Admiral Craft IDW-940 Owner's Manual

IDW-940W
Infrared Display Warmer
This manual contains important information regarding
your Adcraft unit. Please read the manual thoroughly
prior to equipment set-up, operation and maintenance.
Failure to compl y with regular maint enance guidelines
outlined in this manual may void the warranty.
PLEASE READ!!!
Infrared Display
Warmer
WARNINGS
Do not touch any hot surfaces
Plug only i nt o a 3-hole grounded electrical outlet
Do not immerse unit, cord or plug in liquid at any time
Unplug cord from outlet when not in use and before cleaning
Do not operate unattended
Do not use thi s unit for anything other than intended use
Do not use outdoors
Always use on a firm, dry and level surface
Do not use if unit has a damaged cord or plug, in the event the appliance malfunctions, or has been damaged in any manner
Keep children and animals away from unit
Any incorrect installation, alterations, adjustments and/or impr oper maintenance can lead to property loss and injury. All
repairs should be done by authorized professionals only
Ensure that the designated power supply is adequate for continual usage and the voltage is correct
TO USE
1. Place unit on a firm and level surface.
2. Plug the unit into a grounded 3-prong 120V outlet.
3. Place food into the food pan located in the base of the unit. A perforated liner is included to allow for proper drainage of
oil from food.
4. Set “HEATING” switch to on p osition. This will turn the heating elements on and sta r t to warm up the food in the food
pan located in the base of the unit. Please note the maximum temperature that the hot zone area should reach is 122°F (50°C).
5. Set “LIGHT” switch to on position to turn on display lamp.
CLEANING – NOTE: To maintain cleanliness and increase service life, the oven should be cleaned daily. Do not immerse the unit in water or any other liquid. If liquid e nter s the electrical compartment it may cause a s hort circuit or electrical shock
Disconnect the power cord from the electrical outlet
Allow unit to cool down
Remove food pan daily to clean. Separate perforated liner and food pan for best results
Clean unit with a damp cloth using a mild detergent
Do not clean with a water jet stream
To avoid damage, do not use abrasive cleaners or scouring pads
If soap or chemical cleaners are used, be sure they are completely rinsed away with clear water immediately after cleaning.
Chemical residue could damage or corrode the surfaces of the unit.
SPECIFICATIONS
Item Number Description Voltage Wattage Amps Net Weight Dimensions
IDW-940W
120V 940W 7.8 15.5 lbs 13”x22.25”x19.75”
Thank you for your purcha s e
Admiral Craft Equipment Corp.
940 South Oyster Bay Rd.
Hicksville, NY 11801
P: 1-800-223-7750 F: 1-800-447-7751
www.admiralcraft.com
Loading...
+ 4 hidden pages