FCC Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received; including interference that may cause undesired operation.
Federal Communications Commission (FCC) Statement.
This Equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF Radiation Exposure Statement:
1. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
Introduction
The 802.11g wireless USB adapter, USB 2.0 compatible, allows you to connect to your wireless networking. It provides
more throughput rate on data communication than traditional 802.11g wireless adapters. With the built advanced
wireless configuration utility, it let it more easily for you to surf your wireless LAN.
Features and Benefits
System
- Standard: IEEE 802.11b/g.
- Host Interface: USB 2.0 standard.
- Data rate: 1, 2, 5.5, 11Mbps for 802.11b; 6, 9, 12, 18, 24, 36, 48, 54Mbps for 802.11g.
- Operating range: Indoor, 30-100m; outdoor, 100-400m (depends on surrounding environment).
RF
- Frequency band: 2.400 ~ 2.4835 GHz (subject to local regulation).
- Modulation: OFDM(Orthogonal Frequency Division Multiplexing) for 802.11g; DSSS(Direct Sequence Spread
Spectrum) for 802.11b.
- RF radiated output power: 14dBm for 802.11g; 17dBm for 802.11b. (±1dBm).
Software
- Driver: Microsoft Windows 98, ME, 2000, XP, and XP64.
- Operation mode: Infrastructure mode (Seamless roaming supported), Ad-Hoc mode (peer to peer connection).
- Security: 64/128 bit WEP encryption, WPA, WPA-PSK, WPA2, WPA2-PSK, and 802.1x.
LEDs and Physical connections
- Link: Always on, Green, after linked up to remote wireless.
- Activity: Blinking, Green, for data communication.
- Antenna: Embedded.
Package Contents
- USB wireless adapter.
- Manual
- Quick installation guide
- CD: includes adapter drivers, manual, and quick installation guide.
** If any of the above items are missing, please contact your reseller.
System Requirements
Before installing the adapter and related software, make sure your system meets the minimum requirements described
below.
- 2 -
IBM compatible desktop or notebook PC with available USB slot.
- CPU level: no restricted.
- Memory size: no restricted.
- CDROM drive: no restricted.
- USB Host: USB 2.0 suggested. USB 1.0/1.1 leads low data communication rate.
- Operation system: Microsoft Windows 98, ME, 2000, XP, or XP64.
- 3 -