Admiral Craft RW-E50 Owner's Manual

RW-E50

Rice Warmer

This ma nual c ont a ins important information re gardi ng your

Admiral Craft unit . Please read this manual thoroughly prior to
equipment set-up, operati on and maintenance. Failure to comply
with regular maintenance guidelines outlined in this manual may

void the warranty. MUST READ!!!

WARNINGS

• Do not touch any hot surfa ces

• Do not immerse unit, cord or plug in liquid at any time

• Do not plug or unplug unit with wet hands

• Unit is intended to keep cooked rice warm. Unit will not properly warm cold rice and is not intended to reheat rice

• Unplug cord from outlet when not in use and before cleaning

• Do not move unit when in u s e

• Plug only into a 3-hole grounded electrical outlet

• Do not operate unattended

• Do not use thi s unit for anything other than intended us e

• Do not use outdoors

• Keep children and animals away from unit

• Always use on a firm, dry and level surface at least 12” from walls or any other obstruction

• Do not use if unit has a d amaged cord or plug, in the event the appliance malfunctions, or has been damaged in any

manner

• Any incorrect installation, alterations, adjustments and/or improper maintenance can lead to property loss and injury.

All repairs should be done by authorized professionals only

• Ensure that the designated power supply is adequate for continual usage and the voltage is correct

TO USE

1. Before initial use, wash and dry inner p ot and lid.

2. Plug in and preheat for 30 minutes.

3. Place cooked hot rice in the inner pot and cover.

4. Use cautio n when handling, as surfac e will be hot.

5. It is not recommended to keep rice in the warmer for more than 12 hours.

CLEANING – NOTE: To maintain cleanliness and increase service life, the rice warmer should be cleaned daily. Do not
immerse the unit in water or any other liquid. If liquid enters the electrical compartment it may cause a short circuit or
electrical shock.

1. Before c le a nin g or attempting to move, allow warmer to cool down completely then unplug from outlet.

2. Wipe unit with a damp cloth then wipe dry.

3. To avoid damage, do not use abrasive cleaners or scouring pads.

4. If soap or chemical cleaners are used, be sure they are completely rinsed away with clear water immediately

after cleaning. Chemical residue could damage or corrode the surfaces of the unit.