AEG Z5106, Z5116B, Z5116 User Manual

5106 • 5116 • 5116B
4802 02 01 05
Electrolux Group Floorcare Helpline
08706 055 055
5106 • 5116 • 5116B
GUARANTEE
This guarantee is in addition to your statutory and other legal rights.
There are certain conditions which may invalidate this guarantee:
a. It is dependent upon the appliance being correctly installed and used in accordance
with the Company's instructions under normal domestic conditions within the United Kingdom or the Republic of Ireland.
b. Service at all times must be carried out by an Electrolux Service Representative or
authorised agent.
c. The guarantee may be invalidated by unauthorised repair or modification of the
appliance.
d. You may be charged by the Electrolux Group if you call for an engineer to resolve a
problem that we believe is covered in the instruction booklet.
The Company does not accept liability for defects arising from neglect, misuse or acci­dent. This guarantee excludes such normal wearing parts as filters, brushes and dust­bags as the life of these depends upon the amount and nature of use.
Proof of the date of purchase will be required before service under guarantee is pro­vided.
For futher assistance call the
Electrolux Group Floorcare Helpline on 08706 055 055.
Important:
For future reference we suggest you record the following details here, and keep the receipt with this booklet as proof or purchase.
Purchased from: ____________________________________________________
Date purchased _______________Model No _____________________________
Before you start …check the voltage
Before connecting the cleaner to an electrical supply ensure that voltage marked on the data plate (on the underside of cleaner) is correct for your electrical sup­ply. If is not, do not use the cleaner but refer back to your dealer.
Connecting to your electrical supply
Permanently connected to the cleaner is a mains sup­ply (2-core) cable fitted with a non-rewirable plug incorporating a 13A fuse. In the event of the fuse requiring replacement the fuse cover should be removed using a small screwdriver. The old fuse MUST be replaced by a 13AASTA approved BS1362 fuse and the fuse cover must be replaced before the plus is used again. In the event of loss of the fuse cover, replacements can be obtained from your Electrolux dealer or Electricity Board and must be of the same colour as indicated by the coloured insert on the base plug. If difficulty is experienced in obtaining a replacement, contact your nearest Electrolux Service Centre. (Please see the separate Electrolux Service Organisation leaflet).
In no circumstances must the plug be used with­out a correct fuse cover fitted.
If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appro­priate plug fitted. Remove the fuse from the cut-off plug. The cut-off plug should then be disposed off to prevent hazard of shocks in case it should be plugged into a 13 Amp socket in another part of your home.
The wires in the mains cable of this appliance are coloured in accordance with the following code: Blue: Neutral. Brown: Live.
As the colours of the wires in the mains cable of this appliance may not correspond with the coloured markings identifying the terminals in your plug, pro­ceed as follows:
The wire which is coloured blue must be connected to the terminal which marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked the letter L or coloured red.
If using a three-pin plug, do not make any connection to the terminal marked with the letter E or by the earth symbol or coloured green or green-and-yellow. This cleaner is double insulated and no earth-con­nection is necessary.]
It is in you interest to ensure that the plug is correctly attached to the mains cable. In case of doubt, have it done by a qualified electrician, as Electrolux cannot regard the repair of faults on the plug connection as a service that can be given free of charge under the terms of guarantee.
As a general guide to fitting any plug
• Ensure the lengths of wire inside the plug are pre­pared correctly.
• Connection should be firmly made after all conduc­tor stands are entered into the terminal posts.
• When preparing the cable ends take care not to damage the outer seal, or the insulation surrounding the inner conductors.
• Tighten all screws.
• Replace the top cover of the plug and secure.
When using an electrical appliance, basic precautions should always be followed,
including the following:
READ ALL THE INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER.
WARNING
To reduce the risk of fire, electric shock, or injury:
• Do not use outdoors or on wet surfaces.
• Do not leave vacuum cleaner when plugged in.
• Do not allow to be used as a toy. Close attention is necessary when used near children. Do not allow children to operate this appliance.
• Use only as described in this manual. Use only manufacturer's recommended attachments.
• Do not use with damaged cord or plug. If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service centre before using.
• Do not pull or carry by cord, use cord as a handle, close door on cord. Keep cord away from heated surfaces.
• Do not use extension cords or outlets with inadequate current carrying capacity.
• Turn off all controls before unplugging.
• Do not unplug by pulling on cord. To unplug, grasp the plug instead of the cord.
• Do not handle plug or vacuum cleaner with wet hands.
• Do not put any object into openings. Do not use with any opening block, keep free of dust, lint, hair and anything that may reduce air flow.
• Do not use to pick up anything that is burning or smoking, such as cigarettes, matches or hot ashes.
• Do not use without dustbag in place.
• Use extra care when cleaning on stairs.
• Do not use to pick up flammable or combustible liquids such as gasoline, or use in areas where they may be present.
• Store your cleaner indoors in a cool, dry area.
• Keep your work area well-lighted.
• Unplug electrical appliances before vacuuming them.
SAVE THESE INSTRUCTIONS
5106 • 5116 • 5116B5106 • 5116 • 5116B5106 • 5116 • 5116B
The Electrolux Group, 101 Oakley Road, LUTON, BEDFORDSHIRE, LU4 9QQ
Features of the
Electrolux
vacuum cleaner and accessories with it are protected in Great
Britain and abroad by Patents of Registered Designs.
This appliance conforms with the requirements of the amended E.E.C. directive No. 89/336/EEC relating to electromagnetic compatibility (EMC) CE.
The Electrolux Group may introduce modifications to their product from time to time, and consequently the details given in this booklet are subject to alteretion without notice.
ELECTRICAL SUPPLY INSTRUCTIONS
Loading...
+ 2 hidden pages