AEG-Electrolux RGE100 User Manual

2
Fig. 1.
15
Dear customer, please read the instruction book and all additional information before using the appliance. It is most important that they should be retained with the appliance for future reference!
1. Warnings and directions
This product is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the product.
Any electrical work required to install this appliance should be carried out by a qualified electrician. It is dangerous to alter the specifications or modify this product in any way. The absorption refrigerator is designed to be used specifically for the storage of edible foodstuffs and drinks
only. There are working pads in this product which heat up. Always ensure that there is adequate ventilation, as
failure to do so will result in component failure and possible food loss (refer to relevant instructions for unit installation under point 4).
Before defrosting, cleaning or maintenance work is carried out, be sure to switch off and unplug the appliance. Shut down gas operation!
Manufacturers' food storage recommendations should be strictly observed. Refer to relevant instructions for food and drink storage under point 13.
Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or more serious malfunctioning. This product should be serviced by an authorized service engineer, and only genuine spare parts should be used.
2. Area of use
The unit may not be installed in motor vehicles and boats when using the gas operation method. Operation using liquid gas in enclosed spaces in not permitted. The room should have a capacity (length x width x height) of at least 20 m
3
and have a window (which can be
opened) or a door to the outside. Outdoor use includes tents (awnings) which are well ventilated throughout unit operation and flat garden
terraces. There are no restrictions on electrical operation. Site of operation must be protected from rain and other water sources.
3. Storage of gas cylinders
Liquid gas cylinders should never be stored in unventilated areas or below ground (funnel-shaped holes). Avoid direct sunlight. The gas cylinder should not be exposed to temperatures in excess of 50°C.
4. Installation
To be installed horizontally on a smooth, firm or any other appropriate surface. If necessary, adjust/align using a spirit level or a water-filled vessel.
There should be a distance of at least 10 cm between the back of the unit and any other object (wall). Avoid placing unit in direct sunlight and next to other sources of heat. Ventilating ducts of the refrigerator should be kept clear of all obstructions to ensure good air circulation. This will result in a good, energy-saving cooling system.
5. Cleaning
Before initial use and after defrosting or before prolonged periods of disuse, clean the unit containers and door with lukewarm water and, if necessary, washing-up liquid. Warning: do not inadvertently press or force the opened door past its stop-point (this could cause the hinges to break). Never use scouring or corrosive
agents to clean the unit. Wipe cleaned surfaces dry with a soft cloth.
6. A/C operation
Do not use any additional form of energy (batteries/gas). Check that the supply voltage and line voltage data correspond to the type-plate in the unit.
GB
Loading...
+ 7 hidden pages