AEG EFG50022S, EFG50021S User Manual

USER MANUAL

EFG50021

EFG50022

AEG EFG50022S, EFG50021S User Manual

We were thinking of you when we made this product

electrolux 3

EN

IMPORTANT SAFETY INFORMATION 4

YOUR APPLIANCE

5

OPERATING INSTRUCTIONS

5

MAINTENANCE AND CLEANING

7

SOMETHING NOT WORKING

10

GUARANTEE/CUSTOMER SERVICE 11

GUARANTEE CONDITIONS

12

INSTALLATION INSTRUCTIONS

14

ELECTRICAL CONNECTIONS

15

INSTALLING THE COOKER HOOD

16

EN

Welcome to the world of Electrolux

Thank you for choosing a first class product from Electrolux, which hopefully will provide you with lots of pleasure in the future. The Electrolux ambition is to offer a wide variety of quality products that make your life more comfortable. You find some examples on the cover in this manual. Please take a few minutes to study this manual so that you can take advantage of the benefits of your new machine. We promise that it will provide a superior User Experience delivering Ease-of-Mind.

Good luck!

Guide to use the instruction book

The following Symbols will be found in the text to guide you through the instruction book

Safety instructions

Step by step instructions

 

 

 

4 electrolux IMPORTANT SAFETY INFORMATION

 

IMPORTANT SAFETY INFORMATION

 

These warnings are provided in the interests of your safety. Ensure that you

 

understand them all before installing or using this appliance. Your safety is of

 

paramount importance. If you are unsure about any of the meanings of these

EN

warnings contact the Customer Care Department.

Installation

Any installation work must be undertaken by a qualified electrician or a competent person.

This hood must be installed in accordance with the installation instructions and all measurements must be adhered to.

If the cooker hood is installed for use above a gas appliance then the provision for ventilation must be in accordance with the Gas Safety Codes of Practice BS.6172, BS.5440 and BS.6891 (Natural Gas) and BS.5482 (LP Gas) 1994, the Gas Safety (Installation & Use) Regulations, the Building Regulations issued by the Department of the Environment, the Building standards (Scotland) (Consolidated) Regulations issued by the Scottish Development Department.

The fan motor of this cooker hood incorporates a cut-out device which will operate if the cooker hood is installed below the minimum height recommended under section ‘Clearance Height’, or if the motor becomes overheated. If the cutout device is activated, switch off the fan motor and allow the cooker hood to cool. The cut-out device will reset itself when the fan motor has cooled significantly.

It is dangerous to alter the specifications or modify this product in any way.

When installed between adjoining wall cabinets the wall cabinets must not overhang the hob.

If the room where the hood is to be used contains a fuel burning appliance such as a central heating boiler then its flue must be of the room sealed or balanced flue type.

If other types of flue or appliances are fitted ensure that there is an adequate supply of air to the room.

The ducting system for this appliance must not be connected to any existing ventilation system which is being used for any other purpose.

Do not install above a cooker with a high level grill.

Child Safety

This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the appliance.

During Use

This product is for domestic use only.

Never leave frying pans unattended during use as over-heated fats and oils might catch fire.

Never do flambé cooking under this cooker hood.

Do not leave naked flames under the hood.

This cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam.

Maintenance and Service

This appliance can be a hazard if the synthetic paper and charcoal filters are not replaced as recommended.

Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or more serious malfunction. Refer to your local Electrolux Service Force Centre. Always insist on genuine spare parts.

YOUR APPLIANCE AND OPERATING INSTRUCTIONS electrolux 5

YOUR APPLIANCE

EN

OPERATING INSTRUCTIONS

The cooker hood is designed to extract

 

unpleasant odours from the kitchen, it

 

will not extract steam.

 

To obtain the best performance it is

 

advisable to switch on the hood a few

 

minutes before you start cooking and

 

leave it running for approximately 15

 

minutes after finishing.

 

Cooker Hood Controls

 

The cooker hood functions are

 

controlled by slide switches, located

 

centrally in the front edge of the metal

 

grille panel.

