AEG-Electrolux 61502G-M User Manual
61502G
Gas hob
Operating Instructions
GB
IE
Important Safety Information
You MUST read these warnings carefully before installing or using the hob. If you need
assistance, contact our Customer Care Department on 08705 350350
Installation
This appliance must be installed and serviced by a competent person as stated in
the Gas Safety ( Installation and Use) Regulations Current Editions and the IEE
Wiring Regulations.
For appliances installed in the Republic of Ireland please refer to NSAI-Domestic
Gas Installations I.S.813 Current Editions and the ETCI Rules for Electrical
Installations.
Remove all packaging before using the hob.
Ensure that the gas and electrical supply complies with the type stated on the rating
plate, located near the gas supply pipe.
Do not attempt to modify the hob in any way.
Child Safety
This hob is designed to be operated by adults. Do not allow children to play near or
with the hob.
The hob gets hot when it is in use. Children should be kept away until it has cooled.
Children can also injure themselves by pulling pans or pots off the hob.
During Use
This hob is intended for domestic cooking only. It is not designed for commercial or
This appliance is not connected to a combustion products evacuation device. It must
When in use a gas cooking hob will produce heat and moisture in the room in which
When using the hob for a long period time, the ventilation should be improved, by
2
industrial purposes.
be installed and connected in accordance with current installation regulations. Particular
attention shall be given to the relevant requirements regarding ventilation.
it has been installed. Ensure there is a continuous air supply, keeping air vents in
good condition or installing a cooker hood with a venting hose.
opening a window or increasing the extractor speed.
Do not use this hob if it is in contact with water. Do not operate the hob with wet hands.
Ensure the control knobs are in the ‘OFF’ position when not in use.
When using other electrical appliances, ensure the cable does not come into contact
with the hot surfaces of the cooking appliance.
Unstable or misshapen pans should not be used on the hob as unstable pans can
cause an accident by tipping or spillage.
Never leave the hob unattended when cooking with oil and fats.
Never use plastic or aluminium foil dishes on the hob.
Perishable food, plastic items and areosols may be affected by heat and should not
be stored above or below the hob unit.
Service
This hob should only be repaired or serviced by an authorised Service Engineer and
only genuine approved spare parts should be used.
Environmental Information
After installation, please dispose of the packaging with due regard to safety and the
environment.
When disposing of an old appliance, make it unusable, by cutting off the cable.
The symbol on the product or on its packaging indicates that this product may
not be treated as household waste. Instead it shall be handed over to the applicable
collection point for the recycling of electrical and electronic equipment. By ensuring
this product is disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which could otherwise be
caused by inappropriate waste handling of this product. For more detailed information
about recycling of this product, please contact your local city office, your household
waste disposal service or the shop where you purchased the product.
Keep this instruction book for future reference and ensure it is passed on to
any new owner.
These instructions are only valid for countries whose identification symbols are shown on
the cover of this instruction booklet and on the appliance itself.
3
Contents
Important Safety Information ........................................................................................... 2
Instructions for the User .................................................................................................. 5
Description of the Hob ......................................................................................................... 5
Operation ........................................................................................................................... 6
Maintenance and Cleaning .................................................................................................. 8
The Hob Top........................................................................................................... 8
Pan Supports ......................................................................................................... 8
The Burners ........................................................................................................... 8
The Ignition Electrode .............................................................................................. 8
Something Not Working? .................................................................................................... 9
Service and Spare Parts .................................................................................................. 10
Guarantee Conditions ........................................................................................................ 11
Instructions for the Installer .......................................................................................... 12
Engineer technical data ..................................................................................................... 12
Important safety requirements ........................................................................................... 14
Location ............................................................................................................................ 14
Installation ......................................................................................................................... 15
Gas Connection .................................................................................................... 16
Cut Out Size ......................................................................................................... 17
Building In ............................................................................................................. 17
Building over a cupboard or drawer ................................................................. 17
Building over a kitchen unit with door ................................................................ 18
Fitting the hob to the worktop ............................................................................ 19
Electrical connections ....................................................................................................... 20
Permanent Connection .......................................................................................... 21
Wiring diagram ..................................................................................................... 21
Fault Finding ..................................................................................................................... 22
Preliminary Electrical Systems Check .................................................................. 22
Ignition System / Gas Ignition ................................................................................. 24
Commissioning ................................................................................................................ 25
Pressure Testing .................................................................................................. 25
Conversion from Natural Gas to LPG ................................................................................ 26
Guide to Use the instructions
The following symbols will be found in the text to guide you throughout the Instructions:
Safety Instructions
Step by step instructions for an
4
operation
Hints and Tips
Environmental information
Description of the Hob
3
1
2
4
1. Hob Top
2. Rapid Burner
3. Semi-rapid Burners
4. Auxiliary Burner
5. Control knob for back right burner (semi-rapid)
6. Control knob for back left burner (semi-rapid)
7. Control knob for front left burner (rapid)
8. Control knob for front right burner (auxiliary)
3
5
6
7
8
INSTALLATION
Any gas installation must be carried out by a registered competent person, and in
accordance with existing rules and regulations.
