AEG-Electrolux NOVAMAT430 User Manual

Page 1
Instructions for use GB
129 0690 40
Washing machine NOVAMAT 430
Page 2
NOVAMAT 430
Before first use, remove the internal packing of your
washing machine !
Technical data
• Dimensions : height without backpanel : 850 mm
height with backpanel : 895 mm width : 450 mm depth : 600 mm
• Voltage : 230 V
• Heater rating : 1950 W
• Power absorbed : 2200 W
• Spinning speed : 800 rpm
Programmes
Temp.
Prog.
Cotton - linen
°C
1
90
1
60
2
90
2
60
3
60
4
40
5
Whites, very soiled with prewash
Economy with prewash + E button
Whites, soiled, without prewash
Economy without prewash + E button
Resistant coloureds
Delicate coloureds
Rinses
Products
a b c d
• • • •
• • • •
• •
• •
• •
• •
Max.
load
5 kg
End of
prog.
Spinning
Before each wash, make sure that :
• the drain hose is correctly placed
• the water tap is turned on (fully open)
• the plug is in the wall socket
• the timer knob is on the "off" position (pressed out, position "0")
Your washin machine
Your washing machine is ready to operate :
• lift up the lid of the machine
• open the drum with your two hands by pres­sing the button A and the two flapdoors till they disengage
• introduce the laundry into the drum ; close the drum and the lid of the machine Be careful : before closing the lid of your ma­chine, make sure that the drum flapdoors are correctly closed :
- the two flapdoors fastened
- the button A pressed out
The detergent dispensers :
a prewash compartment ( a ) b main wash compartment ( b
c bleach compartment (c d softener compartment (d
If you wish to use liquid detergent :
• choose a programme without prewash
• pour the recommended quantity of liquid detergent into the main wash compartment (b
)
)
)
6
7
8
9
10
11
Softening
Spinning
Resistant, very soiled with prewash
60
Resistant, normally soiled
60
Delicates, normally soiled
40
Very delicate textiles - Wool
30
• • •
• •
• •
• •
2,5 kg
1 kg
Rinse hold
12
Synthetics
13
14
When the selected programme is over, the machine stops automatically. The timer knob stops on the position "I". The "synthetics" programmes end with a rinse hold to avoid the creasing of the laundry in case it is not taken away from the drum just after the wash. To end these programmes, you can select a spinning (programme 7) or a draining (programme 14). To end the wool programme, we advise you to realize a draining programme.
Be careful : the lid can only be opened 1 or 2 minutes after the machine has stopped.
3 Rinses
1 Rinse with Softener
Draining
2,5 kg
5 kg
Draining
After each wash :
• press the timer knob ; the control lamp lights off.
• press out the pushbuttons if necessary.
• unplug the machine from the wall socket and turn off the water tap.
Page 3
Control panel
AEG NOVAMAT 430
1 Select the programme
2 Select the temperature
4
3
2
I 0
1
Press the pushbuttons
34 Pull the timer knob
if necessary
4
3
I 0
• choose the programme according to the nature and the degree of soil of the laundry.
• simultaneously push and turn the timer knob clockwise to select the chosen programme.
2
1
• choose the temperature which cor­responds to the chosen programme (see indications on the programme table).
• Half-load pushbutton " " : if pressed at the beginning of an energic wash programme, it enables to wash economically small quantities of laundry, up to 2,5 kg of resistant laundry (cotton-linen). This button can only be used with the programmes for cotton and linen.
• Energy saving pushbutton " " :
this pushbutton enables to save a lot of energy by limiting the water temperature at 60°C (temperature knob on "E"). The other characteristics of the programme remain unchanged.
• Spinning suppression pushbutton " " : it enables to suppress the spinning
phases of the programme for resistant laundry (cotton-linen) when you wish to wash delicately your laundry. The programme ends then with a draining.
4
3
2
I 0
• The programme starts. The control lamp lights on.
