Admiral Craft CP-100, CP-40, CP-60 Owner's Manual

CP-40, CP-60, CP-100

Coffee Percolators

This manual contains important information regarding your

Admiral Craft unit. Please read this manual thoroughly prior

to equipment set-up, operation and maintenance. Failure to

comply with regular maintenance guidelines outlined in this

manual may void the warranty. MUST READ!!!

WARNINGS

 Do not touch any hot surfaces
 Do not immerse unit, cord or plug in liquid at any time
 Unplug cord from outlet when not in use and before cleaning
 Plug only into a 3-hole grounded electrical outlet
 Do not operate unattended
 Do not use this unit for anything other than intended use
 Do not use outdoors
 Always use on a firm, dry and level surface at least 12” from walls or any other obstruction
 Do not use if unit has a damaged cord or plug, in the event the appliance malfunctions, or has been damaged in

any manner

 Keep children and animals away from unit
 Any incorrect installation, alterations, adjustments and/or improper maintenance can lead to property loss and

injury. All repairs should be done by authorized professionals only

 Ensure that the designated power supply is adequate for continual usage and the voltage is correct

Scalding may occur if the lid is removed during the brewing cycle.



TO USE

1. Clean the filter basket, cover, percolator tube and the inside of the tank with a non- abrasive

detergent.

2. Pour cool water into the urn to fill at least half of the total capacity of the urn.

3. Cover the filter basket with the basket cover.

4. Center the percolator tube into the basket and tray. Make sure that the base of the tube is positioned

securely in the well of the urn.

5. Center the filter basket into the percolator tube and place ground coffee in the basket. Put the

basket cover back on and put the cover on the urn.

6. Plug the cord into your electrical outlet and turn the power switch on. The switch will light up.

7. When the indicator lamp lights up the brewing process is complete.

8. The second heating system will start to operate automatically to keep the coffee warm.

9. When there are only about 3 cups of coffee left in the urn, turn the power switch off and unplug the

cord from the outlet.

10. To reheat cold coffee in the urn, there must be at least 12 cups of coffee in the tank to reheat. Simply

*On areas of the heating element, hard water will cause chalk and limestone to accumulate over time. It is
recommended that you clean the percolator and remove the residue.

re-plug the cord back into the electrical outlet and turn the power switch on.

SEDIMENT REMOVAL

1. Pour 100 ml. of fresh lemon juice into the urn body

2. Wait 5-6 minutes to allow the lemon juice to run through the sediments

3. You can use a soft bristle brush to clean the heating element

4. Repeat steps 1-3 until limestone is removed

5. Use a dry cloth to wipe the residual liquid

6. Pour clean water into the urn until and rinse until lemon smell is gone

Parts – please check prior to installation

Problem

Cause

Solution

Not working as well as
expected

Unit is not on a dedicated circuit

Unplug unit, plug into a dedicated line and
retry

Leaking from the area where
the spigot attaches to the
urn

Nut/bolt is loose

Inside the urn, there is a nut/bolt that may
loosen over time. Tighten the nut/bolt and
leaking will stop.

Leaking from the area where
the spigot attaches to the
graduation

The fitting under the graduation
water indicator has become loose

Tighten the small black fitting underneath
the water indicator and the leaking will
stop.

Leaking from the area where
the spigot lever and spout
meet

The area is loose

Twist the lever to tighten and the leaking
will stop.

1. Cover

2. Urn

3. Level Indicator

4. Faucet

5. Power Switch

6. Indicator Lamp

7. Urn Base

8. Basket Cover

9. Filter Basket

10. Basket Tray – not included on CP-40

11. Percolator Tube

12. Cord

13. Bottom of Urn

14. Heating Element

TROUBLESHOOTING - Troubles listed are for reference. If any fault occurs, please discontinue use. Do not attempt
to repair yourself. This will void the warranty.

UNDER NO CIRCUMSTANCES SHOULD THIS UNIT BE OPERATED DRY.
IT IS ALSO NOT INTENDED TO SIMPLY BOIL WATER.