ADS FDi Owner's Manual

FDi
analog and digital systems
2001 analog and digital systems, inc.
300 wildwood avenue, woburn, massachusetts 01801
781.729.1140 www.adst.com
Factory Direct Interface
owner's manual
connections
power After securely connecting a constant 12v source, remote turn-on wire from the head unit and ground wire to the 3-pin power connector, plug it into the FDi with the screws facing up.
not
used
OEM radio speaker/balanced input Securely connect the speaker leads from your factory head unit to the 9-pin connector and plug it into the FDi with the screws facing up. The level control to the right of this connector will adjust the level of all four channels of the speaker inputs.
OEM radio rca input If your factory head unit is equipped with rca outputs for both front and rear channels, run rca cables from the head unit to the OEM radio rca inputs. In this case do NOT use the OEM radio speaker input. The level control to the right of the four rca jacks will adjust the level of the four rca inputs.
aux source inputs Connect the left and right rca cables from the source unit you are adding to the system here. The FDi allows you to add two sources to your system i.e. a cd changer and an MP3 player. The level control to the left of source A and source B inputs adjusts the level of both aux source inputs.
output Connect rca cables to your system amplifier from these outputs.
source select After installing the source A/B selector switch in the front of the car plug in the cable here. The FDi will only pass signals from the OEM head unit if the switch is not properly connected.
antenna input and output Remove the factory antenna plug from the head unit and insert it into the antenna input on the FDi. Now insert the antenna plug from the FDi antenna output into the OEM head unit. The plugs on the FDi are standard Motorola format. Adapters and/or extension antenna cables may be required to complete this connection.
notes
fm frequency The fm frequency switch gives you three choices for the control frequency the FDi will use to conĀ­trol the aux sources. The FDI will control the aux sources only when the OEM head unit Tuner is set to the selected frequency.
probe The probe rca jacks are used only for testing. Do not connect any cables here.
6
Loading...
+ 2 hidden pages