AEG-Electrolux ESF65710X, ESF65710W User Manual

user manual

Dishwasher

ESF65710

2 electrolux

Electrolux. Thinking of you.

Share more of our thinking at www.electrolux.com

Contents

Safety information 2
Product description 4
Control panel 5
First use 6
Set the water softener 6
Use of dishwasher salt 7
Use of rinse aid 8
Daily use 9
Load cutlery and dishes 10
Use of detergent 13
Multitab function 14
Select and start a washing programme

Subject to change without notice

Unloading the dishwasher 16
Washing programmes 16
Care and cleaning 17
What to do if… 18
Technical data 20
Hints for test institutes 20
Installation 21
Water connection 22
Electrical connection 23
Environment concerns 23

15

Safety information

In the interest of your safety and to en­sure the correct use, before installing
and first using the appliance, read this
user manual carefully, including its hints
and warnings. To avoid unnecessary
mistakes and accidents, it is important
to ensure that all people using the appli­ance are thoroughly familiar with its op­eration and safety features. Save these
instructions and make sure that they re­main with the appliance if it is moved or
sold, so that everyone using it through
its life will be properly informed on appli­ance use and safety.

Correct use

• This dishwasher is only intended for wash­ing household utensils suitable for ma­chine washing.

• Do not put any solvents in the dishwasher.
This could cause an explosion.

• Knives and other items with sharp points
must be loaded in the cutlery basket with
their points down or placed in a horizontal
position in the upper basket.

• Only use products (detergent, salt and
rinse aid) suitable for dishwashers.

• Avoid opening the door whilst the appli­ance is in operation, hot steam may es­cape.

• Do not take any dishes out of the dish­washer before the end of the washing cy­cle.

• After use, isolate the appliance from the
power supply and turn off the water sup­ply.

• This product should be serviced only by an
authorized service engineer, and only gen­uine spare parts should be used.

• Under no circumstances should you at­tempt to repair the machine yourself. Re­pairs carried out by inexperienced persons
could cause injury or serious malfunction­ing. Contact your local Service Force Cen­tre. Always insist on genuine spare parts.

General safety

• Persons (including children) with reduced
physical sensory, mental capabilities or
lack of experience and knowledge must
not use the appliance. They must have su­pervision or instruction for the operation of
the appliance by a person responsible for
their safety.

electrolux 3

• Dishwasher detergents can cause chemi­cal burns to eyes, mouth and throat. Could
endanger life! Comply with the safety in­structions of the dishwasher detergent
manufacturer.

• Water in the dishwasher is not for drinking
purposes. Detergent residue may still be
present in your machine.

• Ensure that the door of the dishwasher is
always closed when it is not being loaded
or unloaded. In this way you will avoid any­body tripping over the open door and hurt­ing themselves.

• Do not sit or stand on the open door.

Child safety

• This appliance is designed to be operated
by adults. Children must be supervised to
ensure that they do not play with the ap­pliance.

• Keep all packaging well away from chil­dren. There is a risk of suffocation.

• Keep all detergents in a safe place out of
children’s reach.

• Keep children well away from the dish­washer when the door is open.

Installation

• Check your dishwasher for any transport
damage. Never connect a damaged ma-

chine. If your dishwasher is damaged con­tact your supplier.

• All packaging must be removed before
use.

• Any electrical and plumbing work required
to install this appliance must be carried out
by a qualified and competent person.

• For safety reasons it is dangerous to alter
the specifications or attempt to modify this
product in any way.

• Never use the dishwasher if the electrical
supply cable and water hoses are dam­aged; or if the control panel, work top or
plinth area are damaged such that the in­side of the appliance is freely accessible.
Contact your local Service Force centre, in
order to avoid hazard.

• All sides of the dishwasher must never be
drilled to prevent damage to hydraulic and
electric components.

Warning! For electrical and water
connection carefully follow the
instructions given in the specific
paragraphs.

4 electrolux

Product description

1 Upper basket
2 Water hardness dial
3 Salt container
4 Detergent dispenser
5 Rinse aid dispenser

6 Rating plate
7 Filters
8 Lower spray arm
9 Upper spray arm

10 Worktop

Control panel

1 On/Off button
2 Programme selection buttons
3 Delay start button
4 Indicator lights
5 Digital display
6 Function buttons

Programme in progress

End

Multitab function

1)

Salt

Indicator lights

Comes on when a washing programme is set and
remains on for all the duration of the washing pro­gramme.
Goes off when the washing programme has
ended.

