AEO LS-XJ01 Instruction Manual

Instruction Manual for BB Buzzer Alarm

(Lost-founder)

LS-XJ01

1.Feature：

The Bi-Bi beep is continuously emitted in a specific state; the
built-in button battery can keep the buzzer state even when the
main power is turned off.

2.Specification:

Size: 38*22*18mm

Weight:12g（with battery）
Battery size: Button battery 2032（Full beep for at least 90 minutes,
there may be a little different in different battery brands.）

Voltage input: 3.6V-8.4V

3.Connection:

Connect BB-Alarm together with Aileron or Elevator servo by
Y-Harness or Connect BB-Alarm to open channel and set mixing
from Aileron or Elevator.

4.How to use

4.1 Turn ON micro switch after you turn ON receiver power, You will
hear Bee-Bi for start beep, Then you hear Battery voltage Beep.

“Bi-Bi-Bi-Bi” 4 short Voltage is higher than 4V
“Bi-Bi-Bi” 3 short Voltage is between 3.8V and 4.0V
“Bi-Bi” 2 short Voltage is lower than 3.8V

4.2 After the switch is turned on, if the PWM signal that has not
been received within 70 seconds keeps unchange, or if the PWM
signal is not received, the alarm will start.

4.3 The alarm tone supplied by the receiver is long, and the built-in

battery-powered alarm tone is short.

4.4 Pls turn off the switch after usage.

内置电池式寻机蜂鸣器使用说明

LS-XJ01

1.基本功能：

在特定状态下持续发出Bi-Bi的蜂鸣声；因内置纽扣电池，可以在主电源
断电的情况下依然保持蜂鸣状态。

2.基本参数

尺寸：38*22*18mm
重量：12g（带电池）
电池尺寸：纽扣电池2032（满电至少蜂鸣90分钟）
输入电压 ：3.6V-8.4V

3.连接方式

将插头配以Y线的方式 插入接受机常用通道。或插入单独的接收机通道以
通道混控模式达到同样的效果。

4.使用方式

4.1 确认供电后，打开开关，会听到 “哔--- 哔”一长一短两声开机提示
音，随后会根据电压有不同的声音提示：
“哔哔哔哔” 4短 电压高过4V
“哔哔哔” 3短 电压处于3.8V-4.0V之间
“哔哔” 2短 电压低于3.8V

4.2打开开关后，若70秒内未能接收到的PWM信号无变化，或者未能接
受到PWM信号，则会开始报警。

4.3由接收机供电的报警音是 长声，内置电池供电的报警音是 短声。

4.4请注意 使用完后，请关闭开关以。