USER MANUAL
EFC60001
EFC90001
We were thinking of you
when we made this product
EN
RECOMMENDATIONS AND SUGGESTIONS 5
CHARACTERISTICS 6
INSTALLATION 8
USE 11
MAINTENANCE 12
electrolux 3
EN
Welcome to the world of Electrolux
Thank you for choosing a fi rst class
product from Electrolux, which hopefully will provide you with lots of pleasure
in the future. The Electrolux ambition is
to offer a wide variety of quality products that make your life more comfortable. You fi nd some examples on the
cover in this manual. Please take a few
minutes to study this manual so that
you can take advantage of the benefi ts
of your new machine. We promise that
it will provide a superior User Experience delivering Ease-of-Mind.
Good luck!
4 electrolux Recommendations and Suggestions
RECOMMENDATIONS AND SUGGESTIONS
Installation
• The manufacturer will not be held liable for any damages resulting from
EN
incorrect or improper installation.
• The minimum safety distance between the cooker top and the extractor hood is 650 mm.
• Check that the mains voltage corresponds to that indicated on the rating
plate fi xed to the inside of the hood.
• For Class I appliances, check that the
domestic power supply guarantees
adequate earthing.
Connect the extractor to the exhaust
fl ue through a pipe of minimum diameter 120 mm. The route of the fl ue
must be as short as possible.
• Do not connect the extractor hood to
exhaust ducts carrying combustion
fumes (boilers, fi replaces, etc.).
• If the extractor is used in conjunction
with non-electrical appliances (e.g.
gas burning appliances), a suffi cient
degree of aeration must be guaranteed in the room in order to prevent
the backfl ow of exhaust gas. The
kitchen must have an opening communicating directly with the open air in
order to guarantee the entry of clean
air.
Use
• The extractor hood has been designed exclusively for domestic use to
eliminate kitchen smells.
• Never use the hood for purposes
other than for which it has ben designed.
• Never leave high naked fl ames under
the hood when it is in operation.
• Adjust the fl ame intensity to direct it
onto the bottom of the pan only, making sure that it does not engulf the
sides.
• Deep fat fryers must be continuously
monitored during use: overheated oil
can burst into fl ames.
• Do not fl ambè under the range hood;
risk of fi re
• The hood should not be used by children or persons not instructed in its
correct use.
Maintenance
• Switch off or unplug the appliance
from the mains supply before carrying
out any maintenance work.
• Clean and/or replace the Filters after
the specifi ed time period.
• Clean the hood using a damp cloth
and a neutral liquid detergent.
The symbol on the product or on its
packaging indicates that this product may
not be treated as household waste. Instead
it shall be handed over to the applicable
collection point for the recycling of electrical
and electronic equipment. By ensuring this
product is disposed of correctly, you will help
prevent potential negative consequences for
the environment and human health, which
could otherwise be caused by inappropriate
waste handling of this product. For more
detailed information about recycling of this
product, please contact your local city offi ce,
your household waste disposal service or
the shop where you purchased the product.
CHARACTERISTICS
Dimensions
Characteristics electrolux 5
==
==
==
600
700
900
275
15
X1
H
X2
J
Components
Ref. Q.ty Product Components
F 1 Adapting ring ø 120-125 mm
G 1 Reducer Flange ø 150-120 mm
H 1 Air Outlet Connection
Ref. Q.ty Installation Components
C 2 Upper Chimney Section Fixing
Brackets
Q.ty Documentation
1 Instruction Manual
H
F
G
EN
180
A
B
180
180
1140 max
590 min
290
750 min
920 max
670 min
670
S30_01_n
C
6 electrolux Installation
INSTALLATION
The cooker hood must be installed centrally over a cooking appliance. The minimum distance between the cooking
surface and the metal grease fi lters on
EN
the underside of the hood must be at
least 650mm.
To install the hood proceed as follows:
1) Drill six 8mm diameter holes at X1-
X2-J and insert the plastic rawl plugs
supplied as illustrated ensuring the
brackets are fi tted as shown in the
blow up.
2) Secure the two brackets C to the wall
inserting two of the screws supplied
through the two holes on line X1-X2
as illustrated .
