Admiral Staging ZEM2SV36 User Manual [EN]

ASSEMBLY KIT

STRONG GIRL

ZEM2SV36

SCOPE

The intended use of ADMIRAL Stong Girl is to transport 30 or
40 circular truss sections with a square cross section. The
diameter may vary from 2,5 m up to 20 m, where the length
of the truss sections does not exceed 3 m.

CONTENT

34

2

1

Length profile: ZEWASGL15
(length profile strong girl)

2

Width profile: 30 truss: ZEWASGW3
40 truss: ZEWASGW4

1

3

Truss carrier: 30 truss: WASGC30
40 truss: WASGC40

4

Admiral Staging Essentials the Netherlands

www.admiralstaging.com [phone]

Castor: 125 with break: ZEWACW24

5

Bolt set: ZEM2SV36

ASSEMBLY

STEP 1 BUILDING THE FRAME STEP 2 PLACE THE TRUSS CARRIER

First, determen the location of the carrier using the table.

INSIDE

M8 x 16

(16x)

1

234

4X

Ø of truss circle is:

1 2.5m up to 5m
2 5m up to 7.5m
3 7.5m up to 10m
4 > 10m

LOADING AND SAFETY

OPTION 1

Use ADMIRAL truss carriers to load the truss.

OPTION 2

If the diameter of your truss is to small for a regular
truss carrier, use a Strong Girl truss carrier (WASGC30
for 30 truss or WASGC40 for 40 truss) with 4 half
conical couplers added.

ALWAYS SECURE THE LOAD

Use ADMIRAL truss carriers to load the truss.

Outside the frame Inside the frame

WARNING

Don’t load higher than 2 meters to prevent instability.
Always keep the dolly on a flat surface

OPTIONAL

STORAGE PLATE

A bottom plate can be assembled for transporting
carriers and straps onto the Strong Girl. Holes for screws
are already available on the frame. Make cuttings into
the plank in order to keep the inside slots for your cable
straps open.

max 2 m

SIDE PANELS

Side panels can be mounted onto
the frame, by using the Admiral Freedom
profiles. We advise you to brace the wooden

board sufficient and cut lifting recessions.

MAINTENANCE

The Strong Girl hardly needs any maintenance under normal use and environmental circumstances.
For safety reasons however, all parts must be checked regularly for dirt, damages, loss and corrosion.

• Check all components for damage and corrosion. Damaged and corroded parts shall be rejected and thrown away.

• Remove all sharp edges and burrs with a piece of sanding paper.

Replaced component shall be genuine ADMIRAL only. Check Content 4 for replacement parts.