Advanced Technology International USA P200N User Manual

USER GUIDE

P200N Printer

Copyright 2003 Advanced Technologies, Inc.

3758 West Devon Avenue, Lincolnwood, IL 60712

847 – 329 - 9875

Introduction

Thank you for purchasing the P200N portable, battery
operated, thermal serial printer.

Your printer comes with this manual, two rolls of 2.25 in.
thermal paper, a 9VDC wall adaptor, for charging the printer’s
batteries, and a serial cable designed to hook up to the
Copicode Alpha, the TC4N, and other products.

Precharging the Batteries

Your printer comes with internal Ni-Cd batteries that must be
charged for about 8 hours prior to the printer being used for the
first time. Simply plug the 9 VDC wall adaptor into the wall and
the printer power jack at the back of the printer.

In general, it is a good idea to turn off the printer when not in
use to save battery charge. The printer is designed to
automatically turn off, by default, after five minutes of inactivity.
Also, if the internal batteries are not sufficiently charged, the
printer will shut off.

Inserting Thermal Paper

It is easy to insert thermal paper in the P200N. Simply lift the
plastic paper compartment lid from the front, drop in a roll as
shown, and close the lid (you will hear a click). Notice the tear
off serrated blade for cleaning cutting the paper after printing.

Turning the Printer On and OFF

To turn on the printer, press the ON button. To turn it off, press
the OFF button.

Forwarding the Printer Paper

To forward the thermal paper, press the paper scroll button
between the ON and OFF buttons.

Self Test Function

It is easy to test the P200N for operation through a self test
procedure. With the printer OFF, first press the paper scroll
button, and while holding it, press the ON button for about a
second. The printer will print a self test, showing the three
possible font selections:

13 dots by 26 dots, 25 characters per line,
11 dots by 24 dots, 32 characters per line, and
8 dots by 20 dots, 42 characters per line.

The self test automatically shuts off after one run through the
three fonts.

Setting the Printer Parameters

The P200N has several parameters that may need to be set for
proper functioning. To access these parameters, first start with
the printer off. Now press the LEFT ARROW button, and while
holding it, press the ON button. The printer will print out its
current parameter settings, and advance to the first parameter
for possible change.

To change a parameter setting, press the BEEP button
between the LEFT and RIGHT ARROW buttons. To advance
to the next parameter, press the RIGHT ARROW button.