AEG Z4390 User Manual
Upright Vacuum Cleaner
Household Type
Owner’s Guide
Model B4390 Series
Index
Important User Information.......... 2
Service Information ..................... 4
Guarantee ................................... 4
Assembly.................................. 5-6
Thermal Cut-Off ....................3 & 7
Use .............................................. 7
Accessories ................................. 8
Hose Blockage ....................... 9-10
Brush Roll.................................. 11
Brush Roll Belt ........................... 11
Dust Bag/Cyclonic Cassette...... 12
Filters......................................... 13
Problem Solving ........................ 14
IMPORTANT
For any advice
on your cleaner and
to order dust bags,
filters and
accessories
please telephone
the Electrolux Group
Floorcare helpline
08706 055055
IMPORTANT SAFEGUARDS
When using an electrical appliance, basic precautions should always be f ollow ed, including the follo wing:
READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER.
WARNING
To reduce the risk of fire, electric shock, or injury:
• Do not use outdoors or on wet surfaces.
• Do not leave vacuum cleaner when plug ged in. Turn off the switch and unplug the electrical cord when not in use and
before servicing.
• Do not allow to be used as a toy. Close attention is necessary when used by or near children.
• Use only as described in this manual. Use only manuf acturer’s recommended attachments.
• Do not use with damaged cord or plug. If vacuum cleaner is not working as it should, has been dropped, damaged, left
outdoors, or dropped into water , return it to a service centre before using.
• Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not
run vacuum cleaner over cord. Keep cord away from heated surfaces.
• Do not use extension cords or outlets with inadequate current carrying capacity.
• Turn off all controls before unplugging.
• Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
• Do not handle plug or vacuum cleaner with wet hands.
• Do not put any object into openings. Do not use with any opening bloc ked; keep free of dust, lint, hair, and an ything that may
reduce airflow .
• This vacuum cleaner creates suction and contains a rev olving brush roll. Keep hair , loose clothing, fingers, and all parts of
body away from openings and moving parts.
• Do not place cleaner on furniture or stairs as the brush roll may cause damage. Place cleaner on floor with the handle in
storage position while using attachments.
• Do not pick up anything that is burning or smoking, such as cigarettes, matches , or hot ashes .
• Do not use without the dust bag or filter(s) in place.
• Belt pulleys can become hot during normal use. To prevent burns, av oid touching the belt pulley when servicing the drive
belt.
• Use extra care when cleaning on stairs.
• Do not use to pick up flammable or combustib le liquids such as gasoline , or use in areas where the y may be present.
• Store your cleaner indoors in a cool, dry area.
• Keep your w ork area well lighted.
• Unplug electrical appliances before vacuuming them.
SA VE THESE INSTRUCTIONS
2
BEFORE Y OU ST ART
CHECK THE VOLTAGE
First check the voltage shown on the data plate (see rear view) to make sure that the cleaner is of the correct voltage for your electricity
supply. If it is not, do not use the cleaner but refer back to your dealer.
CONNECTING TO YOUR ELECTRICITY SUPPLY
Permanently connected to the cleaner is a mains supply (2-core) cable fitted with a non-rewirable plug incorporating a 13A fuse.
In the event of the fuse requiring replacement the fuse cover should be removed using a small screwdriver. The old fuse MUST be replaced
by a 13A ASTA approved BS1362 fuse or a BSI approved fuse. The cover must be replaced before the plug is used again. In the event
of loss of the fuse cover, replacements can be obtained from your Electrolux Group dealers and must be of the same colour as indicated
by the coloured insert on the base of the plug.
If difficulty is experienced in obtaining a replacement, contact the Electrolux Group Floorcare helpline on 08706 055055.
In no circumstances must the plug be used without a correct fuse cover fitted.
If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fitted.
Remove the fuse from the cut off plug.
The cut off plug should then be disposed of to prevent the hazard of shocks in case it should be plugged into a 13 amp socket in another
part of your home.
The wires in the mains cable of this appliance are coloured in accordance with the following code: Blue: Neutral. Brown: Live.
As the colours of the wires in the mains cable of this appliance may not correspond with the coloured markings identifying the terminals
in your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.
If using a three-pin plug, do not make any connection to the terminal marked with the letter E or by the earth symbol or coloured green
or green-and-yellow. This cleaner is double insulated and no earth connection is necessary.
It is in your interest to ensure that the plug is correctly attached to the mains cable. In case of doubt, have it done by a qualified electrician,
as the Electrolux Group cannot regard the repair of faults on the plug connection as a service that can be given free of charge under
the terms of the guarantee.
Fuse
13 Amp Fuse
Cover
Fuse
Blue
Brown
Cord
Clamp
WARNING
The brush in the cleaning head rotates at high speed and can cause damage to the mains supply cable if the cleaner passes
over it during cleaning operations.
Care should be taken to ensure that this does not happen. If the cleaning head has accidentally passed over the mains supply cable the
following action should be taken:
1. Switch off and remove the plug from the socket outlet.
2. Examine the mains supply cable for damage (only after removing the plug from the socket outlet).
3. If there is any sign of damage to the supply cable it MUST be renewed. The repair MUST be carried out by an Electrolux Group Service
Agent or a similar qualified person.
