AEG EK9714X, EK6714X, EK9710, EK9711, EK9715X User Manual

...
Gas and mixed fuel cookers
INSTRUCTION BOOKLET
35674-7602
Mod. EK 6714 - 6735 - 9710 - 9711 - 9714 - 9715 - 9735
ENGLISH
Important Safety Information
It is very important that this instruction book should be kept safely for future consultation. If the appliance should be sold or given to another person, please ensure that the booklet goes together with it, so that the new owner can know of the functions of the machine and also be aware of the warnings.This warnings has been given for the safety of you and others. We therefore ask you to carefully read the procedures of installing and using this cooker.
Installation
The work of installation must be carried out by
Any modifications to the domestic electrical mains
which may be necessary for the installation of the appliance should be carried out only by competent personnel.
It is dangerous to modify, or attempt to modify, the
characteristics of this appliance.
Avoid installation of the cooker near inflammable
material (e.g. curtains, tea towels, etc.).
Child Safety
This appliance has been designed for use by adults.
Take care, therefore, that children do not attempt to play with it.
The appliance remains hot for a long time after being
switched off. Supervise children at all times, paying attention that they do not touch surfaces or remain in the vicinity of the appliance when in use or when not completely cooled.
During Use
This product is intended for the cooking of food and
must not be used for other purposes.
During cooking on the grill or in the oven, the unit is kept at a high temperature in relation to the plate glass door and adjacent parts. Take care therefore, that children do not play near it. When connecting household appliances to a plug near the unit, ensure that they are kept away from the flame and the oven door.
During the first minutes of use, the thermal insulation
of the oven, and residual grease from manufacture, pro­duce smoke and disagreeable smells. On first use, we advise heating the oven, empty, for approximately 45 minutes. Then leave to cool and clean the inside of the oven with hot water and a mild detergent.
Unstable or deformed pans should not be placed on the
burners or plates in order to avoid accidents caused by upsetting or boiling over.
Particular care should be taken when cooking with oil
or fat.
If the appliance is fitted with a cover, its function is to
protect the surface from dust when closed and to accu­mulate splashes of grease when open.Do not use for
other purposes.
Always clean the cover before closing.  Leave the burners and/or plates to cool before closing.  All the covers, in plate glass or enamel, are removable
to facilitate cleaning.
Always ensure that the knobs are in the «
position when the appliance is not in use.
Always insert the dripping pan when using the grill or
when cooking meat on the grid. Pour a little water into the dripping pan to avoid grease burning and creating unpleasant smells.
» (Stop)
Always use oven gloves to remove dishes from the
oven.
Maintenance and Cleaning
Before maintenance and cleaning disconnect the
appliance and allow to cool.
For reasons of hygiene and safety this appliance must
always be kept clean. A build up of grease or other food can cause fires.
The accessories (grid and dripping pan) should be
washed before using for the first time.
Take care when using cleaning products in spray form:
never direct the spray onto the resistance or the thermostat bulb.
If, when placing food in the oven, or when removing it, a
large quantity of oil, juice, etc. spills onto the bottom of the oven, re-clean before starting to cook to avoid unpleasant smoke and also the possibility of these substances catching fire.
Ensure that air can circulate around the gas appliance.
Poor ventilation can produce a lack of oxygen.
The use of a gas cooking appliance produces heat and
humidity in the room in which it is installed. Ensure good ventilation of the room keeping natural ventilation openings clear or installing an extractor hood with a discharge tube. In case of doubt ask installer for advice.
Supply the appliance with the type of gas stamped on
the relevant adhesive label situated in the immediate vicinity of the gas connection tube.
The gas oven becomes hot with the movement of air.
The holes on the bottom of the oven must never be obstructed. Do not cover the sides of the oven with aluminium foil, in particular the lower part of the opening.
The appliance is heavy, move it carefully.
To facilitate ignition, light the burners before placing
pans on the grid. After having lit the burners check that
the flame is regular.
Always lower the flame or turn it off before removing the
pan.  Ensure that the oven grids are inserted correctly.  Only heat-resistant plates may be placed in the drawer
situated under the oven.Do not put combustible
materials there.
