Admiral Craft WP-2 Owner's Manual

WP-2

Warmer Plate

This manual contains important information regarding your

Admiral Craft unit. Please read this manual thoroughly prior to
equipment set-up, operation and maintenance. Failure to comply
with regular maintenance guidelines outlined in this manual may

void the warranty. MUST READ!!!

WARNINGS

1. Do not touch any hot surfaces

2. Do not heat cold liquids. The unit is designed to keep warm liquids hot.

3. Do not immerse unit, cord or plug in liquid at any time

4. Unplug cord from outlet when not in use and before cleaning

5. Plug only into a 3-hole grounded electrical outlet

6. Do not operate unattended

7. Do not use this unit for anything other than intended use

8. Do not use outdoors

9. Keep children and animals away from unit

10. Always cook on a firm, dry and level surface at least 12” from walls or any other obstruction

11. Do not use unit with a damaged cord or plug, in the event the appliance malfunctions, or has been damaged in any

manner

12. Any incorrect installation, alterations, adjustments and/or improper maintenance can lead to property loss and injury.

All repairs should be done by authorized professionals only

13. Ensure that the power supply you are using is adequate for continual usage and the voltage is correct.

14. Unplug the unit when not in use

TO USE

1. First, remove unit from packaging.

2. Make sure the unit is placed on a firm flat surface before use.

3. Place liquid filled container(s) on the burner(s)

4. Plug the power cord into the appropriately rated outlet

5. Turn the switch to the plate(s) in use “On”. Turn “Off” when not in use.

CLEANING - NOTE: To maintain cleanliness and increase service life, the plate warmer should be cleaned daily. Do not
immerse the unit in water or any other liquid, if liquid enters the electrical compartment it may cause a short circuit or
electrical shock)

1. Before cleaning or attempting to move warmer, unplug and let the unit cool completely.

2. Wipe the entire unit with a clean soft cloth until it is completely dry.

3. To avoid damage, do not use abrasive cleaners or scouring pads.

4. If soap or chemical cleaners are used, be sure they are completely rinsed away with clear water immediately

after cleaning. Chemical residue could damage or corrode the surfaces of the unit.