4. NEVER use the machine with a damaged mains supply cable.
Proprietary carpet conditioning and air freshening materials
After using proprietary carpet conditioning powders, it is recommended that the dust bag or filters be changed. Some of these preparations
contain substances which if left in the vacuum cleaner for e xtended periods could damage the plastic mouldings which f orm the structure
of the cleaner.
Many air fresheners, household deodorants, sprays and polishes contain a highly flammable gas propellant.
Because of this, it is particularly important that these products are used strictly in accordance with the relevant manu facturer’ s instructions.
It is essential that none of the above products are sprayed directly into the vacuum cleaner or any of its filters, hose assembly, dust bag
chamber or dust cup.
Thermal Cut Off
This vacuum cleaner has a special thermostat that protects the cleaner in case of motor overheating. If the cleaner suddenly shuts off , push the
switch pedal once and unplug the cleaner . Check the cleaner f or a possib le source of ov erheating such as a full bag, a bloc ked hose or clogged
filter. If these conditions are found, fix them and wait at least 60 minutes before attempting to use the cleaner. After the 60 minute period, plug
the cleaner back in and turn on the switch. If the cleaner still does not run, please call Electrolux Group Floorcare helpline on 08706 055055.
3
SERVICE
Should you require service on your Boss cleaner, please telephone Electrolux Group Floorcare helpline on 08706 055055. Before
requesting service, please check whether your problem is covered under Service Checklist (see below).
New filter pads, dust bags, brush rollers and drive belts can be obtained from authorised Electrolux Group dealers. If difficulty is experienced
in obtaining spares, please contact Electrolux Group Floorcare helpline on 08706 055055.
SERVICE CHECKLIST
• If your cleaner will not operate, check the plug connection, plug fuse and mains fuse.
• Never allow the dust bag to become so full that it impedes the air-flow, thus reducing the cleaning efficiency of the machine. The
character of household dust and its effect on the air-flow through the machine may vary considerably. Fluffy dust allows air to pass
through readily whereas fine powdery dust or proprietary cleaning powders, pack tightly in the dust bag, offering greater resistance
to air-flow and will reduce cleaning efficiency if the bag becomes overloaded.
• Always store your cleaner and spare dust bags/filters in a dry place.
• To maintain maximum suction, wash filters at least once a month or more if required and replace if necessary.
• Sucking up such items as stockings, clippings of cloth, sizeable pieces of paper, wrappings from cigarette packets or sweets etc.,
may block the hose. The Electrolux Group regrets that the clearing of blocked hoses cannot be regarded as service that can
be given free of charge, under the guarantee. Should a blockage occur, first disconnect the cleaner from the electricity supply,
refer to section headed “Blockages”. If these operations are not successful, contact us on 08706 055055.
• Never pick up hot cinders or lighted cigarette ends.
• Make certain that your cleaner does not come into contact with water or any other liquid. It is not designed as a wet pick
up cleaner, and must never be used on damp carpets or wet floors.
Important - in the event of the mains supply cable of this vacuum cleaner requiring replacement, we recommend that this be carried
out by Electrolux Group Service Staff.
Guarantee
This guarantee is in addition to your statutory and other legal rights.
This product is for household use only.
Electrolux Group products are carefully designed, manufactured, tested and inspected and, in consequence, we undertake
to replace or repair any part found to be defective in material or workmanship, within one year of delivery to the original
purchaser, free of charge. You may be required to take the product to your nearest service provider if the product requires
attention during the first year.
There are certain conditions which may invalidate this guarantee:
a. It is dependent upon the appliance being correctly installed and used in accordance with the Company’s instructions
under normal domestic conditions within the United Kingdom or the Republic of Ireland.
b. Service at all times must be carried out by an Electrolux Group Service Representative or authorised agent.
c. The guarantee may be invalidated by unauthorised repair or modification of the appliance.
d. You may be charged by the Electrolux Group if you call for an engineer to resolve a problem that we believe is covered
in the instruction booklet. (example: blocked/dirty filters)
The Company does not accept liability for defects arising from neglect, misuse or accident. This guarantee excludes such
normal wearing parts as drive belts, brushes, filters and dust bags as the life of these depends upon the amount and nature
of use.
Proof of the date of purchase will be required before service under guarantee is provided. Please call the Electrolux Group
Floorcare helpline on 08706 055055 for assistance.
Important:
For future reference we suggest you record the following details here, and keep the receipt with the handbook as proof of
purchase.
Purchased from_____________________________________________
Date purchased______________ Model no ______________________
4
HOW TO ASSEMBLE
CAUTION: Assemble the cleaner before using.
NOTE: Features may vary by model yet all parts assemble the same.
Step A Attach Hose
IMPORTANT:
Hose
MUST BE
inserted
before attaching
the handle.
Notch
2
Step B Attach Handle
CAUTION: Do not catch cord under handle.
Tab
1
Ledge
3
Groove
Hose
Adapter
Tab
4
1. Locate the tab on the hose adapter of the extension hose
(shortest end).
2. Insert hose adapter into opening on top of unit. The hose
adapter tab must be placed all the way down into
the notch.
Groove
3. From rear of cleaner, align handle with groove and
slide onto cleaner. If necessary , use thumb and finger
pressure to slide handle into position.
4. Once handle is in place, check that the hose adapter
tab is completely secure under the ledge of the
handle.
5. Attach handle with two 5/8 inch screws in the
assembly packet. Use either a slotted or Phillips
head screwdriver .
®
5
Loading...