AEG-Electrolux EWF771 User Manual

UserManualNukeCover.qxd 04/07/2005 13:20 Page 1

EWF 771

147143501

EWF 549
EWF 551

The symbols you will see on some paragraphs of this booklet have the following meaning:

The warning triangle and/or the key words (Warning!, Caution!) emphasize information that is particularly
important for your safety or correct functioning of the appliance.

The information marked with this symbol provides additional instructions and practical tips on the use of
the appliance.

Tips and information about economical and ecological use of the machine are marked with this symbol.

Our contribution to the protection of the

environment: we use environmentally

friendly paper.

2

Dear customer,

Please read these operating instructions carefully
and pay particular attention to the safety notes
indicated in the first pages. We recommend that you
keep this instruction booklet for future reference and
pass it on to any future owners.

Washing hints 9

Sorting the laundry 9

Temperatures 9

Before loading the laundry 9

Maximum loads 9

Laundry weights 9

Removing stains 9

Detergents and additives 10

Operating sequence 11-12

International wash code symbols 13

Washing programmes 14-15

Maintenance 16

Door seal 16

Bodywork 16

Detergent dispenser drawer 16

Drain pump 16-17

Water inlet filter 17

Emergency emptying out 17

Frost precautions 17

Something not working? 18-19

Warnings 3

Disposal 4

Tips for environmental protection 4

Technical specifications 4

Installation 5

Unpacking 5

Positioning 5

Water inlet 5

Water drainage 6

Electrical connection 6

Your new washing machine 7

Description of the appliance 7

Detergent dispenser drawer 7

Use 8

Control panel 8

Controls 8

Contents

Transport damages

When unpacking the appliance, check that it is not
damaged. If in doubt, do not use it and contact the
Service Centre.

UserManualNukeEUFinal.OK.qxd 04/07/2005 12:53 Pagina 2

ENGLISH

3

Installation

• All internal packing must be removed before using
the appliance. Serious damage may be caused to
the machine or adjacent furniture if the protective
transit devices are not removed or are not
completely removed. Refer to the relevant
paragraph in the instruction book.

• Any electrical work required to install this
appliance must be carried out by a qualified
electrician.

• Any plumbing work required to install this
appliance must be carried out by a qualified
plumber.

• After having installed the machine, check that it is
not standing on its electrical supply cable.

• If the appliance is placed on a carpeted floor,
ensure that air can circulate freely between the
feet and the floor.

Use

• This appliance is designed for domestic use. It
must not be used for purposes other than those
for which it was designed.

• Only wash fabrics which are designed to be
machine washed. Follow the instructions on each
garment label.

• Do not overload the appliance. Follow the
instructions in the instruction book.

• Make sure that all pockets are empty. Objects
such as coins, safety pins, pins and screws can
cause extensive damage.

• Do not machine wash garments saturated with
petroleum, methylated spirits, trichlorethylene, etc.
If such fluids have been used to remove stains
prior to washing, wait until they have completely
evaporated from the fabric before placing
garments in the appliance.

• Place small items such as socks, belts, etc. in a
cloth bag or pillowcase to prevent them getting
trapped between the drum and the tub.

Warnings

• Use only the recommended quantities of fabric
softener. An excessive amount could damage the
laundry.

• Leave the porthole door slightly ajar when the
appliance is not in use. This preserves the door
seal and prevents the formation of musty smells.

• Always check that water has emptied out before
opening the door. If not, drain the water following
the instructions in the instruction book.

• Always unplug the appliance and shut the water
tap after use.

General safety

• Repairs to the machine must be carried out only by
qualified personnel. Repairs carried out by
inexperienced persons could cause serious
danger. Contact your local Service Centre.

• Never pull the power supply cable to remove the
plug from the socket; always take hold of the plug
itself.

• During high temperature wash programmes the
door glass may get hot. Do not touch it!

Child safety

• Children are often not aware of how dangerous
electrical appliances can be. When the machine is
working, children should be carefully supervised
and not be allowed to play with the appliance.

• The packaging components (e.g. plastic film,
polystyrene) can be dangerous to children - danger
of suffocation! Keep them out of children’s reach.

