FCC COMPLIANCE STATEMENT:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the manufacturer responsible for compliance
could void the user’s authority to operate the equipment
MODEL RST772A
REMOTE ENGINE STARTER
WITH ALARM SYSTEM
OWNER’S MANUAL
RST771A OP
1
APR/30/2003
TABLE OF CONTENTS:
A. REMOTE TRANSMITTER OPERATION ………………………………………….………………….………. 4
B. BUTTON LOCK …………………………………………………..…………………………………….……..…. 4
C. LED DISPLAY .……………..……………………………………………………………………….……………. 5
D. CHIRP INDICATOR ..………..………………………………………………………………………………..…. 5
E. PARKING LIGHT …….……..……………………………………………………………………………..….…. 5
F. ALARM OPERATION CONDITION .………………………………………………………………………...…. 5
G. ACTIVE ARMING – ARM & LOCK .……………………………………………………………...……………. 5
H. PASSIVE ARMING .……………………………………………..………………………………………………. 6
Passive Arming with Passive Door Locking
Passive Arming By-Pass
I. ACTIVE DISARMING – UNLOCK & DISARM .………………………………………………………..………..6
Tamper Disarming
Pathway Illumination
Two Steps Door Unlock
Automatic Re-Arm
J. DISARMING WITHOUT A TRANSMITTER .……………..………………………………………………...…. 6
Overrides the Alarm without Password Pin Code
Overrides the Alarm With Password Pin Code
K. VALET MODE .……………..…………………………………………………………………….…………..….. 7
Enter Valet Mode
Exit Valet Mode
L. CAR LOCATOR .……………………………………………………………………….…………………….…... 7
M. PANIC FUNCTION .……………………………………………………………………………..….……….…... 7
N. TRIGGER THE SYSTEM .………………………………………..………………………….………….………... 8
Clear The Trigger Icons and Melody Sound
Stop The Melody Sound Only
Noise Abatement Circuit
O. ANTI CAR- JACKING .…………………………………………………………………………………………... 8
Active Anti Car Jacking
Passive Anti Car Jacking
Trigger The Anti Car Jacking Mode
Override The System To Turn Off Anti Car Jacking
P. SYSTEM’S TRIGGER CHECK ……………………………………………………………….….….…..….….. 9
Q. SYSTEM’S STATUS CHECK ……………………………………………………………..……….……….….. 9
R. DRIVER PAGING (OPTIONAL) ………..…………………………….…………..…………………...……….. 9
S. DOME LIGHT CONVENIENCE DELAY & SUPERVISION ……………………..………………….……..….9
T. IGNITION CONTROL THE DOOR LOCK/UNLOCK. ………..……………….…………………………..…..9
U. TRUNK RELEASE (CHANNEL 3) OUTPUT ………..……………………………………………………..…10
V. CHANNEL 4 TIMER CONTROL OUTPUT ………..……………………………………………..….………. 10
W. CHANNEL 5 TIMER CONTROL OUTPUT ………..………………………………………….….….……... 10
X. CHANNEL 6 TIMER CONTROL OUTPUT ………..………………………………………….…….…….…. 10
Y. POWER ON MEMONRY: ………..……………………………………………………………….…….…..…. 10
REMOTE START OPERATION:
A. TO REMOTE START THE VEHICLE ………..………………………………………………………………. 10
Safe Start (Child safety mode)
B. TO OPERATE THE VEHICLE WHILE RUNNING ON THE REMOTE START ……………………..….. 11
C. TEMPORARY STOP FEATURE …………………………..………………….……………………...….…… 11
D. TIMER START .………………………………………………………………….………….………..………… 11
E. TO TURN OFF THE REMOTE START ………………………………………………….….….…………..…12
F. SHUT-DOWN INPUT FOR REMOTE STARTER …………………………….………………………..…… 12
G. DISABLING THE REMOTE START SYSTEM …………………………….……..……………..……..….… 12
LCD REMOTE TRANSMITTER:
A. BATTERY REPLACEMENT ……………………………….………………………………………………..… 13
RST771A OP
2
APR/30/2003
B. THE REMOTE LCD ICONS WITH FUNCTION ……….………………………………………………….… 13
C. PROGRAMMING OF THE LCD REMOTE TRANSMITTER …………………………………………….… 14
1. Screen Lamp ON
2. Power Save Mode
3. Clear The Flash Icon and Melody Sound
4. Stop The Melody Sound.
5. Button Lock
6. Vibration / Melody Mode
7. Enable / Disable Bi Sound While Pressing Button:
8. Low Battery Indication.
9. Set Up Fixed Count Down Timer
10. Out Of The Range Check
D. TIMER SETTING ……………………………….…………………………..…………………….………….… 15
1. Timer Setting.
2. Alert Alarm Timer Setting
3. Count Down Timer Setting
4. Time Set-Up For “Daily Timer Start”
WARNINGS:
As with any product that performs automatic functions, there are certain safety precautions that you must
practice and be aware of.
