Advance Adapters 7130970 User Manual

ADVANCE ADAPTERS INC. P/N: 713097

P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447 PAGE 1 OF 1
Telephone: [phone] Fax: [phone] Page Rev . Date: 08-10-10

HEMI V8 UNIVERSAL ENGINE MOUNTS

KIT CONSISTS OF:

No. Qty Part No. Description

1. 1 713008-NS MOUNTING HARDWARE KIT

2. 2 713088-BLK LONG SIDE BLOCK MOUNT

3. 2 713045 FRAME BRACKETS

4. 8 720038 10MM LOCKWASHER

5. 8 720073 10MM - 1.5 x 25MM LONG HHCS

6. 8 720015 10MM FLAT WASHER

These universal engine mounts are designed for use on all types of 4WD and 2WD vehicles that have frame rail
widths up to 30". The frame brackets can be used in either the upward or downward position for the best engine
location. The bracket can be either welded or bolted into position. If you are dealing with a vehicle that has
an open channel, then you should box-in the frame rail prior to mounting the new bracket. If your frame rail is
wider than 30 inches, we offer a different frame bracket that provides an additional 2 inches of width under Part

No. 713037.

Several holes have been stamped in each motor bracket to allow the engine to be offset or centered in the frame
rail. On Jeep CJ’s conversions, it is best to offset the engine 1" towards the driver's side.

The height and lateral location of the motor is determined by the placement of the frame brackets. When trial
fitting the motor into the chassis assembly, the motor brackets insulator donuts and frame brackets should be
assembled. Make sure that the dual donut rubber mount assembly is properly assembled for maximum engine
insulation. The final position should take into consideration the following items:

1. Firewall clearance.

2. Oil pan & harmonic balancer clearance.

3. Hood clearance.

4. Radiator & fan allowance.

5. Steering box and/or linkage clearance.

6. Header/exhaust manifold clearance.

7. Distributor accessibility.

8. Starter motor clearance on front driveline.

THE 5/8"-18 NYLON NUT SHOULD BE

TORQUED TO 25 TO 30 FT./LBS.

SPECIAL NOTE:

Modifications to the engine mount arm brackets may be
necessary on certain installations. The mounts may need to
be shortened in order to fit between frame rails. The hole
location for the rubber mount position may require a new
hole or slotting between two of the holes. These mounts are
used on over 50 various applications and modifications as
to length and hole positions are common.

SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly
recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We
recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally
available at automotive dealerships and parts stores.