AEG EHG691X, EHG691BK, EHG673B, EHG673X, EHG673G, EHG691W, EHG673W, EHG673C, EHG673BK User Manual
Gas hobs
INSTRINSTR
INSTR
INSTRINSTR
Please read this instruction booklet before using the appliance
UCTION BOOKLETUCTION BOOKLET
UCTION BOOKLET
UCTION BOOKLETUCTION BOOKLET
35675-8204
Mod. EHG 673 - EHG 691
GB
Important Safety Information
You MUST read these warnings carefully before installing or using the hob. If you need
assistance, contact our Customer Care Department on 08705 950950
Installation
z This hob must be installed by qualified personnel,
according to the manufacturer’s instructions and to
the relevant British Standards.
z Any gas installation must be carried out by a
registered CORGI installer.
z Remove all packaging before using the hob.
z Ensure that the gas and electrical supply complies
with the type stated on the rating plate, located near
the gas supply pipe.
z Do not attempt to modify the hob in any way.
Child Safety
z This hob is designed to be operated by adults. Do
not allow children to play near or with the hob.
z The hob gets hot when it is in use.
z Children should be kept away until it has cooled.
z Children can also injure themselves by pulling pans
or pots off the hob.
During Use
z This hob is intended for domestic cooking only. It is
not designed for commercial or industrial purposes.
z When in use a gas cooking appliance will produce
heat and moisture in the room in which it has been
installed. Ensure there is a continuous air supply,
keeping air vents in good condition or installing a
cooker hood with a venting hose.
z When using the hob for a long period of time, the
ventilation should be improved, by opening a window
or increasing the extractor speed.
z Do not use this hob if it is in contact with water.
Do not operate the hob with wet hands.
z Ensure the control knobs are in the ‘OFF’ position
when not in use.
z When using other electrical appliances, ensure the
cable does not come into contact with the hot surfaces
of the cooking appliance.
z Unstable or misshapen pans should not be used on
the hob as unstable pans can cause an accident by
tipping or spillage.
z Never leave the hob unattended when cooking with
oil and fats.
z Never use plastic or aluminium foil dishes on the hob.
z Perishable food, plastic items and areosols may be
affected by heat and should not be stored above or
below the hob unit.
Service
z This hob should only be repaired or serviced by an
authorised Service Engineer and only genuine
approved spare parts should be used.
Environmental Information
z After installation, please dispose of the packaging with
due regard to safety and the environment.
z When disposing of an old appliance, make it unusable,
by cutting off the cable.
Keep this instruction book for future reference
and ensure it is passed on to any new owner.
Guide to Use the instructions
The following symbols will be found in the text to guide
you throughout the Instructions:
6. Electric Ignition Push Button (only for model EHG 673)
3
Operation
Hob Burners
To light a burner:
)
Mod. EHG 673
z push the electric ignition pushbutton which is marked
by a little spark;
z at the same time turn the relevant control knob
anticlockwise to maximum position;
z then adjust the flame as required.
If the burner does not ignite, turn the control knob to
zero, and try again.
To ensure maximum burner efficiency, you should only
use pots and pans with a flat bottom fitting the size of
the burner used (see table).
Burnerminimummaximum
diameterdiameter
Large (rapid)180 mm.260 mm.
Medium (semi-rapid)120 mm.220 mm.
Small (auxiliary)80 mm.160 mm.
If you use a saucepan which is smaller than the
recommended size, the flame will spread beyond
the bottom of the vessel, causing the handle to
overheat.
As soon as a liquid starts boiling, turn down the
flame so that it will barely keep the liquid
simmering.
Take care when frying food in hot oil or fat, as
the overheated splashes could easily ignite.
If the control knobs become difficult to turn, please
contact your local Service Force Centre.
To light a burner:
)
Mod. EHG 691
z push in the relevant control knob and turn it
anticlockwise to maximum position.
z Upon ignition, keep the knob pushed down for about
5 seconds. This will allow the "thermocouple" (see
diagram) to be heated and the safety device to be
switched off, otherwise the gas supply would be
interrupted.
z Then adjust the flame as required.
z If the burner does not ignite, turn the control knob to
zero, and try again.
FO 0204
A - Burner cap
B - Burner crown
C - Ignition electrode
D - Thermocouple
Maintenance and Cleaning
Before any maintenance or cleaning can be carried
out, you must DISCONNECT the hob from the
electricity supply.
The hob is best cleaned whilst it is still warm, as
spillage can be removed more easily than if it is
left to cool.
The Hob Top
Regularly wipe over the hob top using a soft cloth well
wrung out in warm water to which a little washing up liquid
has been added. Avoid the use of the following:
- household detergent and bleaches;
- impregnated pads unsuitable for non-stick saucepans;
- steel wool pads;
- bath/sink stain removers.
4
Should the hob top become heavily soiled, the following
products are recommended:
- For stainless steel hobs use a proprietary stainless
steel cleaner.
- For other hobs use Hob Brite or Bar Keepers Friend.
Pan Supports
The pan supports are dishwasher proof. If washing them
by hand, take care when drying them as the enamelling
process occasionally leaves rough edges. If necessay,
remove stubborn stains using a paste cleaner.
The Burners
The burner caps and crowns can be removed for cleaning.
Wash the burner caps and crowns using hot soapy
water, and remove marks with a mild paste cleaner. A
well moistened soap impregnated steel wool pad can be
used with caution, if the marks are particularly difficult to
remove.
After cleaning, be sure to wipe dry with a soft cloth.
Something Not Working?
If the hob is not working correctly, please carry out the following checks before contacting your local Service Force
Centre.
IMPORTANT:
a charge will be made even if the appliance is under guarantee.
If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation,
SYMPTOM
There is no spark when lighting the gas
The gas ring burns unevenly
If after all these checks, your hob still does not operate
correctly, contact your local Service Force Centre.
Please note that it will be necessary to provide proof of
purchase for any in-guarantee service calls.
SOLUTION
Check that the unit is plugged in and the electrical
supply is switched on
Check that the RCCB has not tripped (if fitted)
Check the mains fuse has not blown
Check the burner cap and crown have been
replaced correctly, e.g. after cleaning.
Check the main jet is not blocked and the burner
crown is clear of food particles.
Check the burner cap and crown have been
replaced correctly, e.g. after cleaning.
In-guarantee customers should ensure that the
above checks have been made as the engineer will
make a charge if the fault is not a mechanical or
electrical breakdown.
Service and Spare Parts
In the event of your appliance requiring service, or if you
wish to purchase spare parts, please contact your local
Service Force Centre by telephoning:
0870 5 929929
Your telephone call will be automatically routed to the
Service Force Centre covering your post code area.
For the address of your local Service Force Centre and
further information about Service Force, please visit the
website at www.serviceforce.co.uk
Before calling out an engineer, please ensure you have
read the details under the heading “Something Not
Working.”
When you contact the Service Force Centre you will need
to give the following details:
1. Your name, address and post code
2. Your telephone number
3. Clear and concise details of the fault
4. The model and serial number of the appliance (found
on the rating plate)
5. The purchase date
5
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.