• Keep all detergents in a safe place out of children’s
reach.

• Make sure that children or pets do not climb into
the drum.

• When the appliance is to be scrapped, cut off the
electrical supply cable and destroy the plug with
the remaining cable. Disable the door catch in
order to prevent children from becoming trapped
inside while playing.

The following warnings are provided in the interests of overall safety. You must read them carefully
before installing or using the appliance.

UserManualNukeEUFinal.OK.qxd 04/07/2005 12:53 Pagina 3

ENGLISH

5

Unpacking

All transit bolts and packing must be
removed before using the appliance.

You are advised to keep all transit devices so that they
can be refitted if the machine ever has to be transported
again.

1. Using a spanner, unscrew and remove the two
rear bottom screws. Slide out the two plastic pins.
Lay the machine on its back, taking care not to
squash the hoses. This can be avoided by placing
one of the corner packing pieces between the
machine and the floor.

2. Remove the polystyrene block(s) from the bottom of
the machine and release the two plastic bags.

3. Very carefully slide out the left polythene bag,
removing it towards the right and then
downwards.

4. Very carefully slide out the right polythene bag,
removing it towards the left and then upwards.
Remove the bottom cover placed into the drum of
your appliance, lay it’s hook as the arrow ’A’
indicates and push the top of the cover to seal it
closed

Important: You can find more detailed instructions
regarding the bottom cover assembling in it’s relative
bag.

5. Set the machine upright and remove the
remaining rear screw. Slide out the relevant pin.

6. Plug all the holes with the plugs which you will
find in the envelope containing the instruction
manual.

Positioning

Install the machine on a flat hard floor.
Make sure that air circulation around the machine
is not impeded by carpets, rugs etc. Check that
the machine does not touch the wall or cupboard
units. Carefully level by screwing the adjustable
feet in or out. Never place cardboard, wood or
similar materials under the machine to
compensate for any unevenness in the floor.

Water inlet

Connect the water inlet hose to a tap with 3/4” BSP
thread.
Use the hose supplied with the washing machine.
DO NOT USE OLD HOSES.
The other end of the inlet hose which connects to the
machine can be turned in any direction. Simply
loosen the fitting, rotate the hose and retighten the
fitting, making sure there are no water leaks.

P1051

Installation

UserManualNukeEUFinal.OK.qxd 04/07/2005 12:53 Pagina 5

P0255

1

2

3

P1123

P1128

P0001

P1126

P0002

P1127

P1088

P0021

6

The inlet hose must not be lengthened. If it is too
short and you do not wish to move the tap, you will
have to purchase a new, longer hose specially
designed for this type of use.

Important!

Before connecting up the machine to new pipe work
or to pipe work that has not been used for some
time, run off a reasonable amount of water to flush
out any debris that may have collected in the pipes.

Water drainage

The end of the drain hose can be positioned in three
ways:

Hooked over the edge of a sink using the plastic
hose guide supplied with the machine. In this

case, make sure the end cannot come unhooked
when the machine is emptying.
This could be done by tying it to the tap with a piece
of string or attaching it to the wall.

In a sink drain pipe branch. This branch must be
above the trap so that the bend is at least 60 cm
above the ground.

Directly into a drain pipe at a height of not less
than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the drain pipe
must be larger than the outside diameter of the drain
hose.

The drain hose must not be kinked.

For a correct functioning of the machine the
drain hose must remain hooked on the proper
support piece situated on the top part of the back
side of the appliance.

P1118

Electrical connection

This machine is designed to operate on a 220-230 V,
single-phase, 50 Hz supply.

Check that your domestic electrical installation can
take the maximum load required (2.05 kW), also
taking into account any other appliances in use.

Connect the machine to an earth socket.

Please ensure that when the appliance is
installed the power supply cable is easily
accessible.

P0022

UserManualNukeEUFinal.OK.qxd 04/07/2005 12:53 Pagina 6

The manufacturer declines any responsibility

for damage or injury through failure to

comply with the above safety precautions.

Should the appliance power supply cable need
to be replaced, this should be carried out
by our service centre.