ADVANCED ACT1100, ACT1700 Service Manual

Ω

ACT1100 ( 'V' SERIES )

A

ACT1100 / ACT1700 Standard Clock Oscillators

n

The ACT1100 is a full size through hole oscillator. The ACT1700 is a half size through hole oscillator. The
popularity of these families still remains even after the advent of smaller surface mount devices. With wide
frequency and operating temperature ranges, these series offer low cost & good reliability for ATM, Networking,
Microprocessor and Consumer applications. An option with a supply voltage of 2.5V is available please contact
our sales desk for details. For frequencies < 500KHz, >125MHz & ± 10ppm stability please refer to the
ACT1100HS/1700HS data.

Specificatio

Parameter Symbol

Frequency Range fo
Frequency Stability
Temp Operating Range Topr 0 ~ +70°, -10 ~ +70°C
Temp Storage Range Tstg -40~85°C
Supply Voltage VDD 3.3Vdc ±10% 5.0Vdc ±10%

Supply Current Iop

Duty Cycle TW/t
Output Level ‘0’ VOL TTL 0.4V max, HCMOS .33V max

Output Level ‘1’ VOH TTL 2.4V min, HCMOS 2.97V min VDD

Output Logic TTL / HCMOS
Output Load

Rise & Fall Time tr/tf

Start-up Time 4mSec max,
Option on Pin 1 Tri State or No Connection
Aging ±5ppm / year max

Δf/fo

Specification

500KHz ~ 125.0MHz
±25ppm, ±50ppm and ±100ppm

15mA max 25mA max
25mA max 35mA max
40/60%, 45/55% TTL
40/60%, 45/55% HCMOS

TTL 0.4V max, HCMOS 0.5V max

TTL 2.4V min, HCMOS 4.5V min VDD

TTL 10 Gates
CMOS 15 pF
TTL 10nSec max, 3nSec typical
Measured between 0.4V ~ 2.4V (RL = 390
CMOS 10nSec max, 3nSec typical
Measured between 10%~ 90% VDD (CL = 15pF)

; CL = 15pF)

Tel : [phone]

Fax : [phone]

email : [e-mail]

Condition

Please Specify
Please Specify
Please Specify

Please Specify

0.5 - 27MHz

27 - 125MHz

Measured at +1.4Volts

Measured at 50% VDD

VDD = 3.3V
VDD = 5.0V
VDD = 3.3V
VDD = 5.0V

Please Specify

@25°C

Plating Material on leads

SnAgCu

Soldering conditions

please refer to page 3

CT1700 ( 'CL' SERIES )

Customer to specify : Frequency, Operating Temperature Range, Frequency Stability, Supply Voltage, Duty Cycle, Output Enable (Tristate) If required

In line with our ongoing policy of product evolvement and improvement, the above specification may be subject to change without notice

Please note that all parameters can not necessarily be specified in the same device

ISO9001:2000 Registered

For quotations or further information please contact us at:

3 The Business Centre, Molly Millars Lane, Wokingham, Berkshire, RG41 2EY, UK

http://www.actcrystals.com

Issue 5 C1A
Date 23/3/6

1 of 3

ACT1100 / ACT1700 Standard Clock Oscillators

Reliability tests

Tel : [phone]

Fax : [phone]

email : [e-mail]

Test Test Method

Leak

Drop

Shock

Vibration

Resistance to

Soldering Heat

Aging

High Temperature

Storage

Low Temperature

Storage

Helium bomb: Pressure 200kpa Time 70 min
pressure release 5 min measure within 30min

750mm height.
3 drops.
Onto wood.

Peak acceleration 981m/s2 Pulse duration 6ms
Each of X, Y and Z axis.
3 shocks each axis

10 to 55Hz and return to 10Hzamplitude 1.5mm sweep time 1min.
2 hrs each of X, Y and Z axis.
Total test time 6 hrs

As per profile fig.1 below and/or soldering iron applied for 5s max tip
temperature 350±10°C

85±3°C 30 days measurements after at least 1 hr at atmospheric conditions.

105±3°C 16 hrs measurements after at least 1 hr at atmospheric conditions

-55±3°C 2hrs measurements after at least 1 hr at atmospheric conditions

Measurement

Requirements

<

4x10-9pa.m3/s

Specification as

per page 1 must be

met.

100cycles to the temperature profile fig 2 below. Measurements after at least 1

Thermal Cycling

Damp Heat

Constant

Solderability

hr at atmospheric conditions

Temperature 40±2°C RH 90~95% for 56 days. Measurements after at 1 hr at
atmospheric conditions

255±5°C for 10±0.5s using Rosin resin methyl alcohol flux Solvent (1:4) dipped
to a nominal depth of 0.5mm.

In line with our ongoing policy of product evolvement and improvement, the above specification may be subject to change without notice

ISO9001:2000 Registered

For quotations or further information please contact us at:

3 The Business Centre, Molly Millars Lane, Wokingham, Berkshire, RG41 2EY, UK

http://www.actcrystals.com

Issue 5 C1A
Date 23/3/6

2 of 3