1. Keep the transmitter out of children’s reach.
2. Do not leave anyone in the vehicle while running on remote control.
3. Alert servicing personnel that the vehicle can be started automatically.
4. Do not start the vehicle by remote while it’s in an enclosed area or garage.
5. Always apply the parking brake and lock the vehicle as you exit the vehicle.
6. The vehicle windows must be rolled up.
7. Should the unit malfunction, disconnect the fuse until the problem is corrected.
8. The use and operations of this system is the sole responsibility of the operator.
9. Some areas may have local ordinances that prohibit leaving a vehicle running on public streets.
10. Do not start the vehicle by remote while the standard transmission vehicle is parked at a steep place.
RST771A OP
3
APR/30/2003
OPERATION:
4
5)
6)
hold for 2 seconds
)
A. REMOTE TRANSMITTER OPERATION:
Transmitter Button System Function Remark
-
-
+ +
-
-
-
+
+ +
Lock Doors & Arm System
Panic function Press and Hold for 3 seconds.
Car Locator Under armed mode
Arm and Delete The 2 Stage Shock Sensor. Press twice within 3 seconds
Arm System and Hidden Alarm Function Press within 3 seconds
Silent Arming / Disarming Ignition in "off" position.
Active Anti Car-Jacking Mode Ignition in "on" position press and
Unlock Doors & Disarm System
Two Steps Door Unlock & Disarm System Press twice within 3 seconds.
Trunk Release (Channel 3) Press and Hold for 2 seconds
Passive Arming By-pass While the system Disarmed.
Activate or Turn Off The Remote Start Press twice within 3 seconds.
Channel # 4 Timer Output (
System’s Trigger Record Check Press within 3 seconds
System’s Status Check Press within 3 seconds
Button Lock Press within 3 seconds and Hold
Optional Driving Pager Press within 3 seconds
Monitor Indoor Temperature Press within 3 seconds
Daily Timer Start Press within 3 seconds
LCD screen lamp turns on for 5
seconds.
Clear the Flash Icon and Melody
Sound on the LCD Screen Transmitter
button for 2 seconds
Press and hold for 1 second
Press within 3 seconds
B. BUTTON LOCK:
It is useful if you want to disable the transmission function of the remote control temporarily to prevent from
any inadvertent pressing of buttons by others.
Press the
seconds to activate or cancel the button lock function.
The
is on “Button Lock”.
button first, within 3 seconds press and hold the ( ) button for 2
icon will displayed on the LCD screen to show the LCD remote transmitter
C. LED display:
LED Function LED Function
Off Disarmed Zone 1 / Warn-Away Trigger
Slow Flash Armed 2 flashes... pause Zone 2 / Trigger on Trunk/Hood
Flash Passive Starter Disable 3 flashes... pause Zone 3 / Trigger on Door Switch
Fast Flash Passive Arming 4 flashes... pause Zone 4 / Trigger on Shock Sensor
On (Solid) Valet Mode 5 flashes... pause Zone 5 / Trigger on Ignition Switch
RST771A OP
4
APR/30/2003
D. CHIRP INDICATORS: E. PARKING LIGHT:
Chirp Function Parking light Function
1 chirp Arm 1 flash Arm
2 chirps Disarm 2 flashes Disarm
3 chirps Defective Reminder 3 flashes Disarm / Triggered
4 chirps Disarm / Triggered 12 flashes Car Locator
6 chirps Car Locator Constant On Under Remote Start
F. ALARM OPERATING CONDITION:
Siren / Horn Parking Light LED Doors Starter Dome Light
2. The siren will chirp once and parking light will flash once indicating that the system is now armed. The
vehicle door will lock upon arming when interfaced with the security system.
System Arm
DEFECTIVE SENSOR REMINDER: If the siren sounds 3 chirps, then you have left a door, trunk, or hood
lid ajar. (See Alarm Feature “I
Door Ajar
-
4 Programming)
Trunk / Hood Ajar
Clear The Flash Icon:
Press the
times within 3 seconds
will clear the flash icon on
the LCD screen
transmitter.
button 3
SILENT ARMING / DISARMING:
disarm your security system, No chirp sound will be heard, arm / disarm confirmation will be through the
vehicles parking lights only.
SHOCK SENSOR BY-PASS: Press the
the security system and by-pass the shock sensor. The system will chirp one additional time to confirm the
sensor bypass mode was activated. The sensor bypass feature is programmed to activate for one arming
cycle only. The security system will return to normal operation during the next arming cycle.
HIDDEN ALARM FUNCTION: Press the button first, within 3 seconds press the button to
activate the hidden alarm function. The security system will armed and with “Hidden Alarm Function”. The
siren / horn will be silenced even if the sensor is triggered in the armed status.
Press the transmitter and button at the same time will arm or
button on the transmitter two times within 3 seconds will arm
H. PASSIVE ARMING
Active arming / disarming is controlling your security system via the remote transmitter. This security
system is equipped with an optional Passive Arming feature, which allows the security system to arm 30
seconds after the last door is closed. Operation is as follows.
1. Turn the ignition to the “OFF” position and exit the vehicle.
2. After all entrances are closed, the security system LED will flash fast for 30 seconds. If you reopen any
door / hood / trunk, the security system LED will stop flashing. It will begin flashing again once the
vehicle all entrances are closed.
3. After 30-second timer has elapsed, the security system will automatically “ARM”. The siren will chirp [1]
time and the parking lights will flash [1] time.
PASSIVE ARMING WITH PASSIVE DOOR LOCKING (See Alarm Feature “I
-
2” Programming):
RST771A OP
5
Loading...
+ 10 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.