Advance Adapters KJ09156BK1 User Manual

TOOLS NEEDED

BILL OF MATERIALS

• Metric tools

• Floor jack

• Jack stand (s) 4

• Wheel chocks

• Drill and 3/8 bit

Other Jeep JK Products

• KJ09145BK Hood Wranglers

• KJ09144BK Tailgate Bumpstops

• KJ71020 Upper dash panel

• KJ71030 Lower switch panel

• KU70034 Ft lower control arms

• KU70033 Rear upper control arms

• KU70037 Rear lower control arms

• KU70091 poly flex tool

• KU11005 Poly lube gun

BOM FOR 3/4 KIT

Part # Description Qty

M20300
M20301

BU76123
M20066
M20333

S11090

3” FT spacers 2

3” Rear spacers 2

hardware 1

Ft bump ext 2

Rear bump ext 2

Sway Bar Drop

brackets

KU01009

KU01010
P11183
S20370

Ft shocks 2

Rear shocks 2

Loctite 1

Rear track bar

bracket

KJ09153

2007 to Current Jeep JK 3” lift with shocks

2

1

Hells gate, Moab UT

www.Daystarweb.com

Tech Support Contact Info

[e-mail]

Phone: [phone]

Fax: [phone]

841 South 71

st

Avenue

Instruction Sheet P20372
2010 Daystar Products International Inc.

Thank you for choosing Daystar Products

Daystar recommends a certified technician install this system . In addition to
these instructions, professional knowledge of disassemble/reassembly proce­dures as well as post instructions checks must be known. Attempts to install this
system without this knowledge and expertise may jeopardize the integrity and/or
operating of the vehicle.

Please read all the instructions before beginning the installation. Check the kit
hardware against the parts list. Be sure you have all the needed parts and under­stand where they go. If anything is missing , do not proceed with the installa­tion, Call Daystar Products to obtain needed items.

.

Install the rear wheels and lower the vehicle to the ground.

29

30.

31.

The vehicle should have a professional wheel alignment done at
this time.
Check all bolts and nuts after 500 miles and lug nuts.

Product Use Information

As a general rule, the taller a vehicle is the easier it will roll. We strongly recom­mend , because of rollover possibility, that seat belts and shoulder harness be
worn at all times. Avoid situations where a side rollover may occur.

Braking performance and capabilities are decreased when significantly large/
heavier tires and wheels are used. Take this into consideration while driving,
Also , speedometer recalibration is necessary when larger tires are installed.

Do not add, alter, or fabricate any factory or after-market pa rt s whi ch inc rease
vehicle height over the intended height of the Daystar Product purchased. Mixing
component brands, lifts, and/or combining body lift with suspension lift voids all
warranties. Daystar makes no claims regarding lifting devices and excludes any
and all implied claims. We will not be responsible for any products that is al­tered.

Notice to Dealer and Vehicle Owner

Any vehicle equipped with any Daystar Product must have the “Warning to
driver” decal installed on the sun visor or dash. The decal is to act a constant re­minder for whoever is operating the vehicle of its uniq ue h andl i n g characteristics.
INSTALLING DEALER— Its is your responsibility to install the warning decal
and forward these instructions on too the vehicle owner for review and to be kept
in the vehicle for service life.

After installation occurs, a qualified alignment facility is required to align the
vehicle to factory specs.