AEG-Electrolux EW1034W User Manual
124 970 070
Warnings ..........................Page 18
Installation .........................Page 19
Unpacking..........................Page 19
Positioning..........................Page 19
Water inlet..........................Page 19
Water drainage ........................Page 20
Electrical connection .......................Page 20
Use............................Page 21
Control panel .........................Page 21
Detergent dispenser drawer.....................Page 21
Controls ..........................Page 21
Programme selection ......................Page 22
Washing and drying hints .....................Page 23-27
Detergents and additives .....................Page 24
Drying ...........................Page 24
Washing and drying programmes ...................Page 25-26
International wash code symbols ...................Page 27
Operating sequence .......................Page 28
Maintenance .........................Page 29
Bodywork ..........................Page 29
Detergent dispenser drawer.....................Page 29
Drain filter ..........................Page 29
Water inlet filter ........................Page 29
Something not working? .....................Page 30
17
TECHNICAL SPECIFICATIONS
DIMENSIONS Height 85 cm
Width 60 cm
Depth 60 cm
POWER SUPPLY VOLTAGE/FREQUENCY 220V/60 Hz
TOTAL POWER ABSORBED 2200 W
MINIMUM FUSE PROTECTION 10 A
WATER PRESSURE Minimum 5 N/cm
2
Maximum 80 N/cm
2
Washing Drying
MAXIMUM LOAD Cotton 6.5 kg 3 kg
Synthetics 3.0 kg 2 kg
Delicate fabrics 3.0 kg Do not tumble dry
Woollens 2.0 kg Do not tumble dry
SPIN SPEED 1000 rpm
CONTENTS
18
It is important that this instruction book be kept
with the appliance for future reference. If you sell
or give the appliance away, make sure that the
book is passed to the new owners so that they
can familiarise themselves with its operation and
relevant warnings.
The following warnings are provided in the interests of overall safety. You must read them carefully before installing or using the appliance.
■
When unpacking the appliance, check that it is not
damaged. If in doubt, do not use it and contact the
Service Centre.
INSTALLATION
■
All internal packing must be removed before using
the appliance. Serious damage may be caused to
the machine or adjacent furniture if the protective
transit devices are not removed or are not completely removed. Refer to the relevant paragraph in
the instruction book.
■
Any electrical work required to install this appliance
must be carried out by a qualified electrician.
■
Any plumbing work required to install this appliance must be carried out by a qualified plumber.
■
After having installed the machine, check that it is
not standing on its electrical supply cable.
■
If the appliance is placed on a carpeted floor,
ensure that air can circulate freely between the
adjustable feet and the floor.
USE
■
This appliance is designed for domestic use. It
must not be used for purposes other than those for
which it was designed.
■
Do not overload the appliance. Follow the instructions in the instruction book.
■
Only wash and dry fabrics which are designed to
be machine washed and tumble dried. Follow the
instructions on each garment label.
■
Make sure that all pockets are empty. Objects such
as coins, safety pins, pins and screws can cause
extensive damage.
■
Do not machine wash garments saturated with
petroleum, methylated spirits, trichlorethylene, etc.
If such fluids have been used to remove stains
prior to washing, wait until they have completely
evaporated from the fabric before placing garments
in the appliance.
■
Place small items such as socks, belts, etc. in a
cloth bag or pillowcase to prevent them getting
trapped between the drum and the tub.
■
If you use a liquid detergent with a dispenser which
has to be placed directly in the drum, remember to
remove this dispenser before tumble drying.
■
Use only the recommended quantities of fabric softener. An excessive amount could damage the laundry.
■
Leave the porthole door slightly ajar when the
appliance is not in use. This preserves the door
seal and prevents the formation of musty smells.
■
Always check that water has emptied out before
opening the door. If not, drain the water following
the instructions in the instruction book.
■
Always unplug the appliance and shut the water
tap after use.
SERVICE/REPAIR
■
In the event of a fault, do not attempt to repair the
appliance yourself. Repairs carried out by inexperienced persons may cause damage.
■
If repairs are needed, contact an authorised service centre and ask for genuine spare parts.
