25
If something does not work
During operation of the appliance some smaller but annoying trouble can 
often occur, which does not require calling a technician out. In the following 
chart information is given about them to avoid unnecessary charges on service.
We draw your attention that operation of appliance goes with certain sounds 
(compressor- and circulating sound). This is not trouble, this goes together 
with the operation of the appliance.
We draw it to your attention again that the appliance operates discontinuously, so the stopping of compressor does not mean being no-current. That 
is why you must not touch the electrical parts of the appliance before breaking the circuit.
Problem
It is too warm in the 
refrigerator.
It is too warm in the 
freezer.
Water flows at the 
back plate in the 
refrigerator.
Water flows into the 
chamber.
Water flows onto the 
floor.
There are too much 
frost and ice.
Possible cause
Thermostatic control can be set 
wrongly.
If products are not cold enough or 
placed wrongly.
The door does not close tightly or it is 
not shut properly.
Thermostatic control can be set 
wrongly.
The door does not close tightly or it is 
not shut properly.
Products in big quantity to be frozen 
were put in.
Products to be frozen are placed too 
closely to each other.
It is normal. During automatic defrosting frost melts on the back plate.
The outlet of the chamber can be 
clogged up.
Products placed in can prevent water 
from flowing into the collector.
The melting water outlet flows not 
into the evaporative tray above the 
compressor.
Products are not wrapped properly. 
Doors are not shut properly or do not
close tightly. 
The thermostatic control can be set
wrongly.
Solution
Set the thermostat knob to higher 
position.
Place the products according to the 
chapter „Storing in the refrigerator”.
Check if the door closes well and the 
gasket is unhurt and clean.
Set the thermostat knob to higher 
position.
Check if the door closes well and the 
gasket is unhurt and clean.
Wait some hours and then check the 
temperature again.
Place the products in a way so that 
cold air could circulate among them.
Clean the outlet.
Replace the products so that they can 
not touch the back plate directly.
Put the melting water outlet to the 
evaporative tray.
Wrap the products better. 
Check if the doors close well and the
gaskets are unhurt and clean. 
Set the thermostat knob to a position
that gives higher temperature.