AEG Powertools 8000011647 BAL User Manual

Kommunikationszubehör
für USV PROTECT C. / C. R / 1. / 1.M

Communication accessory
for UPS PROTECT C. / C. R / 1. / 1.M

Einsteckkarte pot.-freie Kontakte
Slotcard potential - free contacts

AEG Power Solutions GmbH
Änderung / Revision

Datum / Date 05 / 2008

03 / Schneider

Betriebsanleitung
Operating instructions

8000011647 BAL en

Settings of Jumper on AS/400 ( Ver01688-04 )

1． Feature of the AS/400 card (Ver01 688-04)

AS/400 (Ver01688-04) card provides shutdown and monitoring of UPS status
through a relay dry-contact signal as previous version, to meet different
application requirement, the AS/400 (Ver01688-04) card is capable of selection
the status of the dry-contact signal (active close or active open) by jumper
setting.

This document describes the logical connection implemented on the card and
the definition of the jumper setting.

2． Internal Logical connection

Fig. 1 Pin definition and internal logical connection

Please refer to Fig.1 on the card. There are 5 relays action according to the UPS status
under control of the controller on the card, and Normal-Close terminal and
Normal-Open terminal of each relay connect to pin 1 and pin 3 of a 3-pin connector
respectively, the pin 2 of the 3-pin connector connect with the signal pin of the DB9
interface connector. The 2-pin jumper can be plug to the 3pin connector to either short
circuit Pin1 & Pin2 or short circuit Pin3 & Pin2.

Relay card Page 1 Release: May 2008