Service
In case of repairs, do not attempt to correct yourself.
Repairs carried out by unqualified persons can cause
damage. Contact an authorized Technical Assistance
Centre and insist an original spareparts.
Environmental Information
After installation, please dispose of the packaging with
due regard to safety and the environment.  When disposing of an old appliance, make it unusable,
by cutting off the cable. Remove any door catches, to
prevent small children being trapped inside.
2
Contents
Instructions for the user
Important Safety Information 2
Dimensions of the appliance 3
Using the cooker hob 4
Hints and tips 5
Using the Gas oven 6
Using the Electric Oven 8
Suggestions for the use of the gas burners 9
Suggestions for the use of the oven 9
Cooking tables 11
Maintenance 13
Guide to Use the instructions
The following symbols will be found in the text to guide you throughout the Instructions:
Safety Instructions
Step by step instructions for an operation
F
Hints and Tips
Environmental information
Instructions for the installer
Gas connection 15
Adaptation to different kinds of gas 16
Insertion possibility 17
Technical data 18
Electrical connection 19
Something not working 19
This appliance complies with the following
E.E.C. Directives:  73/23 - 90/683 (Low Voltage Directive);  89/336 (Electromagnetical Compatibility
Directive);
 90/396 (Gas Appliance Directive);  93/68 (General Directives);
and subsequent modifications.
MANUFACTURER:
ELECTROLUX ZANUSSI S.p.A. Viale Bologna 298 47100 FORLÌ (Italy)
Dimensions of the appliance
850
600
Oven door protection device (Code 35791)
Our appliances are in conformity with the EUROPEANS SAFETY REGULATIONS. In order to further protect children from the heat coming from the oven door a special kit, which can be easily applied to the appliance, is available. You can buy the kit in our CUSTOMER SERVICE CENTRES; it can be requested stating the number of PRODUCT NO. shown on the working plate. Instructions for the installationn are enclosed in the packaging.
600
850
900
550
3
Using the cooker hob
Control knobs on the gas hob
The knobs for using the gas hob of the cooker are found on the control panel. The regulation knobs hould be turned in anti-clockwise direction until the small flame symbol, and vice-versa for the larger symbol.
No gas supply
Maximum gas supply
Minimum gas supply
Ignition of hob burners
To ignite a burner, before positioning the saucepan, proceed as follows:
1. push the corresponding knob in completely
F
In models provided with a safety device ("thermocouple", fig. 1 - D), the control knob must be pressed in for approximately 5 seconds until the safety valve automatically keeps the flame lit. If after a few attempts the burner does not ignite, check that the burner cap and crown (fig.1-A,B) are correctly positioned. To interrupt the supply of gas, turn the knob in a clockwise direction to the position "l".
and turn in an anticlockwise direction to the maximum position;
2. upon ignition regulate the flame as required.
During cooking, when using fats or oils, take particular care as they can, when over­heated, self-ignite. When using the triple-crown burner, place the special grid on the pan support (fig.2-A). When using the auxiliary burner (with pans having a diameter equal or higher than 50mm), place the special grid on the pan support, as shown in fig.2-B.
A - Burner Cap
B - Burner crown
C -Spark generator
D - Thermocouple
FO 0204
A
B
D C
Fig. 1
A
B
Triple-crown burner
In models provided with triple-crown burner, always
ignite the burner before putting the pans on. If after a few attempts the burner does not ignite, check that the burner cap and crown are correctly positioned.
Control knob for the hotplates
The hotplates control knob (EK 6735 - 9735) can be adjusted on four different positions, according to your cooking needs, from maximun heat (position 4) to minimum heat (position 1), as shown in Fig.3.
