AEG-Electrolux 24968G-M, 24658G-M User Manual

USE, INSTALLATION AND

MAINTENANCE INSTRUCTIONS

FOR BUILT-IN HOT PLATES

The manufacturer is not responsible for any transcription errors or misprints contained in this handbook and,
furthermore, reserves the right to make any modification on the products, which might be deemed necessary
or useful, this being also in the user’s interest, without altering their basic operating or safety features.

COD. 115800AEG680 - 03.10.2003

Dear User,
We are sincerely grateful to you for purchasing one of our products. This
appliance has been designed to meet all the modern requirements and is
manufactured from the finest materials and components.
We would ask you to read the instructions within this booklet very carefully so
as to enable you to obtain quality results from the outset.
The design of the figures contained in this handbook is purely indicative.

THE APPLIANCE MUST BE INSTALLED ONLY BY AUTHORISED
PERSONNEL IN COMPLIANCE WITH THE INSTRUCTIONS PROVIDED.
THE MANUFACTUTER DECLINES ALL RESPONSIBILITY FOR IMPROPER
INSTALLATION WHICH MAY HARM PERSONS AND ANIMALS AND
DAMAGE PROPERTY.
THE APPLIANCE MUST BE USED FOR THE PURPOSE FOR WHICH IT
WAS EXPRESSLY DESIGNED. ANY OTHER USE (e.g. HEATING ROOMS)
IS CONSIDERED TO BE IMPROPER AND CONSEQUENTLY DANGEROUS.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR DAMAGE
RESULTING FROM IMPROPER AND IRRESPONSIBLE USE.

2

DESCRIPTION OF THE HOT PLATES

1) Large burner (Left front) of 11.2 MJ (3100 W)

2) Medium burner (Right rear) of 10.2 MJ (2950 W)

3) Small burner (Left rear) of 4.9 MJ (1450 W)

4) Auxiliar burner (Right front) of 4.0 MJ (1050 W)

5) Fish burner (Center) of 9.2 MJ (2600 W)

6) Ultra rapid burner (Left front) of 14.0 MJ (4000 W)

14) Right trivet

15) Center trivet

16) Left trivet

17) Trivet for ultra rapid burner

18) Eletric ignition push-button

19) Burner control knob n° 4

20) Burner control knob n° 1

21) Burner control knob n° 6

22) Burner control knob n° 5

23) Burner control knob n° 3

24) Burner control knob n° 2

24658 G-m

24968 G-m

3

1) BURNERS

Ensure that all gas supply connections are correct
and that supply valves are open.
The burner controls are engraved graphically to
indicate their associated burner and setting.

- MANUAL IGNITION (FIG. 1)

Select desired hotplate burner, depress control
knob and gently turn anti-clockwise to “Full on”
position whilst applying a lighted match to the
burner. After the flame has established, adjust
burner to desired setting.

- ELECTRIC IGNITION (FIG. 1)

Select desired burner, depress control knob and
gently turn anti-clockwise to “Full on” position whilst
depressing the electronic ignition switch (E) until
flame has established.
After the flame has established, select the required
setting.

- AUTOMATIC ELECTRICAL IGNITION (FIG. 1)

Select desired burner, turn the control knob anti­clockwise to “Full on” position, then depress it. After
the flame has established, adjust burner to desired
setting.

- SWITCHING ON BURNERS EQUIPPED WITH

FLAME FAILURE DEVICE (FIG. 1)

The knobs of burners equipped with flame failure
device must be turned in an anticlockwise direction
until they reach the “Full on” position (large flame
fig. 1) and come to a stop. Now depress the knob in
question and repeat the previously indicated
operations. Keep the knob depressed for about 10
seconds once the burner has ignited.

NOTE:
WHEN THE CONTROL OF THE DOUBLE RING
BURNER IS SET TO MINIMUM THE OUTER
FLAME ONLY REMAINS ALIGHT.

HOW TO USE THE BURNER HOTPLATES

In order to maximize the efficiency of the burners
the following pan sizes are recommended:

BURNER PAN DIAMETER

Wok burner 22 - 24
Large burner 20 - 22
Medium burner 20 - 22
Small burner 16 - 18
Auxiliary burner 10 - 14
Fish burne (WIDTH) 12 - 20

(LENGTH) 30 - 40

Suggestions:

- When boiling point is reached, it is beneficial to
turn the control knob to the “LOW” setting.

- When possible, use pans with correctly fitting lids.

- Always use pans of the correct diameter (Fig. 2).

USE

FIG. 1 FIG. 2

4

USE

WARNING - SAFETY:

- BURNERS WITH FLAME FAILURE DEVICE
MAY ONLY BE IGNITED WHEN THE RELATIVE
KNOB HAS BEEN SET TO THE FULL ON
POSITION (LARGE FLAME FIG.1).

- NEVER ALLOW CHILDREN TO PLAY NEAR
THE APPLIANCE WHEN USING THE
BURNERS. CHECK THAT THE PAN HANDLES
ARE POSITIONED CORRECTLY.

- DO NOT SPRAY AEROSOLS IN THE VICINITY
OF THE HOTPLATES WHILE THE APPLIANCE
IS IN USE.

- FOR SAFETY ENSURE THAT NO FLAMMABLE
OR THERMALLY DEFORMABLE OBJECTS
ARE PLACED DIRECTLY BELOW THE HOB.

- WHERE THIS APPLIANCE IS INSTALLED IN A
MARINE CRAFT OR A CARAVAN, IT SHALL
NOT BE USED AS A SPACE HEATER.

- FOR MAXIMUM STABILITY ALWAYS USE A
ROUND BOTTOM WOK.

- IF GAS BURNS WITH A YELLOW FLAME, DO
NOT CONTINUE TO USE BURNER AND
ARRANGE FOR SERVICE.

- OBSERVE SAFE CLEARANCES AROUND
APPLIANCE.

- LOCATE PAN CENTRALLY OVER THE
BURNER SO THAT IS STABLE AND DOES
NOT OVERHANG THE APPLIANCE (FIG. 3).

- USE ONLY A WOK SUPPORT SUPPLIED OR
RECOMMENDED BY THE MANUFACTURER
OF THE APPLIANCE (FIG. 4).

- THE APPLIANCE IS NOT INTENDED FOR USE
BY YOUNG CHILDREN OR INFIRM PERSONS
WITHOUT SUPERVISION.

- YOUNG CHILDREN SHOULD BE SUPERVISED
TO ENSURE THAT THEY DO NOT PLAY WITH
THE APPLIANCE.

- DO NOT STORE OR USE GASOLINE OR
OTHER FLAMMABLE VAPOURS, LIQUIDS OR
ITEMS IN THE VICINITY OF THIS OR ANY
OTHER APPLIANCE.

In the event of bad working of the hob, (there
are no mentions on the instruction book) the
user must apply to the servicing “AEG”
imparting both the “ENR” and “FNR” numbers
stamped on the data label put on the bottom of
the hob.
The above numbers give the technician the
possibility to find the proper spare parts with a
consequent timely assistance. For an easy
finding, we suggest to write the above “ENR”
and “FNR” numbers on the beneath blanks.

ENR: .......................................................................

FNR: .......................................................................

FIG. 3 FIG. 4