SAFETY
■
This appliance is designed to be used by adults.
Children must not be allowed to touch the controls
or play with the product.
■
During high temperature wash cycles and drying
the glass door becomes very hot. Do not touch it.
■
Pets sometimes climb into washing machines.
Check the drum before each use.
PROTECTION OF THE ENVIRONMENT
■
Materials marked with the symbol are recyclable. To enable them to be recycled, they must
be placed in the appropriate collection areas (or
containers). Check with your local authorities.
>PE<= polyethylene
>PS<= polystyrene
>PP<=polypropylene
■
When the appliance is to be scrapped, cut off the
power supply cable and make the door closing
device inoperative to avoid it becoming a death
trap for a child.
WARNINGS
19
Unpacking
All transit bolts and packing must be removed before
using the appliance.
Proceed as follows:
Using a spanner, unscrew and remove the
rear right-hand bolt and
lay the machine on its
back, taking care not to
squash the hoses. This
can be avoided by placing one of the corner
packing pieces between
the machine and the
floor.
Remove the polystyrene blocks from the underside of
the machine and release the two plastic bags by
removing the adhesive strip.
Carefully remove the right-hand bag (1) then the lefthand bag (2) by pulling them towards the centre of the
machine.
Set the machine upright and remove the two remaining bolts from the back.
Pull out the three plastic spacers from the holes into
which the bolts were fitted.
Plug the open holes with the plugs which you will find
in the bag containing the instruction book.
Note: You are advised to keep all transit devices so
that they can be refitted if the machine ever has to be
transported again.
P0020
P0256
P0233
2
1
P0647
P0255
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that the
machine does not touch the wall or other kitchen
units.
Carefully level by screwing the adjustable feet in or
out. Never place cardboard, wood or similar materials
under the machine to compensate for any unevenness in the floor.
Water inlet
Connect the water inlet hose to a tap with a 3/4"
thread after having inserted the small filter “A” supplied with the machine.
The inlet hose must not be lengthened. If it is too short
and you do not wish to move the tap, you will have to
purchase a new, longer hose specially designed for
this type of use.
The other end of the inlet hose which connects to the
machine can be turned in any direction. Simply loosen
the fitting, rotate the hose and retighten the fitting,
making sure there are no water leaks.
P0021
A
P0003
P1051
INSTALLATION
20
Water drainage
The end of the drain hose can be positioned in three
ways:
Hooked over the edge
of a sink using the
plastic hose guide supplied with the machine.
In this case, make sure
the end cannot come
unhooked when the
machine is emptying.
This could be done by
tying it to the tap with a
piece of string or attaching it to the wall.
In a sink drain pipe branch. This branch must be
above the trap so that the bend is at least 60 cm
above the ground.
Directly into a drain pipe at a height of not less than
60 cm and not more than 90 cm.
The end of the drain hose must always be ventilated,
i.e. the inside diameter of the drain pipe must be larger than the outside diameter of the drain hose.
The drain hose must not be kinked. Run it along the
floor; only the part near the drainage point must be
raised.
P0023
P0022
Electrical connection
Before plugging the appliance into the wall socket,
make sure that:
1. the mains voltage corresponds to the voltage given
in the technical specifications;
2. the meter, fuses, mains power supply and wall
socket can all take the maximum load required.
Make sure that the socket and plug are compatible
without having to use any type of adapter. If necessary, have the domestic wiring system socket
replaced.
The electric cable must not be extended. If it is too
short and you do not wish to move the socket, replace
it completely with a longer cable.
Safety standards require the appliance to be
earthed.
The Manufacturer accepts no liability for failure to
observe the above safety precautions.
Important
If the socket in your house is not earthed, you have to
do a separate earth connection using the special
green and yellow ground wire which you can find on
the back of your appliance. This wire has to be connected to an efficient earth.
If, instead, your domestic wiring system is already
earthed, this wire must not be used and we suggest
you to simply cut it off and to throw it away.
Important
In the event of replacing the electric cable, please
contact our nearest Service Centre.
Important
The power supply cable must be easily accessible
after installing the appliance.
Loading...