Please read these operating instructions through carefully.
Please make sure you read the safety instructions on the first pages of
these operating instructions! Keep the operating instructions for future
reference. Pass them on to any future owners.
With the warning triangle and/or by means of key words (Warning!,
1
Caution!, Attention!), information is emphasized which is important
for your safety or the correct functioning of the appliance. It is essential that this information is observed.
0 This symbol guides you step by step when operating the appliance.
Next to this symbol you receive additional information and practical
3
tips on using the appliance.
Tips and information about the economical and environmentally
2
friendly use of the machine are marked with the clover.
These operating instructions contain information about how to independently solve any problems which may arise. See "Troubleshooting".
If this information is not sufficient, please contact your local Customer
Service Centre. Addresses and phone numbers can be found in the separate “Guarantee Conditions/Service Departments“ (supplied with the
appliance).
In connection with this please refer to the "Service" section.
nted on environmentally friendly paper.
Whoever thinks ecologically also acts ecologically ....
The safety standards of AEG electric appliances are in keeping with the
recognised rules of technology and the law governing the safety of
appliances. Nevertheless as a manufacturer we are committed to familiarise you with the following safety instructions:
General safety
• Repairs to the washing machine may only be carried out by qualified
personnel. As a result of incorrect repairs considerable dangers for the
user may result. Please contact our customer service department or
an authorised AEG dealer in the event of repairs being necessary.
• Never start the washing machine if the mains flex is damaged or the
control panel, work top or base area are so damaged that the inside
of the washing machine is accessible.
• Switch off the washing machine before carrying out any cleaning,
care and maintenance work! You can make totally sure by pulling the
mains plug out of the socket or - if permanently connected – by
switching off the fuse switch in the fuse box or by unscrewing the
plug fuse right out.
• Multiway plugs, joints and extension cables must not be used. There is
risk of overheating!
• Never use the flex to pull the plug out of the socket but pull the
actual plug.
• Do not spray the washing machine with a water jet – danger of an
electric shock!
• During washing programs at a high temperature, the glass of the
door heats up. Do not touch!
• Allow the suds to cool down before cleaning the pump or carrying
out emergency emptying.
• Small animals can nibble at power cables and water hoses. Electric
shock hazard and danger of damages from water!
Installation, connection and initial operation
• Please follow the separate Installation and connection instructions.
• Run the first washing cycle without washing (t / Cottons 95, with
half the amount of washing powder) to remove residues on the drum
and suds container caused during production.
5
Safety instructions
• If the machine is delivered during the winter at freezing temperatures: store the washing machine for 24 hours at room temperature
before starting it.
Safety of children
• Often children are not aware of the dangers involved in handling
electrical equipment. Therefore please ensure they are adequately
supervised whilst the appliance is on and do not allow children to
play with the washing machine – there is a risk that the children may
lock themselves in the appliance.
• Packaging (e.g. plastic films, polystyrene) could be dangerous for children – danger of suffocation! Keep packaging away from children.
• Please make sure that children or small animals do not climb into the
drum of the washing machine.
• When disposing of the washing machine pull out the plug, cut off the
flex, dispose of the plug and remaining flex and destroy the door
lock. This hinders children from locking themselves in and endangering their lives.
Intended use
• Only use the washing machine to wash normal domestic washing. If
the washing machine is used for any other purpose or is incorrectly
used, the manufacturer adopts no liability for any damages which
may result.
• Conversions or changes to washing machines are not permitted due
to safety reasons.
• Only use washing powder which is suitable for washing machines.
Please follow the instructions of the washing powder manufacturers.
• The washing may not contain any flammable solvents.
Please observe this above all when washing prewashed laundry.
• Do not use your washing machine for dry cleaning.
• Dyes and bleaching agents may only be used if specifically permitted
by the manufacturer of these products. We cannot be held liable for
any damages.
• Please only use water from the mains. Only use rain or industrial
water if it meets the requirements of DIN1986 and DIN1988.
6
2 Disposal
Dispose of the packaging!
Dispose of the packaging material of your washing machine correctly.
All packaging materials are environmentally friendly and can be disposed of without any danger or burnt in the refuse incinerator.
The plastic parts can be reused:
• The external plastic cover and the bags inside are made of polyethylene (marking >PE<).
• The padding is made of CFC free expanded polystyrene
(marking >PS<).
The boxes are made from recycled paper and should be returned to the
old paper collection.
Dispose of your old washing machine!
When you eventually stop using your washing machine please bring it
to the nearest recycling centre or to your dealer who will take it back
for a small fee.
2 Environmental tips
• For normally soiled washing you do not need a prewash. In this way
you can save washing powder, water and time (and not pollute the
environment!).
• The washing machine works particularly economically if you exploit
the maximum loads.
• For small quantities of washing use half to two thirds of the recommended washing powder quantity.
• By suitable pretreatment stains and a certain amount of dirt can be
removed. Then you can wash at a low temperature.
• Wash slightly soiled to normally soiled cottons with the energy saving
program.
• Often you do not need a fabric softener. Just try it! If you use a washing machine your washing will become soft and fluffy without softener.
