ADS Environmental Services Hykron User Manual
on
Q U I C K R E F E R E N C E G U I D E
Operation of the ADS Hykron
The ADS Hykron is a simple-to-use leak
listening system with high acoustic
sensitivity. It is the ideal tool for a water
crew’s standard tool chest. Leak noise
travels through the water and the pipe
r
wall. It can be detected by listening at
valves, hydrants, or any available tting
on the pipe. The Hykron detects the
leak noise through its high sensitivity
sensor. Listening is conducted via the
headphones with an extension rod and
magnetic attachment.
Connectors
Plug the handheld sensor into the lower right socket of the amplier. The left-side socket is used to
connect the headphones.
Control Buttons
ADS Hykron Leak Listening System
Button Function
Press-to-listen
When pressed, this button amplies sounds from the sensor to the
headphones. When the button is released the amplier is turned o.
Volume
This rotary control is turned to increase or decrease the volume of
sound from the sensor.
Operation
1. Plug the sensor into the amplier.
2. Plug the headphones into the amplier.
3. Attach the extension rods or the magnet to the sensor unit. Position the rod onto the pipe or ground.
4. Press and hold the press-to-listen button.
5. Listen to the sound in the headphones.
6. Release the press-to-listen button.
7. Move the sensor to the next listening location and repeat the listening process.
After use, remove the rods and magnet from the sensor and disconnect the sensor from the amplier. Disconnect the headphones.
Clean the equipment as required and return all the components to the carrying case.
Battery
The amplier is powered by a non-rechargeable alkaline 9V cell. This can be easily replaced by removing the cover at the top of the
back of the amplier. A new battery will give approximately 60 hours continuous use.
LLC
An IDEX Water & Wastewater Business.
4940 Research Drive - Huntsville, AL 35805 - 800.633.7246 www.adsenv.com
© 2011 ADS LLC. All Rights Reserved.
QR 775026 A0
Loading...