND MAINTENANCE

1. Inspect your pool prior to each use.

2. Keep your pool away from rocks, sticks or any sharp objects. Large cuts or snags may not be repairable and will not be covered by your pool warranty.

3. When not in use, store your pool in a clean, dry place out of direct sunlight. Product must be at least room temperature prior to inflating.

4. You may clean your pool with a mild dishwashing detergent and warm water, or spray it off with a garden hose. Do not use chemicals or other compounds.
Allow your pool to air dry completely after cleaning.

5. Do not allow water to enter your pool through the valve(s). If water does enter the pool through the valve(s), make sure to empty it and completely dry the pool before storing.

PRODUCT USE

1. Prior to each use, fill pool with fresh, clean water. Pool should be filled to the top of bottom ring. Please refer to Maximum Water level mark on the side of the pool.

2. Water in the pool should be changed daily.

3. As in any recreational activity, reckless use, misuse, and/or neglect of this pool may result in serious injury or death. It is your responsibility to refer to the safety
instructions.

4. Pool should be emptied and stored when not in use.

TROUBLESHOOTING

Very rarely, your AeroBed

1. Check to make sure your pump is fully charged.

2. If your pool doesn’t appear to be inflating:
First, make sure the Quick Air Release Valve is closed.
If the valve is open, close it by using 2 thumbs to push cover firmly into valve. Be careful to avoid pushing valve cover to right or left as it snaps into valve opening.

3. If air leakage from the Quick Air Release Valve occurs:
Carefully, inspect the soft round gasket on the inside of Quick Air Release Valve cover. Make sure there is no dirt or debris, cuts, nicks, or tears to the gasket. If there is dirt or
debris; clean and use. If cut, nicked or torn, call our Customer Service Center or visit our website to order a replacement part.

4. If trouble persists, please phone our Customer Service Center for assistance.
U.S.: 1-888-462-4468
Monday through Friday, 9 AM to 5 PM Central Standard Time

Canada: 1-888-702-8281
or visit our website at: www.aerobed.com

®

pool may fail to inflate properly. Should this occur, please use the following check list.

LIMITED EXPRESS WARRANTY

Aero Products International, Inc. (“us”) warrants to the original purchaser (“you”) that the AeroBed (“product”) is guaranteed against defects in materials and
workmanship for the following periods: pump and valve, one (1) year from date of purchase; pool, ninety (90) days from date of purchase.

OUR EXCLUSIVE OBLIGATION, AND YOUR SOLE AND EXCLUSIVE REMEDY UNDER THIS LIMITED WARRANTY OR OTHERWISE SHALL BE THE REPAIR OR
REPLACEMENT OF ANY PRODUCT OR PARTS WHICH MAY PROVE DEFECTIVE UNDER THE CONDITIONS OF NORMAL USE DURING THE WARRANTY PERIOD.
IN THE EVENT THE PRODUCTS OR PARTS CANNOT BE REPAIRED OR REPLACED, YOU SHALL RECEIVE A PRODUCT OF COMPARABLE VALUE AT OUR
EXPENSE. AEROBED WARRANTY IS NONTRANSFERABLE, AND IS VALID FOR THE FIRST, ORIGINAL PURCHASER FROM AN AUTHORIZED DEALER OR
AEROBED PRODUCTS. THIS LIMITED WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE
TO STATE.

Exclusions

Our obligation under this limited express warranty shall not apply if our inspection shows:
A. That the product is used for other than normal indoor sleeping purposes.
B. Any product or part has been damaged by alteration.
C. Any product or part has been subject to accident, misuse, abuse or has been operated contrary to our written instructions.

Warranty Redemptions

You must obtain an authorization from us before returning a defective product. Call us at 1-888-462-4468 or write us at Aero Products International, Inc., 1834
Walden Office Square, Third Floor, Schaumburg, IL 60173 for a return authorization. The product should be carefully packaged and delivered postage or delivery
charges prepaid at the address set forth above. You are responsible for all damages incurred in shipping.

Warranty Disclaimer

EXCEPT FOR THE LIMITED EXPRESS WARRANTY SET FORTH IN THIS SECTION, OR ANY IMPLIED WARRANTIES PERMITTED UNDER APPLICABLE LAW,
SELLER MAKES NO EXPRESS OR IMPLIED REPRESENTATIONS. ALL CLAIMS AGAINST US MUST BE BROUGHT WITHIN ONE (1) YEAR FROM THE TIME THEY
ARISE. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE ABOVE DISCLAIMER MAY NOT APPLY TO YOU.

Limitation of Liability

TO THE FULLEST EXTENT PERMITTED BY LAW, SELLER SHALL NOT BE LIABLE FOR INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES WITH
RESPECT TO THE SALE OR USE OF THE PRODUCTS, INCLUDING ANY LOST REVENUES, LOSS OF USE OR LOST PROFITS, REGARDLESS OF THE THEORY BY
WHICH ANY CLAIM MAY BE BASED, INCLUDING ANY TORT, TANGIBLE PROPERTY DAMAGE OR STATUTORY CAUSES OF ACTION. NOTWITHSTANDING THE
TERM OF ANY LIMITED OR IMPLIED WARRANTY, OR IN THE EVENT THAT ANY LIMITED WARRANTY FAILS OF ITS ESSENTIAL PURPOSE, IN NO EVENT WILL OUR
ENTIRE LIABILITY TO YOU EXCEED THE PURCHASE PRICE ACTUALLY PAID BY YOU FOR THE PRODUCTS, OR ANY DEFECTIVE OR NONCONFORMING
PORTION THEREOF, WHICHEVER IS THE LESSER AMOUNT.
SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION
MAY NOT APPLY TO YOU.
THIS LIMITATION DOES NOT APPLY TO ANY CLAIMS FOR PERSONAL INJURY. THIS AGREEMENT AND ANY CLAIMS AND DISPUTES BETWEEN THE PARTIES
SHALL BE GOVERNED BY AND SUBJECT TO THE INTERNAL LAWS (EXCLUSIVE OF THE CONFLICTS OF LAW PROVISION) AND DECISIONS OF THE COURTS OF
THE STATE OF ILLINOIS. THE EXCLUSIVE VENUE AND JURISDICTION FOR ALL CLAIMS AND DISPUTES SHALL BE THE STATE OR FEDERAL COURT LOCATED IN
SCHAUMBURG, ILLINOIS.

Aero Products International, Inc. neither assumes nor authorizes any representative or other person to assume any obligation or liability other than those expressly set
forth herein.
© 2008 Aero Products International, Inc. All rights reserved. 1834 Walden Office Square, Third Floor, Schaumburg, IL 60173 USA

This product may be covered under one or more of the following U.S. and/or foreign patents: U.S. Pat. Nos. 4,977,633; 5,267,363; 5,367,726; 6,237,621;
6,508,264; 6,598,626; 6,701,559 ; 6,755,208; 6,986,360; 6,996,867; 7,025,576; 7,039,972; 7,165,283; D464,225; D490,635; D513,145; CN 1809683.2; RU
2271129; SG93011; EP 0 487 641 ; DE 69024962.4; EP 0 947 152; DE 69233298.7; EP 0 605 624 ; DE 69230797.4; JP 3,419,774; TW 62301; AU
731613; BR PI9710873-1; CN 97196557.9 ; HK 1025374; MX 216898; MX 242683; NZ 334203; SG 61207; JP 2010828; EP 1 359 325; EP 1 415 576.
Other U.S. and foreign patents pending.

Made in China.