 

EFG 50021

 

L. Light ON/OFF control

EFG 50021

0 - Off

 

1 - On

 

V. Fan Speed Control

 

Position 0 - Off

 

Position 1 - Low

 

Position 2 - Normal

 

Position 3 - Boost

 

 

6 electrolux

 

 

EFG 50022

 

 

L. Light ON/OFF control

 

 

0 - Off

EFG 50022

 

1 - On

 

EN

M.Motor ON/OFF control

 

0 - Off

 

 

1 - On

 

 

V. Fan Speed Control

 

 

Position 1 - Low

 

 

Position 2 - Normal

 

 

Position 3 - Boost

 

 

To Operate

 

 

Select the required functions.

 

 

The appliance can be installed to

 

recirculate or extract contaminated air.

 

The cooker hood is more effective when

 

used in the extraction mode.

 

 

Extraction

 

 

In the extraction mode the contaminated

 

air enters the cooker hood, passes

 

through the grease filter and out through

 

the ducting to the atmosphere.

 

 

Recirculation

 

 

In the recirculation mode contaminated

 

air is passed through the

charcoal

filters to be purified and recirculated into the kitchen through a recirculation grille. Ensure the charcoal filters are in position.

When the ducting mode is selected the charcoal filters are not required. Never do flambé cooking under this cooker hood.

Never leave frying pans unattended during use as over-heated fats and oils can catch fire.

Do not leave naked flames under the cooker hood.

Ensure heating areas on your hob are covered with pots and pans when using the hob and cooker hood simultaneously.

MAINTENANCE AND CLEANING electrolux 7

MAINTENANCE AND CLEANING

Before carrying out any maintenance

 

or cleaning isolate the cooker hood

 

from the mains supply.

EN

The cooker hood must be kept clean,

 

as a build up of grease or fat can be

 

a fire hazard.

 

The external surfaces of the hood

 

should be cleaned regularly. Wipe the

 

cooker hood frequently with warm

 

soapy water using a mild detergent. Dry

 

thoroughly after cleaning.

 

Always wear protective gloves when

 

cleaning the hood.

 

Never use scouring pads or abrasive

 

cleaners.

 

Never use excessive amounts of wa-

 

ter when cleaning particularly around

 

the control panel.

 

Charcoal Filter

 

The charcoal filters absorb the odours

 

from cooking. They will slowly become

 

saturated and gradually less effective.

 

The charcoal filters cannot be cleaned,

 

we recommend they are replaced every

 

3-6 months or more often if the hood is

 

used for more than 3 hours per day.

 

To Remove/Replace the

Charcoal Filters

1.Remove the lower grille, supporting the grille with one hand and draw down on the two grey handles (located on each side of the grille).

2.The charcoal filters are left and right handed and should be fitted one at a time.

3.Insert one end of the filter into the slots in the fan housing then lower the other end until the tab engages the slot in the casing.

8 electrolux

Synthetic Grease Filter - EFG 50021

The synthetic grease filter cannot be cleaned.

It cannot be washed.

EN

To Replace the Synthetic Grease Filter

1.Remove the lower grille.

2.Push the wire retaining clips to the side and remove.

3.Clean the metal grille and clips before replacing the paper grease filter.

The clips have sharp points, handle with care and keep away from children.

This appliance is a possible fire hazard if the grease and charcoal filters are not replaced as recommended.

Metal Grease Filters - EFG 50022

The metal grease filters can be machine washed in a dishwasher, or hand washed in hot water and a mild detergent or liquid soap.

To Remove/Replace the Metal Filters

1.Press against the metal actuator to release the spring catch.

2.Drop the front edge of the cassette down as illustrated opposite and lift the back edge out of the rear guide.

3.To refit insert the back edge of the cassette into the rear guide and push up the front edge until the spring catch engages.

This appliance is a possible fire hazard if the grease filters are not cleaned reguarly and the charcoal filters replaced as recommended.

Loading...
+ 16 hidden pages