The relevant instructions are to be found in the second section of this manual.
Please, ensure that, once the hob is installed, it is easily accessible for the engineer
in the event of a breakdown.
WHEN THE HOB IS FIRST INSTALLED
Once the hob has been installed, it is important to remove any protective materials, which
were put on in the factory.
5
Operation
Hob burners control knobs
The symbols on the knobs mean that :
there is no gas supply
there is maximum gas supply
there is minimum gas supply
Lighting the burners
For easier lighting, proceed before putting a pan on the pan support.
To light a burner:
turn the relevant knob anticlockwise to maximum
position (
Upon ignition, keep the knob pushed down about 5
seconds. This will allow the "thermocouple" (Fig.
1 - letter D) to be heated and the safety device to be
switched off, otherwise the gas supply would be
interrupted.
Then adjust the flame as required.
If the burner does not ignite, turn the control knob to
zero, and try again.
When switching on the mains, after installation or a
power cut, it is quite normal for the spark generator
to be activated automatically.
In the absence of electricity, ignition can occur without
the electrical device; in this case, approach the
burner with a flame, push the relevant knob down
and turn it anti-clockwise until it reaches the
“maximum” position.
To ensure maximum burner efficiency, you should only use pots and pans with a flat
bottom fitting the size of the burner used (see table).
).
A - Burner cap
B - Burner crown
C - Ignition electrode
D - Thermocouple
Fig. 1
6
Burner minimum maximum
diameter diameter
Large (rapid) 160 mm 240 mm
Medium (semi-rapid) 120 mm 220 mm
Small (auxiliary) 80 mm 160 mm
As soon as a liquid starts boiling, turn down the flame so that it will barely keep the liquid
simmering.
If you use a saucepan which is smaller than the recommended size, the flame will
spread beyond the bottom of the vessel, causing the handle to overheat.
Take care when frying food in hot oil or fat, as the overheated splashes could easily
ignite.
If the control knobs become difficult to turn, please contact your local Service Force
Centre.
7
Maintenance and Cleaning
Before any maintenance or cleaning can be carried out, you must DISCONNECT the
hob from the electricity supply.
The hob is best cleaned whilst it is still warm, as spillage can be removed more easily
than if it is left to cool.
The Hob Top
Regularly wipe over the hob top using a soft cloth well wrung out in warm water to which
a little wasing up liquid has been added. Avoid the use of the following:
- household detergent and bleaches;
- impregnated pads unsuitable for non-stick saucepans;
- steel wool pads;
- bath/sink stain removers.
Should the hob top become heavily soiled, the following products are recommended:
- For stainless steel hobs use a proprietary stainless steel cleaner.
- For other hobs use Hob Brite or Bar Keepers Friend.
Pan Supports
The pan supports are dishwasher proof. If washing them by hand, take care when drying
them as the enamelling process occasionally leaves rough edges. If necessay, remove
stubborn stains using a paste cleaner.
The Burners
The burner caps and crowns can be removed for cleaning.
Wash the burners caps and crowns using hot soapy water, and remove marks with a
mild paste cleaner. A well moistened soap impregnated steel wool pad can be used with
caution, if the marks are particularly difficult to remove.
After cleaning, be sure to wipe dry with a soft cloth.
The Ignition electrode
The electric ignition is obtained through a ceramic electrode and a metal electrode (Fig.
1 - C). Keep these components very clean, to avoid difficult lighting, and check that the
burner crown holes (Fig. 1 - B) are not obstructed.
8
Something Not Working?
If the hob is not working correctly, please carry out the following checks before contacting your
local Service Force Centre.
SYMPTOM
There is no spark when lighting the
gas
SOLUTION
Check that the unit is plugged in and
the electrical supply is switched on
Check that the RCCB has not tripped
(if fitted)
Check the mains fuse has not blown
Check the burner cap and crown
have been replaced correctly, e.g.
after cleaning.
The gas ring burns unevenly
Check the main jet is not blocked
and the burner crown is clear of food
particles.
Check the burner cap and crown
have been replaced correctly, e.g.
after cleaning.
If after all these checks, your hob still does not operate correctly, contact your local Service Force
Centre.
Please note that it will be necessary to provide proof of purchase for any in-guarantee service
calls.
In-guarantee customers should ensure that the above checks have been made as the engineer
will make a charge if the fault is not a mechanical or electrical breakdown.
9
Loading...