Advance Multimedia Internet Technology WL581UAM User Manual

802.11n Wireless USB Adapter

Manual

802.11n USB Dongle

FCC Information

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and

2. this device must accept any interference received; including interference that may cause undesired operation.

This Equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of

the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- 1 -

Hereby, AMIT, declares that this device is in compliance with the essential requirement and other relevant

IMPORTANT NOTE: Federal Communication Commission (FCC) Radiation Exposure Statement This EUT is
compliance with SAR for general population/uncontrolled exposure limits in ANSI/IEEE C95.1-1999 and had been
tested in accordance with the measurement methods and procedures specified in OET Bulletin 65 Supplement C.

provisions of the R&TTE Driective 1999/5/EC.

Federal Communications Commission (FCC) Statement.

- Consult the dealer or an experienced radio/TV technician for help.
FCC RF Radiation Exposure Statement:

This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate this equipment.

For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels
is not possible.

Introduction

System

- Standard: IEEE 802.11b/g/n.

- Host Interface: USB 2.0 standard.

- Data rate: 1, 2, 5.5, 11Mbps for 802.11b;

6, 9, 12, 18, 24, 36, 48, 54Mbps for 802.11g;

6, 6.5, 13, 19.5, 26, 39, 52, 58.5, 65, 78, 104, 117, 130Mbps for 802.11n.

- Operating range: Indoor, 30-100m; outdoor, 100-400m (depends on surrounding environment).

The 802.11n wireless USB Dongle, USB 2.0 compatible, allows you to connect to your wireless networking. It provides

more throughput rate on data communication than traditional 802.11g wireless Dongle. With the built advanced

wireless configuration utility, it let it more easily for you to surf your wireless LAN.

Features and Benefits

RF

- Frequency band: 2.400 ~ 2.4835 GHz (subject to local regulation).

- Modulation: OFDM(Orthogonal Frequency Division Multiplexing) for 802.11g/n; DSSS(Direct Sequence

Spread Spectrum) for 802.11b.

- RF radiated output power: 17.89dBm for 802.11g/n; 17.61dBm for 802.11b. (±1dBm).

Software

- Driver: Microsoft Windows 2000, XP, XP64, and Vista.

- Operation mode: Infrastructure mode (Seamless roaming supported), Ad-Hoc mode (peer to peer connection).

- Security: 64/128 bit WEP encryption, WPA, WPA-PSK, WPA2, WPA2-PSK, and 802.1x.

LEDs and Physical connections

- Link: Always on, Green, after linked up to remote wireless.

- Activity: Blinking, Green, for data communication.

- Antenna: Embedded.

Package Contents

- USB wireless Dongle.

- Manual

- Quick installation guide

- CD: includes Dongle drivers, manual, and quick installation guide.

** If any of the above items are missing, please contact your reseller.

- 2 -

System Requirements

Before installing the Dongle and related software, make sure your system meets the minimum requirements described

below.

IBM compatible desktop or notebook PC with available USB slot.

- CPU level: no restricted.

- Memory size: no restricted.

- CDROM drive: no restricted.

- USB Host: USB 2.0 suggested. USB 1.0/1.1 leads low data communication rate.

- Operation system: Microsoft Windows 2000, XP, XP64, or Vista.

- 3 -

Installation

- Insert the Product CD into the CD-ROM drive.

- Execute “Setup.exe” in the root directory of the CD, it will guide you to install the Driver and Utility.

- Insert the wireless Dongle into the USB slot.

- 4 -