Advance Adapters 920013 User Manual

ADVANCE ADAPTERS INC. P/N: 920013

P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447 PAGE 1 OF 2
Telephone: [phone] Fax: [phone] Page Rev. Date: 11-26-12

SA TURN OVERDRIVE SHIFT LINKAGE

T14 SATURN SHIFT KIT

KIT CONSISTS OF:

No. Qty. Part No. Description

1. 1 715651 CLIP

2. 1 716140 BRAKE YOKE 3/8" WITH PIN

3. 5 722546 SHIFTER BOOT SCREWS

4. 2 723105 H.H.C.S. 5/16"-18 x 1" LG

5. 1 920016 SHIFTER KNOB (SATURN)

6. 1 920017 WASHER

7. 1 920018 SHIFTER SNAP RING

8. 1 920019 SHIFTER HANDLE

9. 1 920021 SHIFTER BOOT DUAL HANDLE

10. 1 920022 SHIFTER BOOT RING DUAL HANDLE

11. 1 920032 T90 SINGLE LEVER SHIFT ROD

12. 1 920033 T14 SHIFT BRACKET

13. 1 920039 1/4"-20 x 1 H.H.C.S.

14. 1 920040 1/4"-28 JAM NUT

15. 1 920041 HEIM JOINT 1/4"-28

16. 1 722514 1/4"-20 LOCKNUT

17. 1 303081 IGUS BUSHING (PRESSED INTO THE HANDLE)

The shifter bracket fits directly over the top cover plate of the 3 speed transmission and the pivot extends outward
towards the passenger side of the vehicle. To access the assembly of the T14 transmission , the sheet metal tunnel
cover will need to be removed. When mounting the shifter bracket, you will need to use the steel spacer washers
between the top cover and the shifter bracket. New bolts have been supplied for the bracket assembly to the
transmission. The linkage rod must be installed into the slotted shift rail on the back side of the overdrive. The
rod must be slipped over the transfer case and certain installations may require modifications to the shifter rod.
With the extension rod in position and the shifter bracket in position, you can now install the handle assembly. The
handle will slip over the shifter bracket pin as illustrated. The clevis assembly (or brake yoke), will then slip onto
the shifter handle. At this point, the adjustment between the shifter handle and the linkage rod can be determined.
The handle should be positioned in a vertical position and the shifter rod in the overdrive should be positioned into
the neutral location.

SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.

ADVANCE ADAPTERS INC. P/N: 920013

P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447 PAGE 2 OF 2
Telephone: [phone] Fax: [phone] Page Rev. Date: 09-20-12

SA TURN OVERDRIVE SHIFT LINKAGE

T14 SATURN SHIFT KIT