Comes on when a washing programme has
ended. It also has added functions of visual sig­nalling as:
– the setting of the water softener,
– activation/deactivation of the rinse aid dispens-

er,

– intervention of an alarm due to the malfunction

of the machine.

Indicates the activation/deactivation of the multi­tab function ( refer to 'Multitab function' ).

Comes on when the special salt has run out.

electrolux 5

E

D

6

6 electrolux

Indicator lights

Rinse aid

1) The salt and rinse aid indicator lights are never on while a washing programme is running even if filling
with salt and/or rinse aid is necessary.

1)

The digital display

The digital display shows:

• the countdown for the delay start,

• if the appliance is in setting mode,

• if a washing programme is set.

Function buttons

The following functions can be set using
these buttons:

• setting the water softener level,

• cancelling a washing programme or a de-

lay start in progress,

Setting mode

Press the On/Off button. If ALL programme
button lights come on and the digital display
shows 3 horizontal bars, the appliance is in
setting mode.

Comes on when the rinse aid has run out.

– selecting a washing programme,
– setting the water softener level,
the appliance MUST be in setting mode.

Press the On/Off button. If a programme but­ton light comes on and the digital display
shows 1 horizontal bar, the last performed or
selected programme is still set. In this case,
to return to setting mode, the programme
has to be cancelled.

To cancel a set programme or a
programme in progress

Simultaneously press and hold the two func­tion buttons B and C until all the programme
button lights come on and the digital display
shows 3 horizontal bars. The programme
has been cancelled and the machine is now
in setting mode.

Always remember that when performing
the following operations:

First use

Before using your dishwasher for the first
time:

• Ensure that the electrical and water con-

nections comply with the installation in­structions

• Remove all packaging from inside the ap-

pliance

• Set the water softener level

• Pour 1 litre of water into the salt container
and then fill with dishwasher salt

• Fill the rinse aid dispenser

If you want to use combi detergent
tablets such as: ''3 in 1'', ''4 in 1'', ''5
in 1'' etc... set the Multitab function.
(See ''Multitab function'').

Set the water softener

The dishwasher is equipped with a water
softener designed to remove minerals and
salts from the water supply, which would
have a detrimental or adverse effect on the
operation of the appliance.
The higher the content of these minerals and
salts, the harder your water is. Water hard­ness is measured in equivalent scales, Ger­man degrees (dH°), French degrees (°TH)
and mmol/l (millimol per litre - international
unit for the hardness of water).

Water hardness Adjusting the water hardness setting Use of

°dH °TH mmol/l manually electronically

51 - 70 91 - 125 9,1 - 12,5 2 level 10 yes

The softener should be adjusted according
to the hardness of the water in your area.
Your local Water Authority can advise you on
the hardness of the water in your area.

The water softener must be set in two
ways: manually, using the water hard­ness dial and electronically.

salt

electrolux 7

Water hardness Adjusting the water hardness setting Use of

°dH °TH mmol/l manually electronically

43 - 50 76 - 90 7,6 - 9,0 2 level 9 yes

37 - 42 65 - 75 6,5 - 7,5 2 level 8 yes

29 - 36 51 - 64 5,1 - 6,4 2 level 7 yes

23 - 28 40 - 50 4,0 - 5,0 2 level 6 yes

19 - 22 33 - 39 3,3 - 3,9 2 level 5 yes

15 - 18 26 - 32 2,6 - 3,2 1 level 4 yes

11 - 14 19 - 25 1,9 - 2,5 1 level 3 yes

4 - 10 7 - 18 0,7 - 1,8 1 level 2 yes

< 4 < 7 < 0,7 1 level 1 no

3.

Setting manually

The dishwasher is factory set at position

2.

1. Open the dishwasher door.

2. Remove the lower basket from the dish­washer.

3. Turn the water hardness dial to position
1 or 2 (see chart).

4. Replace the lower basket.

Press function button A, the lights of
function buttons B and C go off while the
light of function button A continues to
flash, at the same the End indicator light
starts to flash.
The current level is indicated by the num­ber of flashes of the End indicator light.

