Adtran NetVanta 5305 Quick Start Guide

For more detailed documentation, visit us online at www.adtran.com

Quick Start Guide

NETVANTA 5305 (SYSTEM) P/N 4200990L1

CONNECT THE CONSOLE NETVANTA 5305

Before connecting to the NetVanta 5305 CONSOLE interface you will need the following items: VT100 terminal or PC (with VT100 terminal emulation software) and a straight through serial cable with a DB-9 (male) connector on one end and the appropriate interface for your terminal (or PC) on the other.

1. Connect the DB-9 (male) connector of your serial cable to the CONSOLE port on the rear panel of the unit.

2. Connect the loose end of the serial cable to the VT100 terminal or PC (with terminal emulation software).

3. Open a VT100 terminal session to the NetVanta 5305 using the following settings: 9600 baud, 8 data bits, no parity bits, and 1 stop bit. Press <Enter> to activate the ADTRAN Command Line Interface.

4. Enter enable at the > prompt.

5. Enter the password when prompted. The default password is password.

LED DESCRIPTIONS

For these LEDs… This activity… Indicates that…

Status Green (blinking) Power up process

Green (solid) Power on passed self test Red (solid) Self test failed or boot mode code could

not be loaded

Power 1/2 Green Power supply is okay

Red Power supply failure Off No power supply present

DBU Off No dial backup Modules installed

Green (solid) Dial backup module is ready for use Green (blinking) The unit is in dial backup Red (solid) Dial backup alarm condition Yellow (solid) Unit is in test

TD/RD Green (blinking) Activity on the ethernet port

Off No activity on the ethernet port

LNK Green (solid) 10BaseT link is up

Yellow (solid) 100BaseT link is up Red Link is down Off Administratively down

Status (slots 1-6)

Activity (slots 1-6)

Tes t (slots 1-6)

Off

Green (solid) Link is up Red (solid) Alarm condition is present on the module Green (blinking) Data present on the module (i.e. for the

Off No activity on the module Off No test running

Yellow (solid) Module in test

Empty slot or the interface is administratively down

T3 module, this indicated TD/RD data)

Quick Start Guide

For more detailed documentation, visit us online at www.adtran.com

NETVANTA 5305 (SYSTEM) P/N 4200990L1

CAUTION:

REMOVE POWER CORD PRIOR

TO REMOVAL OF POWER SUPPLY

85-130VAC/190-250VAC

4A/2A 50/60Hz

ETHERNET PINOUT

Pin Name Description

1 TX1 Transmit Positive

2 TX2 Transmit Negative

3 RX1 Receive Positive

4, 5 — Unused

6 RX2 Receive Negative

7, 8 — Unused

CONSOLE PINOUT (CONTINUED)

Pin Name Description

4 DTR Data Terminal Ready (input)

5 SG Signal Ground

6 DSR Data Set Ready (output)

7 RTS Request to Send (input)

8 CTS Clear to Send (output)

9 RI Ring Indicate (output)

CONSOLE PINOUT

Commands

Pin Name Description

1 DCD Data Carrier Detect (output)

2 RD Receive Data (output)

3 TD Transmit Data (input)

Refer to the ADTRAN Operating System (OS) Command Reference Guide (provided on the ADTRAN OS Documentation CD) for details on configuring the system using the Command Line Interface.