1
Page 4
The products (see the leaflet "Washing guide")
Follow the manufacturer's instructions for recommended quantities. If the water is soft, decrease the quantity. If the water is hard or if the laundry is very soiled or stained, increase the detergent quantity a little. For information regarding the degree of hardness in your area, enquire with your local authorities.
Bleach
You may use a bleach agent in all the washing programmes. However, make sure that the fabric withstands the treatment. Bleach is automatically washed down into the drum. Pour 1/4 to 1 glass of 12° chl bleach into compartment "c " before switching the machine on. Make sure that the level of the liquid never exceeds the "MAX" mark.
Softener
Compartment "d" allows automatic addition to the last rinse of a liquid softener. Follow the quantities recommended on the bottle. Make sure that the level of the liquid
never exceeds the "MAX" mark.
Removal of internal packing
The parts protecting the inner components of the machine during transit are red. They must all be removed before using your machine for the first time. These parts and their securing means should be kept in case the machine has to be transported again.
1. Tilt the machine backwards (fig. 1).
2. Unscrew and remove the 2 screws A end the 2 red washers B situated under the
washing machine, then pull on the red plastic ring to take part C out of the machine (fig. 1).
3. Straighten up the machine.
4. After removing the 4 nuts D, the 4 washers (fig. 2), remove the 4 red plastic sleeves E : pull the ring, rotating it at the same time leftwards and rightwards (fig. 3).
If you do not manage to take the red socket off, use a wrench and turn it anticlockwise as shown on the picture (fig. 3 et 4).
5. Unscrew and remove the 4 threaded pins F.
6. Plug the holes left by pins F with plugs G (to be found in the plastic bag with the
instruction manual) taking care to shut down the central part as shown on drawing (fig.
5) and take the polystyrene block (fig. 6) away. Your washing machine is now ready to be operated.
Electrical connection
Before you plug the appliance into the wall socket, make sure that :
• The supply voltage of the domestic wiring system does not fluctuate by more than 10% plus or minus from the value shown on the rating plate.
• The meter, the fuses, the supply line and the wall socket are all suitable to carry the maximum load required by the washing machine (2,2 kW).
The existing safety rules call for the appliance to be connected to an efficient ground wire. The manufacturer disclaims any liability whatsoever if this accident prevention rule is not complied with.
This appliance complies with E.E.C. directive n° 87/ 308 of 06.1987 relative to radio interference suppression.
Water connection
• The end of the water inlet hose must be connected to a cold water tap having 3/4" gas thread spout or to a water tap having a quick-coupling connector after having introduced in the hose ring nut a rubber sealing washer also provided with the machine.
• The curved end of the outlet hose should be inserted into a drain pipe not less than 70 cm and not more than 1,0 m from floor level. Make sure that the drain hose is always safely secured so that it will not become loose or fall down from its position. The water should drain freely and consequently, the drain hose should not be chocked or placed in such a way as to obstruct the normal water flow. If an extension is required, remember that it might cause a malfunction in the drain pump, particularly if the extension has a length in excess of 1 meter or if the diameter of the extension is smaller than the diameter of the original drain hose. Water pressure : minimum 5 N/cm2 (0,5 kg/cm2)
maximum 80 N/cm2 (8 kg/cm2)
Levelling and positioning
To enable the ap­pliance to be moved with ease, it is provi­ded with two fixed wheels located at the rear of the base.
Level the appliance very carefully by adjusting the le­velling feet located at the front of the base. Then tighten the lock nuts at the top of the feet, using a spanner.
Be careful : when the machine is installed on carpeted floor, ensure that the carpet do not obstruct the openings, located at the base of the machine, which are provided for ventilation.
Cleaning the drain filter
The machine is equipped with a drain filter located at the front bottom behind a small flapdoor. This filter should be cleaned regularly as follows:
• open the flapdoor of the filter compartment
Subject to technical alterations.
by pressing it inwards with a finger at the higed side
• turn the filter knob anticlockwise and pull the filter out
• clean the filter thoroughly
• refit the filter and turn the knob clockwise.
Loading...