AEG EDV705G User Manual

USER MANUAL
133356320
Tumble Dryer
EDV705G
EN
Contents
Important Safety Instructions
Dryer Safety Fire Hazards Cleaning the Lint Filter Drying Guide
Installation Instructions
Page 2 Page 2 Page 3 Page 3
Page 4
Use
The Control Panel Operating Sequence
Hints Page 8 Troubleshooting Page 9 Warranty Page 10
DRYER SAFETY FIRE HAZARDS
bottom of the door opening for voltage information.
Page 5 Page 6
These dryers are for drying clothes, towels and linen at home. Do not use them for commercial or any other purpose.
Items that have previously been cleaned in, washed in, or spotted with petrol/gasoline, industrial chemicals
used only for cleaning, dry-cleaning solvents or other flammable o r explo sive substances are highly flammable. Highly flammable or explosive commonly found around the house include acetone, (nail polish remover) denatured alcohol, petrol/gasoline, kerosene, some spot removers, turpentine, waxes and wax removers should not be put in the dryer. Items containing foam rubber (also known as latex foam) or similarly textured rubber-like materials. Foam rubber materials can produce fire by spontaneous combustion when heated.
CLEANING THE LINT FILTER DRYING GUIDE
LINT BUILD-UP IS A FIRE HAZARD
Do not tumble dry
The lint filter is located at the front of your dryer at the bottom of the door opening.
Normal
LINT
FILTER
Delicates
Installation Instructions
3. Unclip the cover trim insert window from the panel.
4. Insert reverse label provided in accessory bag.
NAME BADGE
EXHAUST GRILLE
LEGS
REMOVABLE EXHAUST GRILLE
WORKTOP
DOOR SAFETY SWITCH
BUTTON
Trim Insert
You can invert the trim insert when you want to mount your dryer upside down on the wall.
1. Remove two screws at the back as indicated below.
2. Slide worktop to the back and lift up.
SLIDE THE WORKTOP
TO THE BACK
LIFT UP THE WORKTOP
5. Clip back the cover trim insert window.
6. Place worktop onto original position, then slide to the front.
PLACE ONTO ORIGINAL POSITION
SLIDE THE WORKTOP
TO THE FRONT
7. Put two screws at the back.
DRYER
WASHING MACHINE
venting kit (optional extra)
Installation Instructions
INLETS
OUTLET COVER
Use
THE CONTROL PANEL
Timer Programs
Sensor Programs
unventilated room.
9
10
On/Off Button
1
This button switches the dryer on. At the end of the program, press the button again to switch the dryer off.
2
Start/Pause Button
This button allows you to start or pause the dryer to check the contents of the load or perhaps add more clothes to the load.
NOTE: It will not start or restart a program unless the door safety button has also been pressed in. If the safety button is not pressed in a door switch fault will be indicated (sound “beeps” 6 times).
6 8 5 4 3 2 7
3
Delay
Button
This button is a feature that permits you to start the dryer after a defined number of hours, ranging from 3, 6, and 9 hours.
To abort the Delayed Start, press the Start/Pause button, which puts the machine into paused mode, allowing you to change the delay time.
NOTE: Make sure you have set the disired program before setting the delay.
4
Option Button
This button allows Free.
5
you to select Buzzer and Crease
1
Loading...
+ 11 hidden pages