• For medium to high water hardness (from hardness range II, see
"Washing powder and conditioners") you should use a water softener.
The washing powder can then always be measured as for hardness
area I (= soft).
Disposal
7
The most important features of your appliance
The most important features of your
appliance
• Setting the program using the program selector, temperature selector
and type of washing buttons.
• Stain program for effectively treating stained washing.
• Energy saving program for slightly soiled to normally soiled linen.
• Maximum spin speed 1200 revolutions per minute, speed for the
final spin is automatically adapted depending on the washing program:
–t (Cottons / Linen)1200 revolutions per minute
–} (Easy Cares)1000 revolutions per minute
–Ã (Delicates)1000 revolutions per minute
–s (Woollens)1000 revolutions per minute
• Speed for the final spin can be changed to 1000, 700, or 400 revolu-
tions per minute.
• o (Rinse hold) can be added: the washing remains in the final
rinse water, it is not spun.
• Delay timer: program start can be delayed by 2, 4, 8 or 12 hours
(e.g. to times with a more economical power rate).
• Automatic load adaptation with fuzzy logic: sensor controlled
washing process, water quantity dependent on foam and load. This
ensures the best washing and rinsing results with the lowest automatically adapted water consumption.
• 4-chamber compartment for washing powder and fabric softener:
temporally delayed addition of softener, washing powder and stain
removing agent enables environmentally friendly washing and
improves the effectiveness of the detergents.
• ECO valve: ensures that the washing powder is fully exploited by
automatically closing the suds container during the wash cycle.
• Scoop ribs in the washing machine drum: ensure washing is wet fast
and equally.
• Anti-unbalance control system: for stability and smooth running.
• Extra water switch: suds cooling only or suds cooling with extra
rinse can be set.
• All-round water protection.
8
Appliance structure
Front view
Appliance structure
Door with
handle
Control panel
Drawer for detergent
and conditioner
Outer Door
Trim cover in front
of drain pump
Emergency drain hose
Height adjustable
screw feet
Rating plate
(on the rear of the door)
9
Appliance structure
Control panel
Final Spin Speed/Rinse Hold
Button
Program selector
Temperature selector
Program selector
The program selector defines the
nature of the washing cycle. The
various positions have the following
effect:
k (Pre Wash)
Cold pre wash prior to the main washing cycle which follows automatically
(not for s woollens).
Washing type
Button
Delay Timer
Button
On/Off Button
10
1 (Stains)
To treat very dirty or stained washing with stain remover (extended
main washing cycle, the stain remover is washed in at the optimal point
in the program, not for s woollens).
2(Main Wash)
Main washing cycle for normally soiled washing (wash – rinse/gentle
rinse – spin)
3 (Quick Wash)
Shortened main-wash cycle for lightly dirty washing.
Appliance structure
4 (Rinse)
Separate rinse, e.g. for rinsing hand-washed fabrics (spin according to
the selected washing cycle).
5 (Gentle Rinse)
Separate rinse, separate starch, separate conditioning (one rinse, liquid
conditioner is washed w in from the compartment).
6 (Spin)
Spin after o (Rinse Hold), or separate spinning of handwashed
fabrics.
7 (Soaking)
Separate soaking (maximum 40°C), the washing is left in the soapy
water at the end (not for swoollens).
After soaking the required main washing cycle must be set, the pro-
3
gram does automatically continue.
8 (Pump Out)
Pump out the water after a o rinse hold (without spinning).
Program selector as progress indicator
The program selector serves as a program progress indicator by rotating
in a clockwise direction to the end of the program. In the case of the
1 (Stain), 2 (Main Wash) and 3 (Quick Wash) programs, the program
selector moves to a position just after 3 (Quick Wash) immediately
after program start. The program selector then indicates the progress of
the program as usual.
Temperature selector
The following temperatures can be set on the
temperature selector:
r (cold), 30, 40, 50, 60, E, 70, 80, 95
Position E (Energy Saving Program) is suita-
2
ble for lightly to normally soiled cottons;
temperature reduced to approx. 67°C.
11
Appliance structure
Washing Type Button
The program sequence (e.g. max. possible temperature, water level, drum movement, number of
rinses, spin speed) is altered to suit the type of
washing using the washing type button.
t (Cottons/Linen)
For cottons and linen.
} (Easy-Cares)
For easy-care washing (temperature automatically
limited to a maximum of 60°C.)
à (Delicates)
For delicates (higher water level and reduced drum movement, temperature automatically limited to a maximum of 40°C).
s (Wool)
For machine-washable woollens and particularly sensitive fabrics
(higher water level and very reduced drum movement, temperature
automatically limited to a maximum of 40°C).
Final Spin Speed/o (Rinse Hold) Button
You can change the maximum speed of the final spin
using this button. When set to o (Rinse Hold) the washing is left in the last rinse water, it is not spun.
12
Delay Timer Button
You can delay the start of the washing program by 2, 4, 8,
or 12 hours using this button.
M (On/Off) Button
This button switches the washing machine on and
starts the selected program, or switches the washing
machine off.
Loading...
+ 28 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.