Examples:

5 flashes, pause, 5 flashes, pause, etc. =
level 5
6 flashes, pause, 6 flashes, pause, etc. =
level 6

4. To change the level, press function but-

ton A. Each time the button is pressed
the level changes. (For the selection of the
new level see the chart).
Examples: If the current level is 5, by
pressing function button A once, level 6
is selected. if the current level is 10, by
pressing function button A once, level 1

Setting electronically

The dishwasher is factory set at level 5.

is selected.

5. To memorize the operation, switch off the
dishwasher by pressing the On/Off but­ton.

1. Press the On/Off button. The dishwasher
must be in setting mode.

2. Simultaneously press and hold function
buttons B and C, until the lights of func­tion buttons A, B and C start flashing.

salt

Use of dishwasher salt

Warning!

Only use salt specifically designed for use in
dishwashers. All other types of salt not spe­cifically designed for use in a dishwasher, es­pecially table salt, will damage the water soft­en e r. Only f i ll with s a lt just b e fore sta r ting one

of the complete washing programmes. This
will prevent any grains of salt or salty water,
which may have been spilt, remaining on the
bottom of the machine for any period of time,
which may cause corrosion.

8 electrolux

To fill:

1. Open the door, remove the lower basket
and unscrew the cap of the salt container
by turning it anticlockwise.

2. Pour 1 litre of water into the container

(this is necessary only before filling
with salt for the first time) .

3. Using the funnel provided, pour in the salt
until the container is full.

Use of rinse aid

Warning! Only use branded rinse aid for
dishwashers.
Never fill the rinse aid dispenser with any
other substances (e.g. dishwasher
cleaning agent, liquid detergent). This
would damage the appliance.

Rinse aid ensures thorough rinsing, and
spot and streak free drying.
Rinse aid is automatically added during
the last rinse.

1. Open the container by pressing the re­lease button (A).

4. Replace the cap making sure that there
is no trace of salt on the screw thread or
on the gasket.

5. Replace the cap tightly turning it clock­wise until it stops with a click.

Do not worry if water overflows from the
unit when filling with salt, this is quite
normal.

The salt indicator light on the control
panel can remain illuminated for 2-6
hours after the salt has been replen­ished, assuming the dishwasher re­mains switched on. If you are using
salt that takes longer to dissolve
then this can take longer. The oper­ation of the machine is not affected.

2. Add the rinse aid in the container. The
maximum level for filling is indicated by
"max".

The dispenser holds about 110 ml of rinse
aid, which is sufficient for between 16 and
40 washing cycles, depending upon the
dosage setting.

3. Ensure that the lid is closed after every
refill.

Clean up any rinse aid spilt during filling
with an absorbent cloth to avoid excess
foaming during the next wash.

According to the finish and drying results ob­tained, adjust the dose of rinse aid by means

electrolux 9

of the 6 position selector (position 1 minimum
dosage, position 6 maximum dosage).
The dose is factory set in position 4.
Increase the dose if there are drops of water
or lime spots on the dishes after washing.
Reduce it if there are sticky whitish streaks
on the dishes or a bluish film on glassware or
knife blades.

Daily use

• Check if it’s necessary to refill with dish-

washer salt or rinse aid.

• Load cutlery and dishes into the dishwash-

er.

• Fill with dishwasher detergent.

• Select a wash programme suitable for the

cutlery and dishes.

• Start the wash programme.

Helpful hints and tips

Sponges, household cloths and any object
that can absorb water may not be washed in
the dishwasher.

• Before loading the dishes, you should:

– Remove all left over food and debris.
– Soften remnants of burnt food in pans

• When loading the dishes and cutlery,

please note:
– Dishes and cutlery must not impede the

rotation of the spray arms.

– Load hollow items such as cups,

glasses, pans, etc. with the opening
downwards so that water cannot collect
in the container or a deep base.

– Dishes and items of cutlery must not lie

inside one another, or cover each other.

– To avoid damage to glasses, they must

not touch.

– Lay small objects in the cutlery basket.

• Plastic items and pans with non stick coat­ings have a tendency to retain water
drops; these items will not dry as well as
porcelain and steel items.

• Light items (plastic bowls etc.) must be
loaded in the upper basket and arranged
so they do not move.