Table of minimum and maximum diameters of recipients to be placed on burners
Burner min diam max diam
Triple-crown (large) ø 220 mm ø 260 mm Semi-rapid (medium) ø 120 mm ø 220 mm Auxiliary (small) ø 80 mm ø 160 mm Fish kettle burner 120 x 270 210 x 380
4
Fig. 2
Fig. 3
4
FO 2193
0
1
3
2
Hints and tips
Pottery
Remember that a wide-bottomed pan allows a faster cooking than a narrow one. Always use pots which properly fit what you have to cook. Particularly make sure that the pans are not too small for liquids, since these could easily overflow. Moreover, the pans should not be too large for a faster cooking. In fact, grease and juices may spread on the bottom and burn easily. It is better to use non-openable moulds for baking cakes. In fact, an openable mould lets juices and sugar leak through, falling on the bottom of the oven and consequently burning on the bottom of the baking tray, making cleaning difficult. Avoid putting plastic-handled pans in the oven as they are not heat-proof. You should use pans with the right diameter to fit the burner, in order to make the most out of it, thus reducing gas consumption as in Fig. 4. It is also advisable to cover any boiling casserole and, as soon as the liquid starts boiling, lower the flame enough to keep the boiling point.
Fig. 4
Hotplates
Saucepans suitable for use on solid plate hobs should have several characteristics:
they should be fairly heavy duty;  they should fit the heat area exactly, or be slightly
larger for efficient use, NEVER smaller;
they should have a flat base to ensure good contact
with the plate (see Fig. 5).
This is particularly important when using pans for high temperature frying or pressure cooking.
Ensure pans are large enough to avoid liquids being spilt onto the plates.
Never leave the plates on without a pan on them or with an empty pan on them.
In models supplied with a cover, if it is made of glass, it should not be closed when the burners are still hot, as it could splinter.
Fig. 5
5
Using the Gas oven
(EK 6714- 9710 - 9711 - 9714 - 9715)
Ignition
F
1. Open the oven door, then push and turn the oven knob
(Fig. 6) in anti-clockwise direction to the maximum tem­perature position;
2. Upon ignition keep the knob pushed in for about 5
seconds.
For manual ignition:
open the oven door and hold a flame near the hole in the
bottom as shown in fig. 7;
press the oven knob and turn anti-clockwise until the
maximum temperature position is reached;
press in the oven knob for approximately 5 seconds until
the safety valve automatically keeps the oven burner lit. If the burner does not light first time, keep the oven door open and wait 1 minute at least before repeating the operation. Once the oven has been lit, adjust the flame as required.  If the flame should accidentally go out, turn the oven knob
at the "off" position (symbol "l") and wait 1 minute at least
before retrying to light the burner.
Ignition of the oven burner must be carried out with the oven door open. When cooking with the oven or grill, the cover must be kept open to avoid over-heating.
Fig. 6
FO 2481
240
140
160
200
To adjust automatically the flame in cookers equipped with thermostat (Fig. 6), turn the knob to the position corresponding to the temperature desired, after a few minutes of work.
Grill burner ignition
F
Open the oven door;  turn the oven knob (Fig.6) on the Grill symbol . Upon
ignition, keep the knob pushed in for about 5 seconds.
For manual ignition:
open the oven door and hold a flame near the gas grill
burner holes, as shown in fig. 8;  press the oven knob and turn it clockwise until it points
on the Grill symbol ;  keep the oven knob pushed in for about 5 seconds until
the safety valve automatically keeps the oven burner lit. If the burner does not light first time, repeat the operation keeping the knob pressed in slightly longer. Once the oven has been lit, adjust the flame as required.
Turnspit
F
For correct use, proceed as follows (fig. 9):  fit the spit support into the third runner from the bottom;  slide the spit into the food to be cooked and secure well;  rest the front part of the spit on the hook,ensuring that the
point of the spit is well inserted into the rotisserie motor
housing (fig. 10);  remove the handle;  turn the oven knob to the grill position or, when required
for some models, turn on the motor by means of the
appropriate switch .
6
Fig. 7
Fig. 8
Fig. 9
When cooking with the rotisserie and the grill, you are advised to leave the oven door half open and to fit the knob protection shield as shown in fig.10 - A. Model EK 6714: When cooking with the rotisserie and the grill, you are advised to leave the oven door half open and to fit the knob protection shield as shown in fig.10 - B.
FO 1079
FO 0829
FO 0329
Loading...
+ 13 hidden pages