3) Slide the canopy down the wall to
locate the key hole over the washer
then secure the canopy to the wall
by inserting two of the screws supplied through the two outer holes in
the rim of the canopy J1 and J2 as
illustrated
X
X1
H
J
S30_02_n
J
S30_03_n
X2
1
C
2
2
1
275
15
X1
H
X2
J
==
==
==
180
A
B
180
180
1140 max
590 min
290
920 max
750 min
670 min
670
S30_01_n
600
700
900
Connections
Ducted Version Air Exhaust system
When installing the ducted version,
connect the hood to the chimney using
either a fl exible or rigid pipe ø 150 or
125 mm, the choice of which is left to
the installer.
• To install a ø 125 mm air exhaust connection, insert the reducer fl ange G
on the hood body air outlet and the
adapting ring ø120-125 F on the reducer fl ange.
• Fix the pipe in position using suffi cient
pipe clamps (not supplied).
• Remove any activated charcoal fi l-
ters.
Connection in Recycling Version
• When the hood is fi tted in the recircu-
lation mode the Air Outlet Connection
H should be fi tted as illustrated .
• Fit the (optional) charcoal fi lters by
repeating the following operation on
each side of the motor housing. Place
the two key hole slots in the fi lter and
turn the fi lter clockwise to lock the
fi lter in position.
WARNING: It is a possible fi re hazard if
the metal grease fi lters are not cleaned
and the charcoal fi lters replaced regu-
larly.
ø120
G
Installation electrolux 7
ø150
ø125
F
G
H
B
EN
A
Connection to the Mains
WARNING: Double insulated do
not earth
• Before connecting to the mains supply ensure the mains voltage corresponds to the voltage on the rating
plate inside the hood.
• This appliance is fi tted with a 2 core
mains cable and must be permanently
connected to the electricity supply via
a double-pole switch having 3mm
minimum contact gap on each pole.
8 electrolux Installation/Use
Chimney assembly
Upper Chimney
• To fi t the upper chimney A, place the
EN
top edge of the chimney over the
bracket C as illustrated and secure
the chimney using two of the 2.9mm
self tapping screws provided.
• The distance H in the height between
the fi xing holes X1 and X2 is deter-
mined by the height of the upper
chimney A.
Lower Chimney
• To fi t the lower chimney B, apply slight
force to the two rear edges to increase
the width of the apperture, then sleeve
the chimney B over the chimney A as
illustrated.
B
USE
The cooker hood functions are controlled by a series of slider or push button
switches mounted on the front of the
hood and control the worktop lighting
and fan motor speeds. This cooker
hood will not remove steam.
1) SLIDER SWITCHES
- A switch controls the wotktop light-
ing - ON/OFF.
- A switch controls the fan speeds -
OFF/ON-1-2-3.
- The red neon lamp illuminates when
the motor is switched ON .
2) SPEED SETTINGS
- 1/Low should be selected when sim-
mering or when using only one pan.
- 2/Medium should be selected for
cooking when using up to four pans.
- 3/High should be selected when frying
or cooking food with a strong odour.
S30_08_n
MAINTENANCE
N.B. Before carring out any kind of
maintenance, cleaning or replacing lamps, disconnect the hood from the mains
supply.
Lighting
40 W incandescent light
• Remove the metal grease fi lters.
• Unscrew the bulbs and replace them
with new ones having the same characteristics.
• Replace the metal grease fi lters.
Filters
• The metal grease fi lter should be
cleaned every two months or more
frequently if the hood is used consistently and can be cleaned in a dishwasher or by hand using a mild detergent or liquid soap. When replacing,
ensure that they are dry.
• The charcoal fi lter cannot be washed
and should be replaced at least every
2 months or more frequently if the
hood is used consistently.
Maintenance electrolux 9
EN
Cleaning
When cleaning the hood, it is recommended to use a damp cloth and mild liquid
household
cleaner. Never use abrasive cleaning materials.
ATTENTION: The manufacturer declines all
responsibility for any damage or injury
caused as a result of not following the instructions for installation, for maintenance
and replacement times of fi lters indicated (in
order to avoid a possible risk of fi re when the
fi lters are saturated with grease).
www.electrolux.com
436003751_04 - 070831
Loading...