Advance Tabco SS2020X, GZ2020X, FS2020X Installation Manual

TA-90 Drawer Adapter

Contents:

(2) Drawer Angles
(4) Self Tapping Screws

Step 1:

Turn table top upside down - Position Drawer Adapter (TA-90)
at desired location.

NOTE: Position Drawer Adapters 21-1/2" apart (outside angle to outside
angle) and 3" from front edge of table - mark holes and drill with 1/8"
drill (Figure 2). NOTE: Slotted hole located 3" from end of 30" & 36"
TA-90 Angles OR 1" from end of 24" TA-90 Angles - to be positioned
towards front of table (Figure 1).

Figure 1

Tools Required:

Drill with 1/8” Drill Bit
3/8" Socket

Figure 2

Installation Instructions for

Deluxe and Budget Drawers

Deluxe Drawer:

SS & GZ Series

Step 2:

Secure TA-90 Drawer Adapter with
Self Tapping Screws provided
(Figure 3).

Step 3:

Install Drawer per referenced instructions. See Page 2 or 3.

Edgewood, New York 11717-8380

Figure 3

© ADVANCE TABCO FEBRUARY 2007

Budget Drawer:

FS & FG Series

CHECK FOR CONCEALED DAMAGE

FILE CLAIM WITH DELIVERING FREIGHT CARRIER

Drawers manufactured by ADVANCE TABCO are designed and constructed for storage.
Applications may include storage of flatware, small utensils, etc. ADVANCE TABCO does
not recommend product use for activities employing harsh and active chemicals.
Please consult factory regarding unusual applications.

SS & GZ Series Drawers

FS & FG Series Drawers

Contents:

(1) Drawer Body
(2) Drawer Slides
(4) 1/4 - 20 x 1/2” Bolts with Nuts

Step 1:

Remove rubber sleeve from alignment pin
as shown (

Step 2:

Install roller bearing slides to underside of
table using 1/4 - 20 x 1/2” bolt and nuts
provided. NOTE: Drawer slide must be
positioned to inside of drawer angles.
Alignment pin must be positioned towards
front of table (Figure 2) - Right Drawer Slide
shown.

Figure 1) - Front of Slide shown.

Tools Required:

(2) 7/16 open end wrenches

Figure 1

Figure 2

Contents:

(1) Drawer Body
(2) Friction Drawer Slides
(4) 1/4 - 20 x 1/2” Bolts with Nuts
(1) Drawer Retainer Clip

Step 1:

Install friction slides underneath table top using 1/4 - 20 x 1/2”
bolts and nuts provided. NOTE: Drawer slide must be positioned
to outside of drawer angles (Figure 1) - Left Drawer Slide shown.

Figure 1

Step 2:

Attach drawer retainer clip loosley to front hole of right drawer slide
(Figure 2). DO NOT TIGHTEN.

Tools Required:

(2) 7/16 open end wrenches

Step 3:

Fully extend drawer slides towards front of
table and install drawer body between
drawer slides. Align hole (Top front flange of
drawer body) with alignment pin (Figure 3).

Step 4:

Install rubber sleeves onto alignment pins
(Figure 4).

Page 2

Figure 3

Figure 4

Figure 2

Step 3:

Pivot retainer clip up - insert drawer body into friction slide.
Reposition clip as shown and tighten all bolts (Figure 3).

Figure 3

age 3

P