CP010
PCC 120/277 VAC 10:1 Ratio Passive Coupler
BEFORE YOU BEGIN...
READ ALL INSTRUCTIONS
Make sure your installation will conform to all applicable codes and requirements.
TEST FOR SIGNAL STRENGTH AND NOISE...
using the AR300 and AT300. It is necessary to test the installation in the actual operating
environment. The amount and types of line loads may reduce the strength of the transmitted signal
and/or electrical noise may cause interference with the transmitted signal. Proper installation may
require additional couplers, filters or repeaters. Special coupling devices are required to allow signal
to be distributed to all phases and zero-crossings in multi-phase and multi-transformer distributions.
IF YOU HAVE ANY QUESTIONS...
Consult your nearest Engineered System Center (ESC) for additional information.
There are no field repairable assemblies on this unit. It is covered by a two year limited warranty.
If service is needed, the unit must be returned to the ESC where purchased. Contact your ESC for
return details.
INSTALLATION
CAUTION! Make all connections with the POWER OFF to avoid injury to the installer or damage
to the device.
NOTE! The CP010 is designed to extract command signals from one electrical distribution system
ADVANCED CONTROL TECHNOLOGIES, INC.
Indianapolis, Indiana 46278
1
CP010 Installation Instructions
P/D 022597 Rev. A
CHECKOUT
and supply to another system over dedicated two-wire signal coupling conductors (SCC) and the
CA000 amplifier.
NOTE! Because the CA000 is input voltage dependent and is susceptible to being overdriven by
signal, the CP010 reduces signal strength by a factor of 10 before introducing it to the CA000.
1. Strip 3/4" of insulation from the ends of the conductors and make connections as shown in the
Wiring Diagram.
2. Check connections to be sure they are tight and no bare conductors are exposed.
3. Make sure the load or installation does not exceed the device rating.
4. Install into a standard single or multi-gang electrical wall box. Use a deep box to avoid
interference with box fittings and allow room for wiring connections.
Mount the device in the wallbox and install the cover plate.
1. Restore the power.
2. Transmit control signals from controller on one end of coupled system and test for proper
response from receivers on other end of coupled system (and vice versa).
3. Test for Signal Strength and Noise once again across coupled system using the AR300 and
AT300.
CP010 Installation Instructions
P/D 022597 Rev. A
2
ADVANCED CONTROL TECHNOLOGIES, INC.
Indianapolis, Indiana 46278
Loading...