AEG EBCGL90SP User Manual

EBC GL9

(55 cm)

EBC GL90

(60 cm)

315 7511 03_08/2009

Technical data/Problem solving

Customer service/Warranty

Safety instructions

Installations

This document is an integral part of the documentation for the
installation compact oven EBC GL 9/90

Built-in Compact Oven

Surface grill, microwave

231

Installation Instructions

Installation

WARNING: do not trap the cable!
When plugging in at the top, fasten
cable with the cable routing on the
left-hand side.

Push the oven into the recess Fix the oven on the both sides with

2 screws (detail A)

Place the appliance in front of the
recess and connect the mains plug

During installation in combustible matter, NIN 2000, section 4.2.2 and fire protection guidelines and
regulations of the Association of Cantonal Fire Insurance shall be strictly adhered to.

Variants

If the compact oven is built in directly over the installation oven in combinations, this must be done with the enclosed support
bracket set no. 315 68 3900. Look at installation sheet no. 315 6837 00 for the installation standard.

EBC GL9 (55 cm, 230 V) EBC GL90 (60 cm, 230 V)

Details see safety instructions page C

Connection by means of a power socket shall be provided by the customer, so that the power socket is available and outside the range of coordination

1. Clamp connection as per the connection diagram

2. Secure the strain relief

The electro connection has to be carried out by a licensed fitter

For a network connecting line, use line version H05VV-F or higher

Installation has to be carried out using a supply line with plug or it shall be provided with a separator laid in the home installation with at
least 3 mm contact gap, which separates the equipment at the same time and all-pin, according to NIN 2000.

For servicing the appliance must be disconnected!

Electrical connection / supply

- Cable length: 2.50 m from appliance

- Plug: version 12

cable routing

cable routing

N 560-568

A

Page