Advent UBTSW2 User Manual

UBTSW2

Installation Manual

Bluetooth Hands Free Vehicle Kit

1

UBTSW2 Installation Precautions

PROFESSIONAL INSTALLATION STRONGLY RECOMMENDED

Installation Precautions:

Roll down window to avoid locking keys in vehicle
during installation

Avoid mounting components or routing wires near
hot surfaces

Avoid mounting components or routing wires near
moving parts

Tape or loom wires under hood for protection and
appearance

Use grommets when routing wires through metal
surfaces

Use a Digital Multi Meter for testing and verifying
circuits. DO NOT USE A TEST LIGHT, OR
"COMPUTER SAFE PROBE" as these can set off air
bags or damage vehicle computers.

Technical Support [phone]

http://techservices.audiovox.com

2

or go to

UBTSW2 Installation Instructions

Determine and Inspect Location

Find an appropriate location that does not interfere with the safe operation of the vehicle. Inspect the location
from the front and rear to confirm that no wiring, accessories, etc. are located beneath the proposed mounting
surface. Also ensure that there is a minimum or 3 inches depth behind the dashboard.

Drill Hole

Using a 1” hole saw or drill bit, drill the installation hole in the dashboard.

Install UBTSW2

Route wire from the UBTSW2 and plug into the BTHFMOD, as illustrated below.

BTHFMOD

UBTSW2 SWITCH INPUT
NO FUNCTION

Install Microphone

1. Determine a good mounting location for the microphone. The following locations are recommended:

top of the driver's A pillar
steering column

2. Place the Microphone in the intended mounting location.

3. Test the system to ensure good sound quality.

4. If the location is suitable, use the supplied double-sided tape to mount the base of the microphone.

5. Carefully run the cable to the MIC input on the control unit.

3

FCC COMP LIANCE

This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including any interference that may cause
undesired operation.

Warning! Changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

4