Adtran NetVanta 5305 Controller Quick Start Guide

For more detailed documentation, visit us online at www.adtran.com

Quick Start Guide

NETVANTA 5305 CONTROLLER P/N 1200831L1

SPECIFICATIONS

Interfaces: Console: EIA-232 (DB-9 female) for access to command line

interface and monitoring

Ethernet: Two 10/100BaseT interfaces (RJ-48C) for connection to the local area network

Compliance: FCC Part 15, Class A, UL 60950/CSA-C22.2 No. 60950,

EN 60950, IEC 60950, AS/NZS 60950, EN 55022, EN 55024

Environmental: Operating Temperature: 0°C to 50°C

Storage Temperature: 20°C to 70°C Relative Humidity: 95% non-condensing

INSTALLATION INSTRUCTIONS

1. Remove the existing controller from the controller slot in the NetVanta 5305 Base Unit.

2. Slide the System Controller into the controller slot until the module is firmly positioned in the chassis.

ETHERNET PINOUT

Pin Name Description

1 TX1 Transmit Positive

2 TX2 Transmit Negative

3 RX1 Receive Positive

4, 5 — Unused

6 RX2 Receive Negative

7, 8 — Unused

CONSOLE PINOUT

Pin Name Description

1 DCD Data Carrier Detect (output)

2 RD Receive Data (output)

3 TD Transmit Data (input)

3. Secure the screws at both edges of the module. Tighten with a screwdriver.

4. Connect the cables to the associated device(s).

5. Complete the system installation as specified in the Hardware Installation Guide (P/N 61200990L1-34).

4 DTR Data Terminal Ready (input)

5 SG Signal Ground

6 DSR Data Set Ready (output)

7 RTS Request to Send (input)

8 CTS Clear to Send (output)

9 RI Ring Indicate (output)

NETVANTA 5305 CONTROLLER P/N 1200831L1

Quick Start Guide

CONNECT THE CONSOLE INTERFACE

Before connecting to the NetVanta 5305 CONSOLE interface you will need the following items: VT100 terminal or PC (with VT100 terminal emulation software) and a straight through serial cable with a DB-9 (male) connector on one end and the appropriate interface for your terminal (or PC) on the other.

1. Connect the DB-9 (male) connector of your serial cable to the CONSOLE port on the rear panel of the unit.

2. Connect the loose end of the serial cable to the VT100 terminal or PC (with terminal emulation software).

3. Open a VT100 terminal session to the NetVanta 5305 using the following settings: 9600 baud, 8 data bits, no parity bits, and 1 stop bit. Press <Enter> to activate the ADTRAN Command Line Interface (CLI).

For more detailed documentation, visit us online at www.adtran.com

Commands

Refer to the ADTRAN Operating System (OS) Command Reference Guide (provided on the system documentation CD) for details on configuring the system using the CLI.