Admiral Craft GRID-16, GRID-24, GRID-30 Owner's Manual

GRID-16, GRID-24, GRID-30

Countertop Griddles

This manual contains impor t a nt i nfor m a t ion regarding your

Admiral Craft unit. Please read this manual thoroughly prior to
equipment set-up, opera ti on a nd m aint e na nc e . Fa ilure to comply
with regular maintenance guidelines outlined in this manual may

void the warranty. MUST READ!!!

WARNINGS

• Do not touch any hot surfa ces

• Do not immerse unit, cord or plug in liquid at any time

• Unplug cord from outlet when not in use and before cleaning

• Plug only i nt o a 3-hole grounded electrical outlet

• Do not operate unattended

• Do not use thi s unit for anything other than intend ed use

• Do not use outdoors

• Always use on a firm, dry and level surface at least 12” from walls or any other obstruction

• Do not use i f unit has a da maged cor d or p lug, in the e vent the applia nce mal functio ns, or ha s been da maged in an y

manner

• Keep children and animals away from unit

• Any incorrect installation, a lteratio ns, adjust ments and/or improper maintenance can lead to property loss and injury.

All repairs should be done by authorized professionals only

• Ensure that the designated power supply is adequate for continual usage and the voltage is correct

In order to protect the plates of your new grill during transportatio n, a layer of food-safe oil was coated on the surface prior to
shipment. This oil is harmless, but must be removed before you begin to use. To remove, preheat the grill until the oil
liquefies. Next, carefully wipe away the melted oil with a clean, soft clot h. Once a ll of the oil is removed you can begin to use
your grill

TO USE

1. Un-box unit and remove protective packaging

2. The cooking area is coated with an oil based protectant to prevent rusting during shipment. This protectant will need

to be cleaned off before use with a food safe degreaser.

3. Plug the power cord into the appropriately rated outlet

4. The green power light will illumi nate

5. Turn the temperature controller clockwise to the desired temperature

6. When the surface reaches the designated temperature, the indicator light will shut off and cycle to maintain the

temperature.

7. For best results allow unit to preheat for 15 minutes before placing food on the surface.

CLEANING - NOTE: To maintain cleanliness and increase service life, the griddles should be cleaned daily. Do not immerse
the griddle in water or a ny other liquid, if liquid enters the electrical compartment it may cause a short circuit or electrical
shock

1. Before cleaning or attempting to move griddle, unplug and let the unit cool completely

2. Wipe the entire unit with a clean soft cloth until it is completely dry

3. To avoid damage, do not use abrasive cleaners or scouring pads

4. If soap or chemical cleaners are used, be sure they are completely rinsed away with clear water immediately

after cleaning. Chemical residue could damage or corrode the surfaces of the unit.